JVC KD-G425S User manual
ENGLISH
INDONESIA
CD RECEIVER KD-G425S
ALAT PENERIMA CD KD-G425S
For canceling the display demonstration, see page 5.
Untuk membatalkan tampilan demonstrasi, lihat halaman 5.
INSTRUCTIONS
BUKU PETUNJUK
GET0550-001A
[UN]
Cover_KD-G425S[UN]f.indd 2Cover_KD-G425S[UN]f.indd 2 2/18/08 11:13:51 AM2/18/08 11:13:51 AM
2
ENGLISH
Please read all instructions carefully before operation, to ensure your complete understanding and to
obtain the best possible performance from the unit.
IMPORTANT FOR LASER PRODUCTS
1. CLASS 1 LASER PRO UCT
2. CAUTION: o not open the top cover. There are no user serviceable parts inside the unit; leave
all servicing to qualified service personnel.
3. CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated.
Avoid direct exposure to beam.
4. REPRO UCTION OF LABEL: CAUTION LABEL, PLACE OUTSI E THE UNIT.
How to reset your unit
• Your preset adjustments will also be erased.
• If a disc is loaded, it will eject. Be careful not to
drop the disc.
How to forcibly e ect a disc
• If this does not work, reset your unit.
• Be careful not to drop the disc when it ejects.
Warning:
If you need to operate the unit while driving,
be sure to look ahead carefully or you may be
involved in a traffic accident.
Caution on volume setting:
iscs produce very little noise compared
with other sources. Lower the volume
before playing a disc to avoid damaging
the speakers by the sudden increase of the
output level.
EN02-05_KD-G425S[UN]f.indd 2EN02-05_KD-G425S[UN]f.indd 2 2/18/08 2:00:24 PM2/18/08 2:00:24 PM
ENGLISH
3
How to read this manual
• Button operations are mainly explained with
the illustrations in the table below.
• Some related tips and notes are explained in
“More about this unit” (see pages 15 – 1 ).
Press briefly.
Press repeatedly.
Press either
one.
Press and hold until your
desired response begins.
Press and hold both
buttons at the same time.
The following marks are used to indicate...
: Built-in CD player operations.
: External CD changer operations.
: Indicator displayed for the
corresponding operation.
How to use the MODE button
If you press MODE, the unit goes into functions
mode, then the number buttons and 5/∞
buttons work as different function buttons.
Ex.: When number button 2 works as
MO (monaural) button.
To use these buttons for their original
functions again after pressing MODE, wait for
5 seconds without pressing any of these buttons
until the functions mode is cleared or press
MODE again.
CONTENTS
Control panel ................................... 4
Getting started ................................. 5
Basic operations .................................................... 5
Radio operations .............................. 6
Disc operations .................................
Playing a disc in the unit ...................................... 7
Playing discs in the CD changer ............................ 7
Sound adjustments ........................... 10
General settings — PSM ................... 11
iPod operations ................................ 13
Other external component operations
... 14
Maintenance .................................... 15
More about this unit ......................... 15
Troubleshooting ............................... 1
Specifications ................................... 19
For safety...
• Do not raise the volume level too much, as
this will block outside sounds, making driving
dangerous.
• Stop the car before performing any
complicated operations.
Temperature inside the car...
If you have parked the car for a long time in hot
or cold weather, wait until the temperature in
the car becomes normal before operating the
unit.
Time countdown indicator
EN02-05_KD-G425S[UN]f.indd 3EN02-05_KD-G425S[UN]f.indd 3 2/18/08 2:00:37 PM2/18/08 2:00:37 PM
4
ENGLISH
1 4 /¢ buttons
2 (standby/on attenuator) button
3 5 (up) / ∞ (down) buttons
4 Loading slot
5 Display window
6 0 (eject) button
7 EQ (equalizer) button
8 SRC (source) button
9 AND button
p Control dial
q SEL (select) button
w MO (monaural) button
e SSM (Strong-station Sequential Memory)
button
r Number buttons
t RPT (repeat) button
y RND (random) button
u MODE button
i DISP (display) button
o (control panel release) button
Display window
; Disc information indicators—TAG (ID3
Tag), (folder), (track/file)
a Disc type indicators—WMA, MP3
s Playback source indicators—
CH: Lights up only when CD-CH is
selected as the playback source.
