Landmann 54 User manual
1
Assembly Instruction for
flat bed BBQ Art.-No. 0054
0054UK 10/04bt-rk
IMPORTANT:
READ ALL INSTRUCTIONS AND OPERATIONS
BEFORE OPERATING THIS UNIT.
FOLLOW THE CORRECT LIGHTING AND USAGE
PROCEDURES. HANDLE METAL PARTS WITH CARE
TO AVOID INJURIES. FOLLOW ALL STEPS IN
ORDER. NEVER ALLOW CHILDREN TO OPERATE
THIS UNIT.
2
Contents:
1.: Technical data
2.: Function
3.: Single part list & exploring drawing
4.: Mounting Steps
5.: Preparation
6.: Installation
7.: Warning and safety points
8.: Safety precautions
9.: Lighting instructions
10.: Storage
11.: Cleaning instructions
12.: Barbecue Safety Hints
Warnings:
Ensure to use this appliance outdoors.
Do not attempt to move this appliance during
operation. Never leave fuel cylinder attached to
regulator if disconnected from burner tube.
Attention:
Some parts of this appliance become
very hot, take special care when children or elderly are present
For your safety:
Do not store or use gasoline or methylated fuels
or any other flammable vapours and liquids in the
vicinity of this or any other appliance.
Never light a barbecue with gasoline or
comparable fluids !
3
1.:Technical Data
Gas: LPG (Propane)
Gas Bottle: Propane Gas Bottle with 27mm Clip valve
Pressure: Propane at 37 Mbar
3+ (28-30/37)
Consumption: 1,2 kg / h
Power: approx. 16,5 kW
Weight: approx. 18 kg
Overall dimensions: approx. W 134 cm, D 59 cm, H 59,8 cm
Cooking Area: approx. 64 x 49 cm
Burner set: adjustable
Ignition: Piezo Ignitor
Lava rocks: 1 Bag
The capacity of a 15 kg Butane Gas Bottle is sufficient for
a heating period of approx. 12,5 hours with full power.
You have purchased a high quality LANDMANN
Gas Appliance. This appliance has been made with
regard to the European Gas Standard (EN 498)
and bears the certification no.
CE - 0085.
The gas hose assembly that is enclosed with this
appliance conforms to British Standard BS 3212.2.
4
2.: Function
a) Pilot Gas Control Ignition:
With all gas controls on the Barbecue in the 'OFF' position, turn the gas cylinder valve
to the on position on the regulater. Push in the Barbecue ignition gas control knob and
turn anticlockwise until spring resistance is felt. Hold in this position for 3-5 seconds
to allow gas flow, and then continue to turn anticlockwise to 'HIGH"' position. Keep
the knob pressed in until the burner is seen to be alight. When the burner is alight,
adjacent burners will cross light when their controls are turned to 'HIGH'.
b) Manual Ignition:
With all the gas controls in the 'OFF' position, turn the gas cylinder valve on the regulator
to the on position. Lift out one of the cast iron cooking grills and holding a lighted taper
or gas match alongside the burner, push in and turn the gas control knob for that burner
to 'HIGH'. The burner will light in seconds. Replace the cast iron cooking grille. Once
the first burner is alight, adjacent burners will cross light when their gas controls are turned
to 'HIGH'.
At 'HIGH' setting the burner flame should be approximately 12-20mm long with a
minimum of yellow tipping. Turn the gas control fully anticlockwise for minimum setting.
Should you have any difficulty lighting your barbecue following the above steps, contact
your dealer for advice.
5
3.: Single part list / Exploring drawing
1. Raincover 1
2. Handle clip 1
3. Raincover handle 1
4. Cooking grill 1
5. Hot plate 1
6. Burner 3
7. BBQ body (pre-assembled) 1
8. R Clip 3
9. Knob 3
10. Cross Lighting tube 2
11. Front panel 1
12. Regulator 1
13. Hose 1
14. Gas control bar 1
15. Valve with ignitor 1
16. Valve 2
17. Drip pan 1
18. Drip pan handle 1
19. Gas Hose connection 1
20. Screw Ø4x10 with washer 2 Self tappers
21. Bolt M6x12 1
22. Nut M6 1
23. Screw Ø5x6 1
24. Screw Ø4x10 with washer 2
25. Lava rocks 1 Bag
26. Lava rock grid 1
6
3
2
4
6
8
7
19
13
12
5
20
10
21
22
14
11
9
24
16
15
23
18
17
1
25
26
7
4.: Mounting steps
8
1.: Attach the bbq body on the trolley (see page 7)using “U” brackers provided
2.: The cross lighting tubes (10) are placed on the burner rest and are retained in place
by the locating pegs of the burners. Fit each burner (6) to the barbecue by placing the
neck of the burner over the brass jet of the gas control valve (15)(16). The rear of
the burner is then lowered onto the back burner rest, locating the cast peg on the
underside of the burner into the hole in the burner rest and trapping the cross lighting
tube (10) in place. Repeat for the other burners. Fit the burner retaining clips to the
rear pegs of the burners, from under the burner rest.
Note: The burners should be loose on the gas control nipples. Do not attempt to fix
them tightly or seal them.
3.: Fit the drip pan handle (18) to the front edge of the drip pan (17), using the
screw supplied. Slide the drip pan into place from the front of the barbecue
below the fascia panel. Push it all the way back to its stop. This tray must be
filled before use with an even layer, approximately 10mm thick, of non-combustible,
fat absorbing medium or clean, dry sand. This must be kept clean and loose in
order to absorb fat drippings. If this is not done, it may be possible for the fat
drippings to ignite and burn. Check regularly that the absorbing medium is loose
and clean. Lining the tray with aluminium foil before filling can assist in removal
of the fat soaked absorbing medium. DO NOT USE SAWDUST OR OTHER
FLAMMABLE MATERIAL IN THE GREASE TRAY. Always ensure the tray
is pushed back to its stop point and is not held by the bottom edge of the fascia
panel.
