Intermec 6651 User manual

1. Remove the keyboard hard cover. Place your fingers on the left and

right tabs (slightly jutting out), then gently lift up the keyboard hard cover

and remove.

"NOTE: Keep the keyboard hard cover, it is reusable.

Replace the cover the same way you removed it.

2. Press the POWER (On/Off) key to turn on the 6651.

3. Adjust the display contrast by tapping on the brightness icons

located on the lower right side of the display, or press the Fn key while

holding down the ← or → keys on the keyboard.

4.Follow the instructions and adjust the screen calibration, time zone set-

ting, time and date, and your name and address.

Power off the unit by pressing the POWER (On/Off) key for one second.

Intermec is a trademark of Intermec Technologies Corporation.

PN: 962-054-027

Revision A

May 2000

*962054007*

P/N 962-054-027 Revision A

6651 PEN COMPUTER

QUICK START GUIDE

Packing List

Quick Start Guide P/N:962–054–027

AC Adapter/Charger P/N:871–012–020

Serial Cable P/N:871–012–060

Battery Pack P/N:871–012–010

Pen Stylus P/N:871–012–040

Keyboard Cover P/N:871–012–050

AC Power Cable P/N:851–036–010

Installing and Charging the Batteries

1. Install the main battery, then the backup batteries.

Set the device bottom side up on a cushioned surface and then open the

display by lifting the center latch.

2. Slide the lock switches to the unlocked position.

3.Align the main battery pack with the rails of the 6651 and push it

straight in.

4.Slide the lock switched the locked position. If the lock switches cannot

be moved, pull out the battery pack, then reinsert it.

"NOTE: Both lock switches must be locked or the 6651 won’t

power on.

5.Close the display.

6.Remove the screws from the backup battery cover.

7.Lift up to remove the backup battery cover.

8.Install two CR2032 backup batteries with the plus (+) side up.

Slide the battery to the left and press down. Avoid touching the other

parts.

9.Replace the backup battery cover, and attach the screws.

10. Plug the DC power plug from AC adapter/charger into the DC input

jack on the edge of the 6651. Connect the AC power cord adapter end

into the AC adapter/charger first, then insert the AC plug into a wall outlet.

After a few seconds, charging starts and the orange LED on the 6651

starts blinking.

Charging time is approximately 2.5 hours. When charging is completed,

the LED stops blinking, but stays lit.

11. When charging is completed, disconnect the AC adapter and the

power cord.

"NOTE: Charging can be performed while the device is in

use.

"NOTE: Be sure to disconnect the DC power plug from the

6651 before opening the display fully, or you could

damage the DC power plug or the DC input jack.

Setting up the Device

Open the display.

Place your fingers on the tabs to the left and right of the 6651 center

cover latch, and open the display.

Other manuals for 6651

Table of contents

Other Intermec PDA manuals

Intermec

Intermec Trakker Antares 2475 User manual

Intermec

Intermec 5023 User manual

Intermec

Intermec CK71 User manual

Intermec

Intermec 6210 User manual

Intermec

Intermec Janus 2010 Installation and operating instructions

Intermec

Intermec Janus JR2020 Manual

Intermec

Intermec CN70e RFID User manual

Intermec

Intermec CK71 User manual

Intermec

Intermec CK30 User manual

Intermec

Intermec Trakker Antares 2455 User manual

Intermec

Intermec CV60 User manual

Intermec

Intermec NORAND 6642 User manual

Intermec

Intermec 5055 User manual

Intermec

Intermec JANUS JG2010 User manual

Intermec

Intermec 751G Manual

Intermec

Intermec PEN*KEY 6620 Use and care manual

Intermec

Intermec PEN*KEY 6200 User manual

Intermec

Intermec 5023 Installation and operating instructions

Intermec

Intermec CK30 User manual

Intermec

Intermec Trakker T2090 User manual

Intermec

Intermec CT60 Manual

Intermec

Intermec M90 Series User manual

Intermec

Intermec CN51 User manual

Intermec

Intermec 6110 User manual

Popular PDA manuals by other brands

SPOT

SPOT SPOT user guide

Palm

Palm handheld Getting started guide

Winmate

Winmate E500QK user guide

Getac

Getac PS236 Specifications

Sharp

Sharp CE-1600P Operation manual

HTC

HTC PHAR100 user manual

Mindeo

Mindeo M40 Reference manual

Acer

Acer n30 manual

ASCOM

ASCOM 9D24 EX brochure

Unitech

Unitech PA520BTNF user manual

HandHeld

HandHeld Nautiz X3 user manual

Casio

Casio PALM manual

Sharp

Sharp TM-20 Software guide

Atid

Atid AT870 quick guide

AML

AML M7225 user guide

Audiovox

Audiovox Maestro Quick start card

Casio

Casio PV-750 Plus Function guide

Unitech

Unitech PT630 Programming reference guide