Kuppersbusch IKDU 9900.0PW Quick guide

Installation and instruction manual

IKDU 9900.0PW

Important notes

Miscellaneous

This installation instruction contains important information, read it carefully and follow any

instructions. This will prevent failure caused by wrong use and/or installation. Keep this

manual for possible later use. Follow the instructions from the manufacturer of the cooking

equipment for the installation of hoods. Install this hood with at least two people. Replace

defective parts only with original spare parts from the manufacturer.

If you have bought a cooker hood with an external motor then you will find more

information in the manual for the motor which is to be found in the package.

Safety requirements

Please note that the installation should only be done by a professional as he has the

knowledge about the air duct and the electrical connection. Make sure that the wall or

ceiling is suitable for the weight of the cooker hood. For fixing the cooker hood please use

the enclosed plugs. Depending on the surface the plugs (8mm) are having the following

bearing capacities:

brick 5,2 kN

concrete 9,4 kN

lime sand brick 4,8 kN

If you need to fix your cooker hood on other surfaces please ask a professional.

Risk of injury

During manufacturing of the extractor, sharp edges can be formed. Therefore always wear

gloves during installation.

Danger of electric shock

Voltage must match the voltage marked on the ratings plate. This plate can be found under

the grease filter. This appliance should be connected to a grounded system. The electrical

connection must be easily accessible after installation.

Before any maintenance or repair the power supply must be disconnected!

Air outlet

The air should not be discharged into a chimney which is also used for the removal of

exhaust gases from equipment working on fuel (including gas). Take into account the rules

for air outlet. Prepare electrical connection and ducting, that way the hood can easily be

connected. Avoid sharp bends and kinks in the drain hose.

Mounting above a stove

Furnace for solid fuels

In a solid fuel stove which can fire out (sparks) is the fitting of the hood only allowed when

the furnace is closed and its shielding is not removable.

Gas stove

The minimum distance between the gas stove and the cooker hood is 750mm. If the

manufacturer of the stove is recommending a lager distance please follow this advise.

Electric hob

The minimum distance between the gas stove and the cooker hood is 650mm. If the

manufacturer of the stove is recommending a lager distance please follow this advise.

Gas hob

The installation of the gas hob with a minimum distance of 750mm to the cooker hood is

only allowed if the following, single values for the thermal load are not exceeded.

load of one cooking zone max. 3,0 kW

load of all cooking zones max. 8,3 kW

load of the cooker max. 3,9 kW

Always follow the installation requirements and instructions of the cooker manufacturer!

Control

The cooker hood has the following functions:

Button 1:low level

Button 2: average level

Button 3: high level

Button 4: intensive level, after 3 minutes it will automatically switch back to high speed.

Button 5: Automatic delay stop – Pressing this key will switch the motor to highest

speed, after every three minutes it will switch to an lower speed until it switches off.

Button 6: light on/off

Button 7: Grease filter saturation indicator – when lit the grease filter must be cleaned,

after cleaning the light can be reset by pressing and holding the key for 5 seconds.

Grease filter

Reset of grease filter saturation indicator

After cleaning the grease filter press button 7 for 5 seconds to reset the electronic.

Removal of grease filter

Dismount the grease filter by pulling it down by its two knobs and remove the safety

cable. Attention! When reinstalling the grease filter please do not forget to connect the

safety cable!

Grease filter cleaning

Dismount the grease filter by pulling it down by its two knobs and remove the safety

cable. The grease filter can be cleaned in the dishwasher, it is possible that it’s surface

slightly fade!

Important: Highly saturated filters should not be cleaned together with the regular

dishes!

When cleaning the grease filter by hand, soak in a hot soapy water, then brush, rinse

and let drain.

Important:

-Only a fully dried filter should be put back in the appliance, this to prevent short circuit

-Clean the grease filter regularly, this will prevent later difficult cleaning.

-Don’t use 3-phase cleaners when cleaning the filter in a dishwasher. Don’t clean the

filters in a

professional dishwasher.

-Cleaning with aggressive products such as gasoline, acetone or trichloroethylene shall

be strongly discouraged.

Charcoal filter

Replacement of charcoal filter

As the charcoal filter is cleaning the exhaust air from grease and odours we recommend

to replace this filter every 3 to 6 months (depending on use of cooker hood). The

charcoal filter is placed under the motor. When replacing the filter please press in the

two fixing points (1) and pull out the filter. (see picture)

•disconnect main power

•remove grease filter

•unlock charcoal filter

•replace used charcoal filter

•set in new charcoal filter

•Attention!Never try to clean the charcoal filter with water!

