kb!ce KBFM1JA01 User manual
Portable Nugget Ice Dispenser
User Instructions
Model: KBFM1JA01
Table of Contents:
Safety Instructions 2
Features & Specications 4
Use Of Dispenser 6
Dispenser Care 10
Installation Instructions 14
Troubleshootings 15
Service & Important Notice 16
2
GENERAL OPERATING
INSTRUCTION
Read these instructions before use and save them
for future reference. Let the unit rest and remain
unplugged for 24 hours before use.
• Remove all external and internal packaging
materials. Be sure that all parts have been
included before discarding any packaging
materials. You may want to keep the packaging
materials for use at a later date.
SAFETY INSTRUCTIONS
Electrical Safety
THANK YOU FOR
YOUR PURCHASE
Thank you for purchasing the Portable Nugget Ice
Dispenser. Enjoy ice nuggets anywhere.
CONTACT US
Phone:
Email:
DANGER
Improper use of the power cord plug can
result in the risk of electrical shock, property
damage and personal injury or death.
Unplug the unit or disconnect power before
performing any maintenance.
Upon receipt and inspection of the unit the
power cord must be replaced if it is damaged.
DANGER
To reduce the risk of injury when cleaning
your appliance follow these basic precautions.
CAUTION
When disposing of refrigerated appliances,
special handling is often required. It is the
consumer’s responsibility to comply with
federal and local regulations when disposing
of this product.
Disposing
• Unplug the appliance before performing
any maintenance.
• Do not clean appliance with ammable
uids. Do not store or use gasoline or other
ammable vapors or liquids in the vicinity of
this or any other unit. The fumes can create a
re hazard or explosion.
• Do not use solvent-based cleaning agents
or abrasives on the interior or exterior of the
appliance. These cleaners may damage or
discolor the appliance.
• Do not operate the appliance with wet hands,
while standing on a wet surface, or while
standing in water.
Child Safety
• Exercise caution and use reasonable
supervision when appliance is used near
children. Never allow children to operate
the unit. Keep packing materials away from
children.
• Keep ngers out of dispense point area.
Cleaning
3
• This appliance is equipped with a 3-prong
grounding-type plug.
• It is required to use a 3–prong grounding-
type electrical outlet properly grounded in
accordance with the National Electrical Code
and local codes and ordinances.
• A separate adequately fused and grounded
circuit shall be used for this appliance. The
voltage rating must match the rating label on
the unit.
• Do not under any circumstances cut or remove
the third ground prong from the power cord.
• Never unplug the appliance by pulling the
power cord. To disconnect the unit always grip
the plug rmly and pull straight out from the
wall outlet.
• Do not operate the appliance if the appliance
housing is removed or damaged.
• Do not attempt to repair or replace any part
of your appliance unless it is specically
recommended in this manual. All other
servicing shall be referred to a qualied
technician.
• To protect against electric shock do not
immerse appliance plug or cord into water or
other liquids.
CIRCUIT
GROUNDING
CONDUCTOR
PROPERLY
CONNECTED
GROUNDING PRONG
4
FEATURES & SPECIFICATIONS
Overview
This compact automatic ice dispenser allows you to enjoy nugget ice with the touch of a button. Water ll
through push-to-open or removable door makes it portable and easy to use.
Features and Parts
1
8
2
3
6
5
7
4
• This compact automatic ice dispenser allows you to enjoy
nugget ice with the touch of a button.
• The built-in ice engine can quickly make nugget ice within 60
minutes and produce 20 lbs of ice per day.
• Automatic cleaning and descaling programs can keep the unit
in a good sanitary and operational condition all the time.
• Water ll through push-to-open or removable cover provides
you with the convenience to use it anywhere.
• Less than 17.5 inches in height allows for installations on any
counters and tables.
1. Display Panel
2. Ice Dispense Point
3. Water Port
4. Reservoir Cover
5. Air Vent
6. Water Drip Tray
7. Power Cord
8. Drain Tube Plugs/Holder
Product Portable Nugget Ice Dispenser
Model No FDFM1JA01
Ice Type Chewable Nugget Ice
Ice Production Capacity (75°F Air) 26 lb / 24 h
Ice Storage Capacity 2 lb
Water Reservoir Capacity 100 oz
Ice Dispensing Actuation Touch Button
Drip Tray Magnetically Detachable
Drain Plumbing Not Required
Water Supply Manual Fill
Water Fill Port Push to Open / Removable Door
Touch Buttons Make Ice, Clean, Dispense Ice
LED Notications Making Ice, Cleaning, Water Level, Power
Operating Temperature 50~90 °F
Electrical Rating 115V/60Hz/2.5A
Refrigerant R600a
Installation Countertop
Unit Dimensions 12”W x 16” D x 17-1/2”H
Net Weight 40 lb
Specications
5
WATER LEVEL
CLEAN
POWER
DISPENSE
NUGGETS
MAKE
NUGGETS
CLEANING
Hold for 3 sec
MAKING ICE
6
CLEANING NOTE
Clean the unit once a week to prevent high
water TDS and hardness.
Descale the unit with citric acid once a month
to prevent sediment building up.
Sanitize the unit with chlorine bleach once a
month to prevent bacteria growing.
NOTE
Use potable water only.
Water TDS level must be 5~400 mg/L or PPM.
Water Hardness must be no greater than 10
grains/gal (180 mg/L).
