Kramer 617T User manual

Installation Instructions

MODELS:

617T, 617R

4K HDR HDMI Tx/Rx over Extended-Reach

Multi-Mode Fiber Optic Cable

SAFETY WARNING

Disconnect the unit from the power supply before opening and servicing

For the latest information on our products and a list of Kramer distributors, visit our Web site where

updates to this user manual may befound.

We welcome your questions, comments, andfeedback.

www.KramerAV.com

info@KramerAV.com

P/N:

2900-301021

Rev:

All manuals and user guides at all-guides.com

all-guides.com

617T, 617R 4K HDR HDMI Tx/Rx over Extended-Reach Multi-Mode Fiber

Optic Cable

Congratulations on purchasing your Kramer 617T and 617R Plug and Play active 4K HDR HDMI

Tx/Rx over Extended-Reach Multi-Mode (MM) Fiber Optic cable. 617T and 617R extend signals of up

to 4096x2160 @60Hz (4:4:4), over a distance of up to 200m (656ft) without signal scaling or data

compression, providing a maximum data rate of 18Gbps. 617T and 617R are easily and securely

connected via a 2LC fiber connector and can be powered from the USB connector. Alternatively, 617T

only can be powered from the HDMI interface (pin #18).

Figure 1: 617T Transmitter and 617R Receiver

Safety

Caution:

There are no operator serviceable parts inside the unit.

Warning:

Disconnect the power and unplug the unit from the wall before installing.

Warning:

Avoid direct eye exposure into the optic connectors when powered,

although this product is regulated strictly enough to operate under the

Laser Class 3R for eye safety.

See www.KramerAV.com for updated safety information.

Installation

To install 617T and 617R:

1. Unpack the contents of the package with care.

We recommend that you save the original box and packaging materials for possible future

shipment.

2. Turn on the power to the HDMI source (for example, a laptop) and acceptor (for example, a

display).

3. Power the 617T and 617R:

•Connect the micro USB connector on each device to a USB cable (supplied).

•Connect the USB cable either to the wall-mount power adapter (supplied) and to the

mains, or to a USB port.

The POWER LED lights and the STATUS LED flashes three times.

Although 617T can be powered via pin #18 on the HDMI interface, we

recommend that you use the USB power adapter.

617R can only be powered via the USB power adapter.

All manuals and user guides at all-guides.com

4. Connect the two LC optical fibers between 617T and 617R.

Connect (A) to (A) and (B) to (B). Make sure that the duplex connectors are connected

properly.

The STATUS LED flashes.

Do not look directly into the LC connectors on the 617T (the transmitter side)

when it’s powered.

This product operates under LASER Class I, classified by CDRH/FDA for eye

safety.

We recommend that you avoid using intermediate cables or adapters. Using

them may affect the transmission quality.

5. Connect 617T to the HDMI connector on the source side and 617R on the acceptor side.

Make sure that the 617T is always connected to the source side and the

617R is connected to the acceptor side.

Once the system is connected the Status LEDs on both 617T and 617R flash.

Troubleshooting

If the display appears black:

•Check that the power source adapters are properly connected on both sides.

•Check that both HDMI connector heads are fully plugged into the devices.

•Check that the source and display devices are both switched on.

•Reset the system by disconnecting and then reconnecting the 617T or 617R, or by

disconnecting and then reconnecting the power adapters.

•Reboot the system.

All manuals and user guides at all-guides.com

If the image appears distorted and/or there is background noise:

•Go to the display properties and check the settings. Make sure that the resolution is set below

4096x2160 at a 60Hz refresh ratio to check if the graphic resolution is properly defined.

•Reset the system by disconnecting and then reconnecting the 617T or 617R, or by

disconnecting and then reconnecting the power adapters.

It is important to connect the devices correctly as marked: 617T to the source side and

617R to the acceptor side.

Specifications

Video

Max. Resolution

4K @60Hz 4:4:4 (4096x2160)

Data Rate

Maximum 6 Gbps per channel

Compliance

Supports HDMI 2.0, HDCP 2.2, EDID and CEC

Ports

617T (source end)

Male HDMI connector

617R (display end)

Male HDMI connector

617T (source end)

Micro USB (for power supply)

617R (display end)

Micro USB (for power supply)

Power

Via USB source

Via external source

From HDMI PIN #18 (617T only)

Consumption

<2.5W

Recommended

Cable

Structure

Dual Multi-mode OM3 (50/125um) glass fiber

Optical Connectors

Duplex LC connectors

Max. Fiber Cable Attenuation

(λ=850nm)

2.5dB/KM

Max. Skew

0.4ns

Max. Insertion Attenuation

0.5dB

Total Optical Attenuation

1dB max @ 656ft/200m extension

Maximum Length

200m (656ft)

Environmental

Conditions

Operating Temperature

0° to +50°C (32° to 122°F)

Storage Temperature

-30° to +70°C (-22° to 158°F)

Operating Humidity

0 to 85%

Standard

Compliance

EN 55032:2012/AC: 2013 (Class A),

EN 61000-3-2:2014, EN 61000-3-3:2013,

EN 55024:2010

FCC

CFR 47 part 15 SUBPART B Class B, Section

15.101

Environmental

RoHS (2011/65/ EU)

General

Net Dimensions (W, D, H), each

2.6cm x 7.2cm x 1.5cm

(1" x 2.8" x 0.6")

Shipping Dimensions (W, D, H)

19.3cm x 25.3cm x 62cm

(7.6" x 10" x 24.4")

Net Weight, each

0.12kg (0.3bs) approx.

Shipping Weight

1.48kg (3.3lbs) approx.

Accessories

Included

2 Micro USB to USB type-A cables, 2 Wall-mount

power adaptors

All manuals and user guides at all-guides.com

This manual suits for next models

Popular Extender manuals by other brands

SY HDBT-60T installation guide

Appsys ProAudio

Appsys ProAudio ADX-16 user manual

Atlona

Atlona RS232 user manual

IDK

IDK OPF-TH1000-A user guide

Enable-IT

Enable-IT 824WP quick start guide

Worx

Worx Landroid RadioLink WA0864 Get started

TP-Link

TP-Link TL-WA730RE user guide

Camplex

Camplex CMX-HDMI-SFPL user manual

SC&T

SC&T HE03-4K user manual

Marmitek

Marmitek MegaView70 user manual

Samsung

Samsung SCS-26UC4 user guide

Foxun

Foxun SX-GES24 operating instructions

MuxLab

MuxLab 500771 Operation manual

foxunhd

foxunhd SX-AEX01 operating instructions

TERK Technologies

TERK Technologies LFIRX2 owner's manual

Devolo

Devolo Audio Extender supplementary guide

Edimax

Edimax EW-7438RPn V2 instructions

Shinybow USA

Shinybow USA SB-6335T5 instruction manual