Larson Electronics TPM-2XLEDEQ-4X3-CPR User manual

TPM-2XLEDEQ-4X3-CPR

120W LED Pole Light

(2) LED Lamps - 3' to 8.5' Adjustable - 9-64V DC

Instruction Manual

IMPORTANT

READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE. THE TPM-2XLEDEQ-4X3-CPR MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL

CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.

WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS

PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,

CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.

WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE

INSTALLATION OR PERFORMING ANY MAINTENANCE.

RISK OF FIRE/ELECTRIC SHOCK –DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.

RISK OF PERSONAL INJURY –FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.

RISK OF BURN –ALLOW FIXTURE TO COOL BEFORE SERVICING.

The Larson Electronics TPM-2XLEDEQ-4X3-CPR LED Pole Light is a pole lighting solution with outdoor and rugged

applications. This 120-watt unit consists of two high output LED fixtures, which are capable of emitting 8,400 lumens of

white light. The telescoping pole is adjustable at heights between 3 and 8.5 feet. Operators can manage power

connections seamlessly using a 20` wiring harness with a weatherproof quick disconnect.

MOUNTING AND SETUP

The adjustable telescoping pole is designed to be mounted to any vertical surface via an

included mounting plate with four pre-drilled mounting holes. Users can simply attach the

mounting plate to a wall, trailer, the exterior of boat cockpits etc, then slip the pole into the

bracket and lock it into place using the T-handle screw. Once positioned, the aluminum pole can

be collapsed to 3 feet and extended to 8.5 feet by unlatching the locking brackets, extend the

pole to the desired length, and lock the brackets to hold in position. The top of the pole is fitted

with an aluminum mounting plate holding the two LED lamps. Each lamp can be rotated or tilted

to the desired position. Use the screws on the sides of the lamps for vertical adjustments, and

the bolt through the bottom bracket for horizontal adjustments.

WIRING

The TPM-2XLEDEQ-4X3-CPR comes with a 20` 16/2 wiring harness, which features a

weatherproof quick disconnect between the light and harness. Attach the harness to the lights

via the Deutsch connectors as shown.

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 1of 2

•Cordis attached via a weatherproof 2-pinDeutsch connector.

•The cord is detachable by depressing the tab on the top of the connectors. This

enables the operator to remove and store the light while leaving the cordconnected to the

power source.

•Additionalor replacement cords canbe ordered from our website. Contact us or visit

LarsonElectronics.com for more information.

QUICK DISCONNECT

DEUTSCH CONNECTOR

Once the harness is connected, complete the connections as appropriate for the cord

option chosen when ordering.

FLYING LEADS

We strongly encourage a licensed electrician install this product, in all locations,

especially in outdoor areas where weatherproofing may be required.

Warning: Check product label for correct input voltage!

Attach supply line wires to the appropriate light fixture wires as shown in the

diagram 

TPM-2XLEDEQ-4X3-CPR

BATTERY CLAMPS OR RING TERMINALS

Complete connection to battery outputting voltage within the fixture's rating, following all local and national electric

codes, and taking precautionary steps for weatherproofing all connections if installed in a location where water may

come in contact with the unit. All outdoor installations and indoor installations near a wet location require the use of a

GFCI device for safety, according to the National Electrical Code® (NEC). Ensure the unit is properly grounded.

CIGARETTE PLUG

Mate cord cap with compatible receptacle outputting voltage within the fixture's rating.

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 2of 2

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SAL[email protected] OR BY PHONE AT 1-877-348-9680 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

MAINTENANCE

There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the

fixture for proper function.

•Disconnect power running to the lamp and be sure the fixture is cool to the touch.

•Use a non-abrasive glass cleaning solution to clean the lens.

Note: It is not necessary to open the fixture and clean or touch the LED’s.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of

children when not in use.Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

The TPM-2XLEDEQ-4X3-CPR is designed to provide years of reliable performance. Should the need for replacement

parts arise, please contact Larson Electronics.

Table of contents

Other Larson Electronics Lighting Equipment manuals

Larson Electronics

Larson Electronics RL-15-LED-CPR User manual

Larson Electronics

Larson Electronics HAL-LI-48-2X50LED User manual

Larson Electronics

Larson Electronics IIND-DBL-36-1L-R1-120V User manual

Larson Electronics

Larson Electronics SLEDB-110V-MS User manual

Larson Electronics

Larson Electronics GL-2051-M User manual

Larson Electronics

Larson Electronics EPL-FL1524-LED Series User manual

Larson Electronics

Larson Electronics EPL-HB-150LED-RT User manual

Larson Electronics

Larson Electronics EPL-HB-50LED-RT User manual

Larson Electronics

Larson Electronics FRL-EMX-18-90W-FUVC-KT User manual

Larson Electronics

Larson Electronics GL-29000GB User manual

Larson Electronics

Larson Electronics EPL-SL-5X75-12V-TXF User manual

Larson Electronics

Larson Electronics HAL-RSL Series User manual

Larson Electronics

Larson Electronics SPLED-QP-1X10WRE User manual

Larson Electronics

Larson Electronics GAU-HB-100LED-RT-UVA-10C User manual

Larson Electronics

Larson Electronics EPL-SL-4-50X-50LED-RT-MBC-EPP User manual

Larson Electronics

Larson Electronics HAL-48-33W-LED-1227-70C User manual

Larson Electronics

Larson Electronics TPM-2XWP60E-10C User manual

Larson Electronics

Larson Electronics HALD-48-1X4-2X50LED-DIMM User manual

Larson Electronics

Larson Electronics EPLRL-50-16.4-HR-SWB User manual

Larson Electronics

Larson Electronics EPEXC-1C-10.3-GFI-50C-BCE User manual

Larson Electronics

Larson Electronics GAU-EMG-2X5W-LED-WP User manual

Larson Electronics

Larson Electronics VPLHL-7WLED-GR30 User manual

Larson Electronics

Larson Electronics LM Multi Stage Series User manual

Larson Electronics

Larson Electronics GAU-PT-150LTL-LED-480V User manual

Popular Lighting Equipment manuals by other brands

Brizo

Brizo 8SP-MU-4 manual

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 installation instructions

IKEA

IKEA BJÖRKSPIREA manual

Laserworld

Laserworld Evolution Series ES-400RGB manual

Alien

Alien RG STAR user manual

EuroLite

EuroLite LED B-40 user manual

Qazqa

Qazqa Suplux SL 3 Black 103062 instruction manual

Commercial Electric

Commercial Electric 54568141 Use and care guide

CREE LIGHTING

CREE LIGHTING 304 Series installation instructions

Goobay

Goobay 49867 user manual

ECOMAN ITALIA

ECOMAN ITALIA LED T8 instruction manual

Alkalite

Alkalite Krypton KT-81 user manual

Clas Ohlson

Clas Ohlson GU10 manual

DTS

DTS DELTA 10 F user manual

ring

ring Solar Steplight manual

One Stop Gardens

One Stop Gardens 57696 Owner's manual & safety instructions

Chauvet DJ

Chauvet DJ COREpar UV120 ILS user manual

SIREM

SIREM Swimeo A2 instructions