© Leitner 2020
-make sure that the ground which the wheelchair is used on is even and free of obstacles. Uneven surfaces may cause the wheelchair to flip
and cause injury. Uneven surfaces also may prevent the wheelchair from operating and turning efficiently. Do not use the wheelchair on loose
surfaces, e.g. on gravel, small carpets, sand
-ride the wheelchair carefully as it may flip. The maximum incline the wheelchair may be used on is 12 degrees. When starting to use the
wheelchair do so under supervision of a qualified person. When first travelling a new route make sure that there is a person accompanying the
occupant to help in case of unforeseen issues with the terrain. Only use wheelchair without supervision after sufficient training.
-when navigating in limited space, for example close to walls, keep hands and arms within the wheelchair armrest so that the arms won’t get
caught between the wheelchair and objects. Also, in such situations, keep feet inside footrest. Only put feet on footrest after occupying the
chair. Do not step on the footrest if you are not sitting in the wheelchair or the wheelchair may flip.
-do not release the brakes on inclines or declines! The wheelchair may roll down uncontrollably and serious injury or death may occur!
-the wheelchair is best suited for indoor use. When using outdoors only use it in dry, clean conditions on even, safe surfaces without obstacles
-don’t use wheelchair on stairs, escalators or conveyor belts – use suitable elevator if necessary
-always switch wheelchair OFF when stationary to avoid accidental activation of wheelchair
-the warnings and instructions in the manual have been issued to the best of our knowledge and with the intent to make the wheelchair safe
to use. If there are any mistakes or parts in the manual which do not seem to make sense, please contact us immediately and we are happy to
work with you to clarify the issues. We do not assume liability for any incorrect information provided in this manual.
-perform a safety check before each ride. All parts need to be installed safely and all nuts and bolts need to be tight. If in doubt have the
safety check done by a local mobility shop. The following parts needs special attention during the safety check:
folding safety clamp at back of the wheelchair needs to be locked so that the wheelchair won’t fold while being used
brakes need to be ON before operating the wheelchair by joystick.
brakes needs to brake effectively, all nuts and bolts need to sit tight. If the joystick is not engaged and the brakes are on, the wheelchair should
not move.
front wheels need to spin freely when lifted off the ground and turned by hand. The axle of the front wheels need be able to spin 360 degrees.
Joystick needs to bring wheelchair to a stop when released. Before occupying the wheelchair, carefully check if the joystick controls work as
intended. The control panel needs to be stable and shouldn’t move. Tighten up the control panel screw manually if needed to make sure it sits
tight.
Armrests need to be locked with the safety clip on the outside of each armrest
Cables must not touch the wheels when using the wheelchair
batteries need to be charged and installed safely
Back-rest and seat cushion need to be attached safely to the wheelchair. Foot-rest and small bag under wheelchair need to be installed
correctly.
Contact 1300 856 725 or sales@leitner.com.au for any questions
Safety warnings
