Jensen DV1628 User manual
1
1
DV1628
Owner's Manual
Thank you!
Thank you for choosing a JENSEN product. Weve tried to make the
instructions in this owner s manual clear and easy to follow. If you take a few
minutes to look through it you ll learn how to use all of the features of your
new JENSEN AM/FM/CD/DVD player for maximum enjoyment.
Installation:
Getting Started.
It is a good idea to read all of the instructions before you begin the
installation.
Tools and supplies needed:
• Flat and Phillips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio
• Electrical tape
• Crimping tool
• Volt meter/ Test light
• Crimp connections
• Speaker Requirements: Only connect speakers rated in the load
impedance range of 4 Ohms. Speakers with a load impedance less
than 4 Ohms could damage the unit
1. Prepare:
• Disconnect battery. Before you begin always disconnect the
battery s negative terminal
2. Mounting angle:
• Do not exceed a 30¡ mounting angle. Improper operation of the
unit could occur if the mounting angle is exceeded.
3. Removal of factory radio or DV1628:
30
Installation...........................................................................................1
Troubleshooting..................................................................................3
Operation.............................................................................................4
Specifications......................................................................................16
Warranty.............................................................................................17
2
2
14
13
12
11
10
Front L Speaker
Front R Speaker
Power Antenna
Gro nd
Rear R Speaker
Rear L Speaker
Center Speaker
Front L Speaker
Front R Speaker
12 V Pl s
Memory 12 V+
Right Rear speaker
Rear L Speaker
Center Speaker
( - )
( - )
( - )
( - )
( - )
( Trigger )
( - )
( + )
( + )
( + )
( + )
( + )
( + )
( Battery )
1
2
3
4
5
6
7
8
9
Bl e
Gray
White
Brown
Green
Violet
Black
Gray w/ Black stripe
White w/ Black stripe
Brown w/ Black stripe
Green w/ Black stripe
Violet w/ Black stripe
Red
Yellow
F nctionWire ColorPin #
• Use factory radio or DV1628 removal tools to remove the radio
from the DIN opening.
4. Wire Connections:
• See Figure #1
1
3
2
POWER/SPEAKER (5.1)
DV1628
FIGURE1
ANTENNA
SUB OUT (VARIABLE PRE-AMP)
LEFT STEREO OUT (FIXED PRE-AMP)
RIGHT STEREO OUT (FIXED PRE-AMP)
VIDEO IN
LEFT STEREO IN AUX IN
RIGHT STEREO IN
VIDEO 1 OUT
VIDEO 2 OUT
LEFT STEREO OUT
SMART MODE (FIXED PRE-AMP)
RIGHT STEREO OUT
POWER/SPEAKER (5.1)
CDC
EXTERNAL MUTE KEY IN
3
3
Troubleshooting:
PROBLEM CAUSE CORRECTIVE
ACTION
Does not
operate,
display does
not light.
No power to
Yellow wire,
No power to
Red
Check power
connection with
M lti-meter. Check
f se for contin ity
with M lti-meter.
Inline f se
blown Replace f se.
No power to
nit
Inline f se
blown
Check and/or
replace f se.
No A dio to
speakers
Speaker
harness not
connected
Check speaker
wires, connect
harness.
Blows f ses
Power wire
shorting to
gro nd
Make s re wire is
not pinched.
Speaker
wires shorting
to gro nd
Make s re wire is
not pinched.
Incorrect
f se/ rating
too small
Replace with
proper f se.
CD/DVD skips
Mo nting
angle is too
great or not
sec re.
Check proper
mo nting angle
and/or mo nting
strap for sec re
mo nting.
Dirty laser. Use CD/DVD
cleaning kit.
ERROR
DISPLAY
CDP and CDC
ERR1 appears
on display
Mechanism
Error Press Reset b tton.
ERR6 appears
on display Sled Error Press Reset b tton.
CDP ONLY
ERR2 appears
on display Servo Error Press Reset b tton.
ERR7 appears
on display
TOC reading
error
Check disc - disc
may be dirty or
pside down. If not
press the reset
b tton.
CDC ONLY
ERR2 appears
on display
TOC reading
error
Check disc - disc
may be dirty or
pside down. If not
press the reset
b tton.
ERR3 appears
on display
Temperat re
error Press Reset b tton.
ERR7 appears
on display
Disc and
Servo error Press Reset b tton.
4
4
AS/PS
CLK DSP SMART
MOODE SEL
PWR/ILL
327 10
BAND/MENU
11 15 29 12 26
6
D.UP5
D.DN
2423
20
22
21
25 9
ENT
MUTE
OPEN
1
DOLBY
6713 2
1
4
RND
3
RPT
2
SCN
SOURCE
4
5
LED 28
AUDIO
Operation:
1. Front Panel / Remote Control
• Controls
1. Power Button: Press the Power button to turn the unit
on. Press and hold for 2 seconds to turn the unit off. Press the
Power button when the unit is on to select 4 different
brightness settings for the panel.
