KMC-41D
2
1. Removing the cable ASSY
1) Pull out the holder that is set into the fixing bracket of the
cable ASSY, using a pair of pliers.
Holder
Fixing bracket
Waterproof line
Cable ASSY
Fig. 1
2) Completely peel off the bond (*1) glued to the cable
ASSY, using a set of nippers.
Note: Please be careful not to damage the coating of the
cable ASSY and the waterproofing line of the front case.
*1: Use the following bond:
• Manufacture name: Shin-Etsu Chemical Co., Ltd.
• Bond name: Shin-Etsu silicone One-component RTV
silicone rubbers Alcohol type KE-4898-T
Bond
Fig. 2
3) Following the procedure below, pass through the connec-
tor part of the cable ASSY into the hole of the front case
(waterproof line part).
(1) Move the three lead wires soldered onto the PCB to
the upper corner of the hole.
(2) The yellow lead wire side of the connector comes in
the inside of the front case.
White lead wire
Yellow lead wire
Three lead wires
Fig. 3
(3) Push the cable ASSY to the earphone jack side with
the connector part bent as shown in the figure, then
hook the end of the connector (white lead wire side)
into the outside corner of the hole, using your finger.
(4) Pass the connector through the hole, pushing the con-
nector (yellow lead wire side) using a pair of tweezers
or similar tool.
Note: Attach adhesive tape or rubber to the end of the
tweezers so as not to damage the connector of the
cable ASSY.
Yellow lead wire
Fig. 4
4) Pull the cable ASSY, then remove the cable ASSY from
the front case by passing the connector part through the
hole of the front case.
Fig. 5
DISASSEMBLY FOR REPAIR