USE OF DISPENSER
Display
WATER LEVEL
CLEAN
POWER
DISPENSE
NUGGETS
MAKE
NUGGETS
CLEANING
Hold for 3 sec
MAKING ICE
WATER LEVEL
CLEAN
POWER
DISPENSE
NUGGETS
MAKE
NUGGETS
CLEANING
Hold for 3 sec
MAKING ICE
WATER LEVEL
CLEAN
POWER
DISPENSE
NUGGETS
MAKE
NUGGETS
CLEANING
Hold for 3 sec
MAKING ICE
WATER LEVEL
CLEAN
POWER
DISPENSE
NUGGETS
MAKE
NUGGETS
CLEANING
Hold for 3 sec
MAKING ICE
WATER LEVEL
CLEAN
POWER
DISPENSE
NUGGETS
MAKE
NUGGETS
CLEANING
Hold for 3 sec
MAKING ICE
LED illuminates when the unit is
plugged into power.
Red LED ashes when more water is needed.
Green LED illuminates once water is full.
Blue LED ashes slowly while
the unit is currently making ice.
Green LED illuminates once
the ice bin is full.
LED ashes slowly while the unit
is currently in cleaning process.
LED ashes quickly once cleaning
is needed for defrosting process.
Make Nuggets Button can be used
when the unit is not in the Cleaning
mode.
• To make ice, press the button once. The
Making Ice LED ashes slowly indicating that
ice is being made.
• To stop making ice, press and hold the button
for 3 seconds. The Making Ice LED will go off.
Clean Button can be used when the
unit is not in the Ice Making mode.
Also, can be used for defrosting,
ushing, descaling or sanitizing
process.
• Press and hold for 3 seconds to start Cleaning,
the Cleaning LED ashes slowly while the unit
is currently in cleaning process.
• Press and hold for 3 seconds again to stop
Cleaning, the Cleaning LED goes off.
7
Use Of Dispenser (continued)
1. Filling the water reservoir for the rst time use
• Remove the reservoir cover by simultaneously
pulling from the left and right side towards you
(See illustration 1).
• Add water to MAX WATER FILL and then
replace cover.
2. Flushing the unit for the rst time
• Plug the unit into power.
• Press and hold Clean button for 3 seconds to
start the Cleaning mode
• Unplug the unit when the ushing process is
complete (it takes 30 minutes and the Cleaning
LED goes off).
• Pull the drain tubes with plugs/holders out of
the unit back and remove the plugs/holders to
release water.
• Replace the plugs/holders and put the tubes
with plugs/holders back to the unit.
8
FIRST TIME USE
For the rst time use ush the unit following
instructions below.
For the rst time use dispense several cups of
ice and then discard them.
Water
Port
LR
MAX Water Fill Magnets
MIN Water Fill
Reservoir
Cover
Pug/Holders
Drain Tubes
1. 2.
9
Water
Port
Reservoir
Cover
Pump
Protector
Dispense Nuggets button
The unit will stop dispensing
automatically after 60 seconds elapse.
• Place a cup under the ice dispense point.
• Press and hold to dispense ice, release to stop.
Combination Buttons
can be used when the
unit can’t dispense ice
because ice is jammed.
• While you hold Dispense Nuggets button,
press and hold Clean button to turn the ice
auger backwards.
Cleaning the pump protector
• Drain water following instructions in Section 2.
• Remove the water reservoir door and lift up the
pump protector.
• Clean the pump protector with dishwashing
liquid and rinse it with potable water.
• Replace the pump protector
Dispensing Ice
NOTE
Do not add water until Water Level red
LED ashes.
Do not overll the reservoir otherwise it may
overow when ice melts completely.
NOTE
The unit does not dispense ice while Cleaning
LED ashes.
3. Making ice for the rst time use
• Add water to the MAX WATER FILL.
• Plug the unit into power.
• Press Make Nuggets button once and wait
for the Making Ice LED to ash slowly which
indicates that ice is beginning to be made
• Push the water port door to open.
• Add water until the Water Level green LED
illuminates with 5 beeps.
• Release the water port door to close.
Or
• Add potable water between MAX WATER FILL
and MIN WATER FILL.
WATER LEVEL
CLEAN
POWER
DISPENSE
NUGGETS
MAKE
NUGGETS
CLEANING
Hold for 3 sec
MAKING ICE
WATER LEVEL
CLEAN
POWER
DISPENSE
NUGGETS
MAKE
NUGGETS
CLEANING
Hold for 3 sec
MAKING ICE
WATER LEVEL
CLEAN
POWER
DISPENSE
NUGGETS
MAKE
NUGGETS
CLEANING
Hold for 3 sec
MAKING ICE
3. If the Water Level red LED ashes and the
unit stops making ice
• Fill the water reservoir with clean potable water.
4. If the Water Level red LED illuminates but
the water reservoir is full
• Unplug the unit and plug the unit into
power again.
5. If the Cleaning LED ashes and the unit
stops making ice (If this section can’t solve
your problem, please go to section 9)
• Empty the ice bin and water reservoir following
instructions in Section 2.
• Plug the unit into power.
• Fill the water reservoir with clean potable water.
• Press and hold Clean button for 3 seconds to
start the Cleaning mode.
• Unplug unit and drain the water following
instructions in Section 1.
• Plug the unit back into power
• Fill the water reservoir with clean potable water.
• To start making ice, press Make Nuggets
button once
1. How to drain water
• Unplug the unit.
• Pull the drain tubes with plugs/holders out
of the unit back and lower them to a bucket
or sink, remove the plugs/holders to release
water.
• Replace the plugs/holders and put the tubes
with plugs/holders back to the unit.
2. How to empty the ice bin and water
reservoir
• Dispense ice until no more ice comes out of
the ice dispense point.
• Unplug the unit and let the remaining ice melt.
• Drain water following instructions in Section 1.
CAUTION
Use food grade citric acid powder and
chlorine bleach only.
Follow the product instructions carefully for
First Aid.
Keep them out of reach of children.
DISPENSER CARE
10
This manual suits for next models
1
Table of contents
Other kb!ce Ice Maker manuals
