Keystone Hardscapes YORKSHIRE User manual

YORKSHIRE™

SQUARE FIRE PIT

YORKSHIRE

™

| SQUARE FIRE PIT KIT

Product Number #YSFP

Included in Kit 48 Units

Length 44"

Width 44"

Height 16"

Pallet Weight 1,142 lbs

YORKSHIRE

™

| SQUARE FIRE PIT KIT

Step 1 | Foundation

Place and compact a level base with gravel extended beyond the

Ashland ﬁre wedge units by at least 4 inches. The surface of the leveling

pad should extend below grade by 2 inches. If you are using a concrete

paver base, place Yorkshire units directly onto the base. Fill the bottom

with 2-4 inches of sand for drainage.

Step 2 | Install Base Course

Lay out the ﬁrst course (base layer) of Yorkshire units in a square design

with 28" x 28" from the inside wall. Adjustments to the units may be

necessary to ensure alignment as the units should ﬁt tightly together.

Ensure the ﬁrst layer is level front-to-back and side-to-side.

Step 3 | Install Additional Layers

Apply a bead of exterior grade construction adhesive to the base layer

of units. The second course units should be centered over the two units

below to establish a running bond (see graphic at right). Repeat for

courses 3 & 4.

Important Note: Burning large items or trash in ﬁre pits may cause damage to the Yorkshire units. Our ﬁre features are designed strictly for small ﬁres.

Keystone Hardscapes recommends a steel insert to protect units and will not be held liable for damage to the ﬁre pit or coping if an insert is not used.

Speciﬁcations

Installation

www.keystonehardscapes.com

Yorkshire Unit

4" x 12" x 8"

Steel Insert

(with cooking grate)

Granite Blend

Desert Blend Sandstone Blend

Available Colors Optional Accessories

Steel Insert

Courses 1 & 3 Courses 2 & 4