Appropriate use
The device may only be used if it is in perfect condition, and then only for its intended purpose, in
compliance with all safety regulations, with an awareness of the potential risks, and according to the
operating manual. Any faults that may impair the safety must be rectified immediately.
The device and its components are only to be used for handling the liquids listed and the purpose
described. Using the machine for any other purpose would constitute inappropriate use. The manufacturer
is not responsible for any lass arising as a result of this, the risk for this is borne only by the operating
company
Organisational measures
This operating manual should always be kept readily available at the site of operation! Each person
concerned with the assembly, commissioning, maintenance and operation of the equipment must have
read and understood the entire operating manual. lt is essential that the type plate and the warning notices
attached to the device are observed, and maintained in a fully readable condition.
Qualified personnel
The operating, maintenance and assembly personnel must be appropriately qualified for their work. The
areas of responsibility, competences and supervision of the personnel must be precisely regulated by the
operating company. lf the personneI do not have the required knowledge, they must be trained and
instructed. The operating company must also ensure that the contents of the operating manual are properly
understood by the personnel.
Waters protection
The device has been designed to handle water hazardous substances. The regulations on the operating
place (e.g. Water Resources Act WHG, = ordinance on installations for handling of substances hazardous
to water VAwS) must be adhered to.
Hydraulics
Only persons with special knowledge and experience with hydraulic systems may carry out work on
hydraulic parts and equipment. All lines, hoses and screw joints should regularly be checked for leaks and
visible external damage. Any damage must be rectified immediately. Any oil spurting out can cause injuries
and fire.
The relevant safety regulations for the product must be followed when handling oils, greases or other
chemical substances!
Electric power
Work on the electrical equipment may only be carried out by a qualified electrician or by trained persons
under the guidance and supervision of a qualified electrician according to electro-technical guidelines.
Machine or system components, an which inspection, maintenance or repair work is to be carried out must
be de-energised.
2 Product description
The JP-16 is a double-action hand pump for pumping the media listed below from barrels, drums and
overground storage tanks. The M64 x 4 and G2" threads integrated in the housing enable simple assembly.
The JP-16 is available with two different suction pipes.
2.1 Product versions
JP-16 with suction pipe for immersion depths of 840 mm, fits to 200 l upright drums.
JP-16 with telescopic suction pipe for immersion depths between 470 and 925 mm.
JP-16 Kit with telescopic suction pipe for immersion depths of 470 mm to 925 mm with hose fitting, 1.5 m
DN 19 x 4, incl. outlet elbow AK 20 and bend protect spring (approved for use in areas at risk of explosion)
2.2 Permitted media
The JP-16 may be operated with the following media (hazard classes A I - III): Diesel, heating oil EL/L, fuels,
petroleum, antifreeze (undiluted),low viscosity mineral oils and RME.
