Jole Armour C2005B User manual
INSTALLATION
IN A VEHICLE
IMPORTANT: KEEP THIS INSTRUCTION BOOKLET IN THE PLACE
PROVIDED AT THE BACK OF THE CHILD RESTRAINT
MODEL C2005B
instruction manual
IM-000726C
Armour
TM
USE WITH A
CHILD
IMPORTANT: KEEP THIS INSTRUCTION BOOKLET IN THE PLACE
PROVIDED AT THE BACK OF THE CHILD RESTRAINT
MODEL C2005B
instruction manual
Armour
TM
2
1
CONTENTS
WARNINGS ....................................................................................................... 3
ADDITIONAL WARNINGS .......................................................................... 4 & 5
Features ....................................................................................................... 6 & 7
REAR FACING INSTALLATION
Recline Angle ................................................................................................... 8
Installing the Restraint ............................................................................... 9 - 12
CHECKLIST .....................................................................................................13
FORWARD FACING INSTALLATION
Recline Angle ................................................................................................. 14
Installing the Restraint ............................................................................ 15 - 18
CHECKLIST .................................................................................................... 19
TOP TETHER WARNINGS .............................................................................. 20
Top Tether Features ........................................................................................ 21
Tether Anchorage Installation .................................................................. 22 - 24
Read the whole of these instructions carefully and if there is any doubt about the
method of installation, consult the child restraint manufacturer or agent, or a child
restraint tting station authorized by the relevant transport authority, or in New
Zealand an agent for the vehicle.
DO NOT USE THIS CHILD RESTRAINT UNTIL YOU HAVE READ AND UNDERSTOOD THE
INSTRUCTIONS IN THIS USER GUIDE AND IN YOUR VEHICLE OWNERS MANUAL
IMPORTANT:
Before installation and use of this child restraint check that it is
suitable for the size of your child.
Refer to the shoulder height label information on pages 9 and 19
of the USE Instructions.
Which way to face the restraint?
FRONT OF VEHICLE
Install facing the back of the vehicle
for babies and small toddlers.
Install facing the front of the vehicle
for bigger toddlers and small children.
Keep these Instructions for future reference.
Distributed by Nuna Baby Australia Pty Ltd
ACN: 642 240 140
Unit 1, 35 Lyn Parade Prestons, NSW Australia 2170
For after-sales & warranty service, contact: 1800 951 070
customerservice@nunababy.com.au
4
3
ADDITIONAL WARNINGSWARNINGS
GENERAL
WARNINGS
• Use the restraint exactly as shown in the instructions.
• Do not alter or modify this restraint.
• Repairs must only be done by the manufacturer or agent.
• Do not allow the restraint to come into contact with pol-
ishes, oils, bleach and other chemicals.
• Destroy the restraint if it has been in a severe crash, even if
no damage is visible.
• A loose harness or restraint is dangerous.
• Fit the restraint rmly to the car seat.
• DO NOT USE A REAR FACING CHILD RESTRAINT WHERE
AN AIRBAG IS FITTED IN FRONT OF THE SEATING POSI-
TION.
• DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR
This child restraint is not approved for use with any connec-
tors that connect to the car’s ISOFIX low anchorages.
NOTE: The warnings on this page are required by the Austra-
lian and New Zealand Standard AS/NZS 1754 for this type of
child restraint.
Other warnings specic to this child restraint will be found on
the following pages and throughout these instructions.
TO BE USED WITH A LAP-SASH/LAP ONLY SEAT BELT IN THE BACK OF MOST
CARS WITH FORWARD FACING SEATS.
• When installed rearward facing this restraint is 710 mm long, 500 mm wide and 515
mm high. Check the measurement between the front of the seat back of the rear seat
and all front seats in the car in which the restraint is intended to be used to ensure the
space available is sufcient.
• Do not use seat belt extenders if the car seat belt is not long enough to secure the
child restraint. If the vehicle seat belt is not long enough to secure the restraint seek
advice from a child restraint tter.
• Read carefully the whole of the instructions for the installation, and in the event of
doubt about the method of installation, consult the child restraint manufacturer or
agent, or a child restraint tting station authorized by the relevant transport authority, or
in New Zealand, consult the agent for the vehicle.
• Aftermarket accessories (i.e. items not provided in the box with the child restraint),
may not have been tested for use with this child restraint and if used, may lower the
level of protection offered possibly leading to injury or death.
• Any aftermarket accessory used should be compliant with AS/NZS 8005 (Accesso-
ries for child restraints for use in motor vehicles) and stated as suitable for use with this
child restraint.
515 mm
710 mm
500 mm 500 mm 490 mm
850 mm
620 mm
6
5
ADDITIONAL WARNINGS
Only install child restraint in a forward facing
vehicle seat. Never install in a seat that faces
the rear or the side of the vehicle.
Never install the Child Restraint in a seat
with a front airbag. DEATH or SERIOUS
INJURY may occur. Refer to your vehicle
Owners Manual for airbag warnings and
information.
IMPORTANT
Some vehicles have airbags at-
tached to the sash belt.
DO NOT install the restraint using
using this type of belt.
If in doubt refer to the vehicle own-
ers manual or an approved child
restraint tter.
Features
1
2
3
4
5
67
8
9
10
1 Headrest height Adjustor
2 Seat Cover
3 Harness QR Buckle
4 Harness Adjuster (under cover)
5 Harness Adjuster Webbing
6 Recline Angle Adjustment Handle
7 Crotch Pad
8 Shoulder Harness Strap
9 Shoulder Harness Strap Cover
10 Infant Body Support
8
REAR FACING INSTALLATION
7
Features
17 20
19 21
12 13 15
18
14
11 Top Tether Anchorage
12 Top Tether Snap Hook
13 Top Tether
14 Headrest Adjuster
15 Sash Belt Lock-off Device
16 Extra side impact protection
17 Instructions Storage
18 Base
19 Tether End Storage Bag
20 Seat Shell
21 Forward-Facing Vehicle Belt Slot
22 Rear-Facing Vehicle Belt Slot
22
11
Recline Angle
This restraint should be installed in the
rear seat.