Lighting

Bulb replacement

Faulty lamps should be replaced. Before changing the bulb disconnect the hood from

main power (pull the plug).

Lamps remain hot for a while, let them cool down before touching them.

-Disconnect main power.

-Remove the metal ring with a small screwdriver. (see photo 1) Attention! Don not

drop the glass cover.

-Remove the old bulb.

-Install a new bulb (type G4 (20 W)), hold it with a cloth. (Don not touch the bulb with

your skin!)

-Install the glass cover and metal ring.

Photo 1

Trouble-shooting

Check the following points before contacting the service department.

Installation instruction

Installation of the Küppersbusch cooker hood IKDU 9900.OPW

1. Determine the centre of the hood over the stove. Use a plumb to mark the centre of

the unit on the ceiling.

2. Mark the drilling holes with help of the ceiling fixing plate.

3. Drill holes for mounting the cooker hood (4xM8). Insert the plugs in the drilled holes

and screw the bolts in as far as they stick out 20mm.

4. Place the mounting plate on the bolts and fix it with help of the washers and nuts.

5. Fix the rods by tightening the set screws (M4).

6. Connect the cooker hood to the power supply.

7. Slide the ceiling plate on the rods and fix it with the spherical-head screws (M4).

Please tighten these screws with a screw driver by hand only!

8. After this mount the complete cooker hood with help of two people to the rods and

tighten the set screws (M4).

9. Finally connect the cable which comes out of the rod to the cooker hood.

Other Kuppersbusch Ventilation Hood manuals

Kuppersbusch

Kuppersbusch EDL 9750.1E Operation manual

Kuppersbusch

Kuppersbusch DW9800.0S Operation manual

Kuppersbusch

Kuppersbusch EDIP6400.2 Operation manual

Kuppersbusch

Kuppersbusch KD 6500.1 User manual

Kuppersbusch

Kuppersbusch IKD 9600 User manual

Kuppersbusch

Kuppersbusch LB 6650.1 E Operation manual

Kuppersbusch

Kuppersbusch TKD Quick setup guide

Kuppersbusch

Kuppersbusch DW8300.0S User manual

Kuppersbusch

Kuppersbusch KD 6210.1 GE Operation manual

Kuppersbusch

Kuppersbusch KD6590.0GE User manual

Kuppersbusch

Kuppersbusch KD 3700.0 User manual

Kuppersbusch

Kuppersbusch LB 1000 E User manual

Kuppersbusch

Kuppersbusch KD 6210.0 GE Operation manual

Kuppersbusch

Kuppersbusch LB 635.1 Quick setup guide

Kuppersbusch

Kuppersbusch DI 3800.0 S Operation manual

Kuppersbusch

Kuppersbusch KD 6210.0 GE Operation manual

Kuppersbusch

Kuppersbusch KD 906.3 User manual

Kuppersbusch

Kuppersbusch EDD9960.OGE Technical manual

Kuppersbusch

Kuppersbusch VarioLine K Series Operation manual

Kuppersbusch

Kuppersbusch DEL5100.0 User manual

Kuppersbusch

Kuppersbusch EDIP 9650.0 User manual

Kuppersbusch

Kuppersbusch KD 380.1 GE Operation manual

Kuppersbusch

Kuppersbusch KD15560.0 Operation manual

Kuppersbusch

Kuppersbusch IKD 6700.0 User manual

Popular Ventilation Hood manuals by other brands

emmeti

emmeti RECUPA MED A-140 Installation and use manual

Nibe

Nibe F135 user manual

Kuppersberg

Kuppersberg INTRO 60 Technical Passport

Zephyr

Zephyr Spruce AK9834BS Use, care and installation guide

Hisense

Hisense MH6INBG manual

Miele

Miele DA 1255 Operating and installation instructions

Broan

Broan 46000 Specification sheet

GE Profile PV977 Owner's Manual & Installation Instructions

FALMEC

FALMEC FFRIA24W5FS Instruction booklet

Whirlpool

Whirlpool RH2600XL-1 SERIES installation instructions

Küppersbusch

Küppersbusch DX ISLA instruction manual

ETNA

ETNA AV360RVS Instructions for use

JUNO

JUNO JDF603E6 installation manual

Miele

Miele DA 6708 D Operating and installation instructions

Tricity Bendix

Tricity Bendix LE 150 Installation & operating instructions

AEG

AEG X68163BV1 user manual

AEG

AEG 125 D operating instructions

Smeg

Smeg KSEV97X instruction manual