2. SEL: Selects the audio effect. Press the select
button to choose the desired Bass Treble or speaker setting.
Use the VOL+ and VOL- button to adjust the levels.
3. Open: Opens the front panel to allow access to
the CD/DVD slot.
4. Source: Press the source button to toggle
between Radio CD/DVD CDC/DVDC and Aux mode.
(NOTE: CDC/DVDC mode is active only if a changer is
connected. This source will be skipped if a changer is not
installed.) Press and hold the Source button for 2 seconds to
mute the rear speaker and subwoofer. Press and hold for 2
more seconds to re-activate the rear speakers and subwoofer.
5. Enter / Mute: Press the Enter button to select the
highlighted menu bar. Press and hold the Enter button for 2
seconds to mute the speakers.
6. / : Press the to fast forward the
track. Press the to rewind the track.
7. / Press the to skip to the next
track, press the to skip to the previo s track.
8. Slow/Zoom: Activate the slow forward or zoom
f nction.
9. / Pa se/Play b tton. Press once to
pa se the CD/DVD, press again to res me play.
10. Band/Menu: In radio mode, press the
Band/Men b tton to change from AM/FM bands. In
DVD mode, press the Band/Men b tton to activate
the DVD men .
11. /AS/PS: In DVD mode press the /AS/PS to
stop the DVD. In Radio mode press the /AS/PS to
access the Automatic memory storing and preset scanning
mode. Press and hold the button for 2 seconds to scan
through the 6 preset stations.
12. Vol + / Vol - Controls the volume level press the
Vol+ button to increase the volume and the Vol- button to
decrease the volume.
13. Audio/DSP: Chooses the audio soundtrack and the
preset EQ. DVD mode: Press and hold for 2 seconds to
change the language soundtrack. Feature is activated only
if the DVD is recorded with multi language soundtracks.
CD Mode: Press and hold for 2 seconds to change from
Stereo Mono left and Mono right mode. Press once to
5
5
115
2
4
5
6
7
9
10
12
13
16
14
17
18
11
29
8
19
CLK
SCN
RND D.DN D.UP
AS/PS
DSP
RPT
toggle between EQ settings each press will toggle from
Flat Classic Pop Rock to off.
14. Angle: Allows the viewer to view the DVD at
different angles if the DVD is recorded with this feature.
Press the angle button while the DVD is Stopped. Then
press the / to adj st the brightness and contrast
levels.
15. Disp/Clock: Press to display the Clock or Disc
information. Setting the clock: Press and hold the
Disp/Clock button until the display begins to flash. Press
the #6 / to adj st the ho rs or min tes.
16. Subtitle: Changes the subtitles language on the
DVD if the DVD is recorded with this feature.
17. Title: Displays the title that is stored on the
CD/DVD.
18. Setup: Displays the setup menu.
19. 0-9: Numeric key buttons.
20. M1-M6: Selects the Radio stations stored in the
memory.
21. Scan: Scans the entire disc and plays the first
10 seconds of each track.
22. Repeat: Replays the current disc or track.
23. Random: Plays the disc in random.
24. Disc- / Disc+: Chooses the CD/DVD ( only if CDC or
DVDC is connected.
25. Reset: Reset button press only if the unit is
locked up. This resets the unit to the factory settings.
26. Remote IR: Receiving sensor for the remote control.
27. Display: Main unit display
28. Eject: Eject the CD or DVD
29. Smart Mode / Disc: Press the Smart mode button to put the
unit into Smart mode. See Smart mode function. In DVD
changer mode ( Only if DVDC is connected ) press the button
to enter the Disc Menu.
6
6
• Front Panel removal:
a. Press the open button #3.
b. Press the middle release button and pull the panel straight
out.
• Radio Removal
a. Grab the grooves of the front frame with fingers and pull.
b. Insert the supplied levers inside the grooves on the right
and left hand side of the radio. Pull the levers out as
shown.
2. MP3 Compatible:
This unit supports the following MP3 CD formats:
• Joliet
• Romeo
• ISO9660
3. Smart Mode function:
The Smart Mode feature allows the user to listen to two different audio
sources at the same time. One source can be selected through the speaker
system while the DVD can be listened to through an external audio source.
Ex. IR transmitter for wireless headphones.
• Smart mode is activated only in DVD mode.
• Press Source button #4 to enter DVD mode.
• Press Smart button #29 to activate Smart Mode
• Press Smart button #29 again to deactivate Smart Mode.
• When Smart Mode is active Smart Mode will be displayed in the
top right corner of the Radio display.
• Pressing the Source button #4 while in Smart mode will change the
Audio source being played on the speakers. The Smart Mode
audio to the external audio source will remain DVD.
1
3
2
7
7
Initial Setup:
Press the Setup #18 button to enter the Setup mode.