DISC: Lights up for the built-in CD player.
d Playback mode / item indicators—
RND (random), (disc), (folder),
RPT (repeat)
f LOUD (loudness) indicator
g EQ (equalizer) indicator
h Sound mode (C-EQ: custom equalizer)
indicators—JAZZ, CLASSIC, HIP HOP,
POPS, ROCK, USER
j Tr (track) indicator
k Source display / Volume level indicator
l Main display
/ Tuner reception indicators—ST (stereo),
MO (monaural)
Parts identification
Display window
Control panel
EN02-05_KD-G425S[UN]f.indd 4EN02-05_KD-G425S[UN]f.indd 4 2/21/08 4:10:45 PM2/21/08 4:10:45 PM
ENGLISH
5
Getting started
Basic operations
~ Turn on the power.
Ÿ
* You cannot select these sources if they
are not ready or not connected.
! For FM/AM tuner
⁄ Adjust the volume.
@ Adjust the sound as you want. (See
pages 10 and 11.)
To drop the volume in a
moment (ATT)
To restore the sound, press
it again.
To turn off the power
Volume level indicator
Volume level appears.
Basic settings
• See also “General settings — PSM” on pages
11 and 12.
1
2
1 Can eling the display
demonstrations
Select “DEM ,” then “DEM FF.”
2 Setting the lo k
Select “CL CK H” (hour), then adjust
the hour.
Select “CL CK M” (minute), then
adjust the minute.
3 Finish the pro edure.
To check the current clock
time when the power is
turned off
EN02-05_KD-G425S[UN]f.indd 5EN02-05_KD-G425S[UN]f.indd 5 2/18/08 2:00:47 PM2/18/08 2:00:47 PM
6
ENGLISH
Radio operations
~
Ÿ
! Start searching for a station.
When a station is received, searching
stops.
To stop searching, press the same button
again.
To tune in to a station manually
In step ! above...
1
2 Select a desired station frequency.
Lights up when receiving an FM stereo
broadcast with sufficient signal strength.
Selected band appears.
When an FM stereo broadcast is hard to
receive
Reception improves, but stereo effect will be
lost.
To restore the stereo effect, repeat the same
procedure. “MONO OFF appears and the MO
indicator goes off.
Storing stations in memory
You can preset six stations for each band.
FM station automatic presetting —
SSM (Strong-station Sequential
Memory)
1 Select the FM band (FM1 – FM3) you
ant to store into.
2
3
“SSM flashes, then disappears when
automatic presetting is over.
Local FM stations with the strongest signals are
searched and stored automatically in the FM
band.
Lights up when monaural mode is activated.
EN06-11_KD-G425S[UN]f.indd 6EN06-11_KD-G425S[UN]f.indd 6 2/18/08 11:14:18 AM2/18/08 11:14:18 AM
7
ENGLISH
Manual presetting
Ex.: Storing FM station of 92.5 MHz into preset
number 4 of the FM1 band.
1
2
3
Listening to a preset station
1
2 Select the preset station (1 – 6) you
ant.
or
To chec the other information while
listening to an FM or AM station
Disc operations
Playing a disc in the unit
All tracks will be played repeatedly until you
change the source or eject the disc.
To stop play and eject the
disc
Playing discs in the CD changer
All discs in the magazine will be played
repeatedly until you change the source.
• Ejecting the magazine will also stop playing.
~
* If you have changed the external input
setting to “EXT IN” (see page 12) you
cannot select the CD changer.
Ÿ Select a disc.
For disc number from 01 – 06:
For disc number from 07 – 12:
Cloc Ô Frequency
Preset number flashes for a while.
To be continued...
EN06-11_KD-G425S[UN]f.indd 7EN06-11_KD-G425S[UN]f.indd 7 2/18/08 11:14:20 AM2/18/08 11:14:20 AM
8
ENGLISH
To go to the next or previous folders (only for
MP3 or WMA discs)
For MP3 discs:
For WMA discs:
To locate a particular trac (for CD) or folder
(for MP3 or WMA discs) directly
To select a number from 01 – 06:
To select a number from 07 – 12:
• To use direct folder access on MP3/WMA
discs, it is required that folders are assigned
with 2-digit numbers at the beginning of their
folder names—01, 02, 03, and so on.