4.: Place the lava rock grid (26) into the barbecue. This rests on the ledges formed on the
front and back panels above the burner. Spread the lava rocks (25) onto the grid in
a single even layer. Place the cast iron cooking grill and hotplate into the barbecue.
These rest on the ledges formed on the front and back panels. The cast iron cookware
should be washed thoroughly in warm soapy water, dried and coated with a liberal
coating of cooking oil before first use.
5.: Attach the raincover handle (3) to the outside and the retainer to the inside of the
raincover (1), using the two self tapping screws provided. The raincover will store
vertically behind the barbecue body when the retainer is hooked over the back panel
of the body, also acting as a windshield.
9
5.: Preparation
You will need to purchase a Propane bottle with a 27mm clip on valve to operate this barbecue
which can be obtained from your nearest Gas Retailer.
Energy saving tips:
a.: Preheat the barbecue for 5 minutes low then 10 minutes on medium.
b.: Do not preheat longer than recommended.
c.: Do not use a higher setting than required.
6.: Installation
After purchasing your gas bottle you will then be ready to set it up
with your barbecue.
a.: Position the gas bottle at the side of your barbecue, not underneath, keeping in mind
that the bottle must be kept away from heat and in a safe position.
b.: When ready to use your barbecue insert the regulator into the gas bottle valve and
tighten firmly.
Note: Before attempting to light your barbecue you must refer to your lighting instructions
and warning / safety points.
Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is
found to be faulty in any way do not attempt to use your barbecue.
When changing your gas bottle ensure that there are no sources of ignition close by i.e. fires,
cigarettes, naked flames etc. Make sure that the appliance is switched off.
Ensure that the hose is free from any kinks or bends which will affect the gas flow when using
your barbecue. Also the hose must not have undue tension and must not touch any part of
the barbecue which may be hot.
How to change your cylinder
These cylinders take a regulator which incorporates a switch for the on / off control of the
gas supply. No spanner is required.
10
How to connect a gas bottle
a.: Turn the orange cap so that the arrow is pointing to the gap in the shroud.
b.: Remove the orange safety cap by pulling the lanyard out, then out. Do not use tools.
Leave the cap hanging.
c.: Check that the black sealing washer is fitted inside the cylinder valve. Place the regulator
down over the valve with switch in 6 o´clock position.
d.: Turn the switch clockwise to the OFF (9 o’clock) position.
e.: To turn gas on turn control counter anti - clockwise on gas bottle - then turn on the
barbecue as instructed.
Note: Always test gas line for leaks at connector with soapy water finishing all connections.
How to disconnect a gas bottle
a.: Turn the switch clockwise to the OFF (9 o’clock) position.
b.: Except for twin - cylinder installations with a changeover valve, turn off the gas tap if
fitted to the appliance. Wait until the burner and pilot light have gone out.
For installations with a changeover valve, it is only necessary to switch off the empty
cylinder.
c.: Never turn the switch to the disconnect (6 o’clock) position straight from the ON
(12 0´clock) position.
d.: Depress the centre button of the switch. Keeping it depressed turn the switch anticlockwise
to the disconnect (6 o’clock) position and lift off the regulator.
e.: Replace the orange safety cap onto the empty cylinder.
7.: Warning and Safety Points
Please read the following points before using your barbecue:
1.: Please follow all assembly instructions in this manual, if instructions are not followed it
may cause problems in use.
2.: This barbecue will become very hot when being used, care is to be taken especially when
pets, children or elderly people are present.
3.: In the event of a gas leak shut off gas to the barbecue, extinguish any open flames, open
lid and if leak continues check for damages, poor connections etc. Contact your local
gas dealer immediately if the problem can not be solved.
4.: Do not attempt to move Barbecue while it is in operation.
5.: Do not use or store any flammable liquids or vapours in the vicinity when operating the
barbecue.
Table of contents
Other Landmann Grill manuals
Landmann
Landmann TRITON 2.0 User manual
Landmann
Landmann 0423 User manual
Landmann
Landmann Avalon series User manual
Landmann
Landmann 590151 User manual
Landmann
Landmann Triton PTS 2.1 User manual
Landmann
Landmann 590131 User manual
Landmann
Landmann 11901 User manual
Landmann
Landmann TRITON User manual
Landmann
Landmann 42209 Guide
Landmann
Landmann Rexon Select PTS 3.1 User manual
Landmann
Landmann 11422 User manual
Landmann
Landmann Triton PTS 4.1 User manual
Landmann
Landmann Avalon 4.1 12792 User manual
Landmann
Landmann Grill Chef 11242 User manual
Landmann
Landmann Pantera User manual
Landmann
Landmann CHARCOAL GOURMET 610101 User manual
Landmann
Landmann 525142 User manual
Landmann
Landmann 520268 User manual
Landmann
Landmann 45027 Guide
Landmann
Landmann REXON FLEXX 2.0 User manual
Popular Grill manuals by other brands
Kenmore
Kenmore 415.16123800 Use and care guide
Camp Chef
Camp Chef PG24CLAU Warning & instruction booklet
Tucker Barbecues
Tucker Barbecues GTR Series Assembly, installation and operating instructions
Monogram
Monogram ZGG540NCP1SS owner's manual
Equipex
Equipex Sodir Savoy Operation manual
Gaggenau
Gaggenau VR 414 610 use and care manual