Press the Down #7 key to highlight the desired Setup screen.
Press the Enter button to select the desired Setup screen.
General Setup:
General Setup Cont.:
TV Display:
Selects the appropriate TV aspect ratio 4:3 or 16:9
• Normal / PS
o Pan and Scan for 4:3 aspect ratio. If selected while using
a 16:9 TV the left and right edges will be cut off.
• Normal / LB
o Letterbox style for 4:# aspect ratio. If connected to a
wide-screen TV black bands will appear on the top and
bottom of the screen.
• WIDE
o Select when using a 16:9 formatted TV
TV Type:
• Multi
o Automatically selects the DVD format when inserted
• NTSC
o Select when using a DVD formatted as NTSC
• PAL
o Select when using a DVD formatted as PAL
GENERAL SETUP
SPEAKER SETUP
AUDIO SETUP
PREFERENCES
EXIT SETUP
SETUP MENU - - MAIN PAGE
TV DISPLAY NORMAL/PS
TV TYPE NORMAL/LB
WIDE PIC MODE
ANGLE MARK
OSD LANG
CAPTIONS
MAIN PAGE
-- GENERAL PAGE --
TV DISPLAY
MULTI
TV TYPE
PAL
PIC MODE
ANGLE MARK
OSD LANG
CAPTIONS
MAIN PAGE
-- GENERAL PAGE --
NTSC
8
8
PIC Mode:
• Auto
o PIC mode automatically selects the setting depending on
the DVD.
• Film
o Suitable for film or progressive source.
• Video
o Select Video for best image resolution.
• Smart
o When the TV output is progressive additional vertical
processing is applied.
• SSmart
o When the TV output is progressive pixel based motion
adaptive de-interlacing is activated.
Angle Mark:
Changes the viewing angle of multi-angle DVD s. If the DVD does not
have this feature the viewing angle will not have any effect.
TV DISPLAY
TV TYPE
FILM
VIDEO
SMART
PIC MODE
SSMART
ANGLE MARK
OSD LANG
CAPTIONS
MAIN PAGE
-- GENERAL PAGE --
AUTO
TV DISPLAY
TV TYPE
PIC MODE
ANGLE MARK
OSD LANG
CAPTIONS
MAIN PAGE
-- GENERAL PAGE --
ON
OFF
9
9
OSD Language Setup:
Selects the Language that the OSD will be displayed in.
Closed Captioning:
Turns the Closed Captioning on and off.
Speaker Setup:
GENERAL SETUP
SPEAKER SETUP
AUDIO SETUP
PREFERENCES
EXIT SETUP
SETUP MENU - - MAIN PAGE
Down Mix:
• LT/RT
o Activates Dolby Surround compatible output.
• STEREO
o Activate simple Stereo mode.
• OFF
o Turns stereo mode off to enable Downmix
TV DISPLAY ENGLISH
TV TYPE FRENCH
PIC MODE
ANGLE MARK
OSD LANG
CAPTIONS
MAIN PAGE
-- GENERAL PAGE --
GERMAN
SPANISH
TV DISPLAY
TV TYPE
PIC MODE
ANGLE MARK
OSD LANG
CAPTIONS
MAIN PAGE
-- GENERAL PAGE --
ON
OFF
10
10
Speaker selection:
Highlight the desired speaker selection then the ON / OFF
Selection to turn the desired speaker ON or OFF. Individual speaker
selection is active only in Downmix mode.
Select Rear Delay and / or CNTR Delay to control the delay of the audio
signal to the Rear and Center speakers.
DOWNMIX
CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
BASS
MAIN PAGE
ON
OFF
15MS
9MS
3MS
OFF
DOWNMIX
CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
BASS
MAIN PAGE
5MS
3MS
1MS
OFF
DOWNMIX
CENTER
REAR
SUBWOOFER
CNTR DELAY
REAR DELAY
TEST TONE
BASS
MAIN PAGE
Table of contents
Other Jensen Car Stereo System manuals
Jensen
Jensen JDM118BT User manual
Jensen
Jensen VM9026 User manual
Jensen
Jensen CH1002 User manual
Jensen
Jensen CM9521 User manual
Jensen
Jensen MS30BT User manual
Jensen
Jensen Phase Linear UV10 User manual
Jensen
Jensen JCD3006 User manual
Jensen
Jensen VR182 User manual
Jensen
Jensen CD3720XM User manual
Jensen
Jensen PADIN5 User manual
Jensen
Jensen CD6112 - CD Receiver User manual
Jensen
Jensen CD3720XM User manual
Jensen
Jensen AWM970 User manual
Jensen
Jensen CR225X User manual
Jensen
Jensen AWM970 User manual
Jensen
Jensen CD2620 User manual
Jensen
Jensen VX7021 User manual
Jensen
Jensen MP1516 User manual
Jensen
Jensen JWM10A User manual
Jensen
Jensen JWM40 Installation instructions
