K150/ K150P Cleaning
& Start-up Procedure
Cleaning & Sanitizing Procedure
Cleaning Solution
1. Prepare Urnex Rinza solution by adding 8 oz (240 ml) of Urnex Rinza concentrate
to 1 gallon (3.5 L) of warm tap water (or equivalent dilution).
2. Mix well and use immediately.
3. Soak removed parts for 30 minutes in solution.
If parts could not be removed from the appliance, then add cleaning solution to a soft cloth
and use it to coat appliance parts then let sit for 30 minutes.
Sanitizing solution
1. Prepare Urnex Complete Café Sanitizer Solution by adding 0.5 oz (15 mL) of Urnex
Complete Café concentrate to 1 gallon (3.7 L) of warm tap water.
2. Mix well and use immediately.
3. Soak parts in solution for 1 minute.
If parts could not be removed from the appliance, then add sanitizing solution to a soft cloth
and use it to coat appliance parts then let sit for 1 minute.
4. Remove parts from solution and allow to drain and dry completely.
Do NOT rinse.
If parts were not removed from the appliance, wipe with a clean soft cloth and let air dry.
Do NOT rinse or apply water.
Sanitize Machine Surfaces (as needed)
1. Prepare a solution of 4 mL of Urnex Complete Café Sanitizer to 1 L of water.
in a spray bottle.
2. Spray exterior surface of appliance and allow solution to remain on surface for 1 minute.
3. Wipe away with clean cloth and allow to fully air dry.
Urnex Café Wipz
These can be used to wipe down any components of the brewer that cannot be easily removed.
Urnex Cleaning Pods
These can be used during Cleansing brews to clean the bottom of the pod holder and exit needle.