To select a particular track in a folder (for
MP3 or WMA discs):
About MP3 and WMA discs
MP3 and WMA “tracks (words “file and
“track are used interchangeably) are recorded
in “folders.
About the CD changer
It is recommended to use a JVC
MP3-compatible CD changer with your unit.
• You can also connect other CH-X series CD
changers (except CH-X99 and CH-X100).
These units are not compatible with MP3
discs.
• You cannot play any WMA disc in the CD
changer.
• You cannot use the KD-MK series CD
changers with this unit.
• Disc text information recorded in the CD
Text can be displayed when a JVC CD Text
compatible CD changer is connected.
To fast-forward or reverse the trac
To go to the next or previous trac s
EN06-11_KD-G425S[UN]f.indd 8EN06-11_KD-G425S[UN]f.indd 8 2/18/08 11:14:21 AM2/18/08 11:14:21 AM
9
ENGLISH
Other main functions
S ipping trac s quic ly during play
Only possible on JVC
MP3-compatible CD changer
• For MP3 or WMA discs, you can skip tracks
within the same folder.
Ex.: To select track 32 while playing tracks
whose number is a single digit (1 to 9)
1
2
Each time you press the button, you can
skip 10 tracks.
• After the last track, the first track will be
selected and vice versa.
3
Prohibiting disc ejection
You can lock a disc in the loading slot.
To cancel the prohibition, repeat the same
procedure.
Changing the display information
While playing an audio CD or a CD Text
While playing an MP3 or a WMA*2 disc
• When “TAG DISP” is set to “TAG ON”
(see page 12)
• When “TAG DISP” is set to “TAG OFF”
: Clock ith the current track number
: Elapsed playing time ith the current
track number
*1 If the current disc is an audio CD
“NO NAME” appears.
*2 Only for the built-in CD player.
*3 If an MP3/WMA file does not have Tag
information folder name and file name
appear. In this case the TAG indicator will
not light up.
EN06-11_KD-G425S[UN]f.indd 9EN06-11_KD-G425S[UN]f.indd 9 2/18/08 11:14:22 AM2/18/08 11:14:22 AM
10
ENGLISH
Selecting the playbac modes
You can use only one of the following playback
modes at a time.
1
2 Select your desired playback mode.
7 Repeat play
Mode Plays repeatedly
TRK RPT : The current track.
FLDR RPT*4 : All tracks of the current
folder.
DISC RPT*5 : All tracks of the current disc.
RPT OFF : Cancels.
7 Random play
Mode Plays at random
FLDR RND*4 : All tracks of the current
folder, then tracks of the next
folder and so on.
DISC RND : All tracks of the current disc.
MAG RND*5 : All tracks of the inserted
discs.
RND OFF : Cancels.
*4 Only while playing an MP3 or a WMA
disc.
*5 Only while playing discs in the CD
changer.
Sound adjustments
You can select a preset sound mode suitable to
the music genre (C-EQ: custom equalizer).
Indication (For)
BAS TRE LOUD
(bass) (treble) (loudness)
USER
(Flat sound) 00 00 OFF
ROCK
(Rock or disco music) +03 +01 ON
CLASSIC
(Classical music) +01 –02 OFF
POPS
(Light music) +04 +01 OFF
HIP HOP
(Funk or rap music) +02 00 ON
JAZZ
(Jazz music) +02 +03 OFF
Adjusting the sound
You can adjust the sound characteristics to your
preference.
1
Preset values
Ex. When “ROCK” is selected
EN06-11_KD-G425S[UN]f.indd 10EN06-11_KD-G425S[UN]f.indd 10 2/18/08 11:14:23 AM2/18/08 11:14:23 AM
Table of contents
Languages:
Other JVC Car Receiver manuals
JVC
JVC KD-AVX2 - DVD Player With LCD Monitor User manual
JVC
JVC KW-R900BT User manual
JVC
JVC KD-G801 User manual
JVC
JVC KD-X130M User manual
JVC
JVC KD-AR370J User manual
JVC
JVC KW-XR810 User manual
JVC
JVC KW-ADV792 - Arsenal 2-DIN 7" TouchScreen DVD/MP3/CD... User manual
JVC
JVC KS-FX801U User manual
JVC
JVC KD-S700GN User manual
JVC
JVC KD-R526 Guide