Correct Recline Angle
When used rear facing the restraint must
always be fully reclined.
The white arrow on the shell must be
above the blue arrow on the base.
To Adjust:
1. Pull the release handle on the shell fully
forward.
2. Rotate the shell until the white arrow is
above the blue arrow.
IMPORTANT: A correct recline angle is
essential for your baby’s safety.
2
1
16
TR TIONS
SAT REAR
OF SEAT
4
5
INSTRUCTIONS
STOREDAT REAR
OFSEAT
10
9
REAR FACING INSTALLATION
REAR FACING INSTALLATION
Installation
Place the restraint on the vehicle seat rear
facing.
See page 5 for recommended positions in
the vehicle.
1. Pull the vehicle lap/sash belt out and
pass through the slot in the restraint.
Pass the vehicle belts over the restraint
seating surface and out the other side.
2. Engage the vehicle belt buckle. Lap
Belt
Sash Belt
REARWARD FACING
BELT PATH
Look for this label showing the cor-
rect path for the vehicle belts
“CLICK”
REARWARD
FACING BELT
PATH
2
IMPORTANT: the vehicle belts
must be fully down in the slots in
the side wings
1
5. Connect the top tether strap.
4
3
Installation
3. Pull the vehicle belts tight.
4. Ensure there are no twists in the belts.
5
NOTE: many vehicles have built-in top
tether connection points.
If your vehicle does not have these re-
fer to page 22 for information on tting
the anchorage supplied.
12
11
REAR FACING INSTALLATION
REAR FACING INSTALLATION
Installation
Increase tether tension by pulling web
out.
Reduce tension by pressing release but-
ton and pulling web out.
6
6. Store end of web in bag on back of
cover.
Tether Strap General Information
Always connect the snap hook securely to
the anchorage tting.
Adjust the tether tension until the
tether is pulled tight.
Do not adjust so tight that it lifts the
child restraint off the vehicle seat.
Straps must not be twisted.
Pull straps pulled tight.
Installation
Also refer to page 21 for more Top
Tether information.
PULL
Pull web
to increase
tension
PULL
PRESS
Press button
to reduce
tension
14
FORWARD FACING INSTALLATION
13
REAR FACING INSTALLATION
Checklist
Recline adjustment
- restraint must be fully
reclined
Tether Strap - check tension.
Ensure there are no twists in
the webbing. End of tether in
storage bag
Side Flaps - these can be
opened to provide extra
side impact protection.
Open on the car door side
only.
Sash Belt - fully down in the
side slots
Vehicle Belt - latched
securely and pulled tight
Tether Strap - securely
attached to anchorage
Recline Angle
Correct Recline Angle
When used forward facing the restraint
must always be correctly reclined. The
white arrow on the shell must be above
one of the yellow arrows on the base.
Select a position that gives the most com-
fort for your child.
To Adjust:
1. Pull the release handle on the shell fully
forward.
2. Rotate the shell until the white arrow is
above one of the yellow arrows.
IMPORTANT A correct recline angle is
essential for your child’s safety.
DO NOT use the position marked by
the blue arrow when the restraint is
forward facing.
2
1
REAR FACING ONLY FORWARD FACING ONLY
12 3 4 5
INSTRUCTIONS
STORED AT REAR
OF SEAT
16
15
FORWARD FACING INSTALLATION
FORWARD FACING INSTALLATION
Installation
See page 5 for recommended positions in
the vehicle.
Place the restraint on the vehicle seat
forward facing.
1. Pull the vehicle lap/sash belt out and
thread it through the vehicle belt slots at
the back of the child restraint.
2. Engage the vehicle belt buckle.
Look for this label showing the cor-
rect path for the vehicle belts
FORWARD-FACING
BELT PATH
“CLICK”
1
2
3. While pressing the child restraint down
firmly into the vehicle seat, pull the vehicle
sash belt until both lap and sash belts are
tight.
Look for this marking showing the cor-
rect path for the vehicle sash belts
FORWARD-FACING
BELT PATH
Installation
3
4
4. Secure the sash belt in the belt
lock off.
18
17
FORWARD FACING INSTALLATION
FORWARD FACING INSTALLATION
7
7. Connect the top tether strap.
8. Store end of web in bag on back
of cover. 8
Installation
6
5
5. Pull the vehicle belts tight.
6. Ensure there are no twists in the belts.
NOTE: many vehicles have built-in
top tether connection points. If your
vehicle does not have these refer to
page 22 for information on tting the
anchorage supplied.
Installation
Pull web to increase tension
Increase tether tension by pulling web
out.
Reduce tension by pressing release but-
ton and pulling web out.
Press button to reduce tension
Web pulled tight.
No twists in web.
Always connect the snap hook securely to
the anchorage tting.
Tether Strap General Information
Also refer to page 21 for more Top
Tether information.
Table of contents
Other Jole Car Seat manuals
Jole
Jole i-Bold User manual
Jole
Jole signature i-Gemm 3 User manual
Jole
Jole i-Snug 2 User manual
Jole
Jole i-Juva User manual
Jole
Jole i-Jemini User manual
Jole
Jole Spin 360 GTi User manual
Jole
Jole every stage fx User manual
Jole
Jole every stage R129 User manual
Jole
Jole Spin 360 GTi User manual
Jole
Jole trillo eco User manual
