USER MANUAL v.1.1
JEFFANDRM30-110E
30"HIGH VELOCITY DRUM FAN • 123W • 110V~50Hz
www.jeffersontools.com
4
SAFETY GUIDELINES
Please read and ensure that you understand all of the operating instructions, safety precautions and warnings in this
Instruction Manual before operating or maintaining this equipment. An accident can often be avoided by recognizing
a potentially hazardous situation before it occurs, and by observing appropriate safety procedures. Hazards that
must be avoided to prevent bodily injury or machine damage are identied by warnings on the equipment and in this
Instruction Manual. Never use this equipment or modify it in any way that has not been specically recommended by the
manufacturer. Contact Jefferson Tools for all information relating to the repair and maintenance of this equipment. Contact
a qualied electrician for advice on any issues relating to electrical safety in your working environment.
Electrical Safety
Ensure that you check the equipment thoroughly to ensure it is safe and t for
purpose before each use. It is important that you inspect all plugs, sockets, power
cables and electrical ttings for wear and damage and repair or replace any defective
components. The risk of electric shock can be minimised by the correct use of the
appropriate electrical safety devices.
• We recommend that you t a Residual Current Circuit Breaker (RCCB) in the main distribution board
and that a Residual Current Device (RCD) is used when operating this equipment.
• The Electricity at Work Act 1989 includes legislation that places legal implications on employers
to ensure the safety of electrical devices in the workplace. The regulations dictate that all portable
equipment must be inspected regularly and tested to ensure that it is safe for use. 'Portable
equipment' means any electrical item that can be moved and this is often referred to as Portable
Appliance Testing (PAT). PAT testing should be carried out regularly on this equipment by trained,
authorised personnel, as required by the legislation.
• The Health and Safety at Work Act 1974 states that it is the responsibility of the owner of electrical
appliances to ensure that both the equipment and working environments are maintained to ensure
safe operation at all times.
• Check that all equipment cables are secure, correctly insulated, free from damage, and protected
against short circuit and overload before connecting to the power supply. Do not use worn or
damaged cables, plugs, sockets or other ttings.
• Ensure that the power supply matches voltage requirements specied on the equipment and that the plug is wired correctly and tted with
the correct fuse.
• If the electrical fuse blows, ensure it is replaced by an identical type of fuse with the same rating.
• Never pull or manoeuvre this equipment into position using the power cable.
• Ensure the power cable is kept away from heat, oil and sharp edges.
• We recommend that the equipment is connected directly to the power supply without the use of extension leads as the resulting voltage drop
can reduce motor performance.
• Always disconnect the equipment from the power source before servicing, inspecting, maintaining, cleaning, replacing or checking any parts.
General Equipment Safety
• Do not touch the fan until it has been disconnected from the mains power supply.
• Always disconnect the fan from the power supply when moving it from one location to another.
• Ensure fan is stood on a rm, level surface during operation.
• The air ow generated from this equipment is powerful. Before use ensure that there is nothing nearby that can be damaged or displaced by
the stream of air. Be careful that there are no naked ames or embers that can be blown by the air ow, even remotely.
• Keep the fan clean and maintained in good condition. For motor service contact an authorised service agent.
• Use only Jefferson approved replacement parts when repairing this equipment. Unapproved parts may be dangerous, and will invalidate your
warranty. Speak to your nearest Jefferson dealer for advice.
• Never operate the fan in environments containing explosive or ammable gases, fumes or other hazardous substances.
• Never allow the fan to be placed on top of the power cable.
• Do not insert any objects through the fan guard.
• Do not cover the fan when in use.
• Never immerse the fan in water or any other liquid.
• Never allow children to operate the fan - keep children and animals away from the equipment during operation.
• Never operate the fan in a position where it can be knocked over or off a surface, or where the lead may cause a person to trip.
• This equipment is not suitable for outdoor use.
• Do not modify the speed control or attempt to t any additional external speed control devices to the fan.
• When not in use place the fan in its original box, or otherwise cover, to protect from dust and store in a safe, dry, childproof environment.
• Always keep the user manual with the equipment for future reference.
