Kramer VM-3H2 User manual

Other manuals for VM-3H2

2

Table of contents

Popular Switch manuals by other brands

URC

URC Total Control MFS-8 installation manual

Azbil

Azbil HPQ-D11 user manual

Sony

Sony DFS-900M operating instructions

SICK

SICK i17S operating instructions

F&F

F&F SZR-277 quick start guide

Shure

Shure UAMS/BK user guide

Dräger

Dräger X-zone Switch Off Instructions for use

Asco

Asco Joucomatic 349 Series manual

BT

BT Mini Hub user guide

D-Link

D-Link DES-1226G manual

Johnson Controls

Johnson Controls FS80-C installation instructions

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Configuration guide

MicroNet

MicroNet SP1200A user manual

Ruijie

Ruijie RG-PF2920 Series Hardware installation and reference guide

Altinex

Altinex DA1914SX user guide

MiLAN

MiLAN MIL-SM2401M user guide

RJM

RJM MASTERMIND PBC/6X user manual

Atlas

Atlas MMK-KVM8 owner's manual

VM-3H2 Quick Start

P/N:

2900- 301131QS

Rev:

3

Scan for full manual

VM-3H2 Quick Start Guide

This guide helps you install and use your VM-3H2 for the first time.

Go to www.kramerav.com/downloads/VM-3H2 to download the latest user manual and check if firmware

upgrades are available.

Step 1: Check what’s in the box

VM-3H2 4K HDMI 2.0 1:3 DA

4 Rubber feet

1 Power supply (5V DC)

1 Quick start guide

Step 2: Mount VM-3H2

Install VM-3H2 using one of the following methods:

•Attach the rubber feet and place the unit on a flat surface.

•Fasten a bracket on each side of the unit and attach it to a flat surface

(see www.kramerav.com/downloads/VM-3H2).

•Mount the unit in a rack using the recommended rack adapter

(see www.kramerav.com/product/VM-3H2).

•Ensure that the environment (e.g., maximum ambient temperature & air flow) is compatible for the

device.

•Avoid uneven mechanical loading.

•Appropriate consideration of equipment nameplate ratings should be used for avoiding overloading of

the circuits.

•Reliable earthing of rack-mounted equipment should be maintained.

•Maximum mounting height for the device is 2 meters.

Step 3: Connect inputs and outputs

Always switch OFF the power on each device before connecting it to your VM-3H2.

To achieve specified extension distances, use the recommended Kramer cables available at www.kramerav.com/product/VM-3H2.

Using third-party cables may cause damage!

Step 4: Connect power

Connect the power cord to VM-3H2 and plug it into the mains electricity.

Safety Instructions (See www.kramerav.com for updated safety information)

Caution:

•For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the

terminal or in the User Manual.

•There are no operator serviceable parts inside the unit.

Warning:

•Use only the power cord that is supplied with the unit.

•Disconnect the power and unplug the unit from the wall before installing.

Step 5: Set DIP-switches

Set the DIP-switches according to your needs using the following table:

Programming mode

HDCP Input (MAC mode)

Force RGB

Lock Default EDID

DIP

1

2

3

4

OFF (up)

Normal mode

HDCP enabled

Force RGB

EDID not locked

ON (down)

Enable programming

HDCP disabled

Normal mode

EDID locked