Intel NUC7CJYHN User manual
User Guide for NUC7CJYHN, NUC7PJYHN
1
Intel® NUC Kit NUC7CJYHN
Intel® NUC Kit NUC7PJYHN
User Guide
User Guide for NUC7CJYHN, NUC7PJYHN
2
Before You Begin
CAUTIONS
The procedures in this user guide assume familiarity with the general terminology associated with
personal computers and with the safety practices and regulatory compliance required for using
and modifying electronic equipment.
Disconnect the computer from its power source and from any telecommunications link or network before
performing any of the procedures described in this guide. Failure to disconnect power,
telecommunications links, or networks before you open the computer or perform any procedures can
result in personal injury or equipment damage. Some circuitry on the board can continue to operate
even though the front panel power button is off.
Follow these guidelines before you begin:
Always follow the steps in each procedure in the correct order.
Set up a log to record information about your computer, such as model, serial numbers,
installed options, and configuration information.
Electrostatic discharge (ESD) can damage components. Perform the procedures described in
this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam
pad. If such a station is not available, you can provide some ESD protection by wearing an
antistatic wrist strap and attaching it to a metal part of the computer chassis.
Installation Precautions
When you install and test the Intel NUC, observe all warnings and cautions in the installation
instructions.
To avoid injury, be careful of:
Sharp pins on connectors
Sharp pins on circuit boards
Rough edges and sharp corners on the chassis
Hot components (such as SSDs, processors, voltage regulators, and heat sinks)
Damage to wires that could cause a short circuit
Observe all warnings and cautions that instruct you to refer computer servicing to qualified
technical personnel.
Observe Safety and Regulatory Requirements
If you do not follow these instructions, you increase your safety risk and the possibility of
noncompliance with regional laws and regulations.
User Guide for NUC7CJYHN, NUC7PJYHN
3
This guide tells you how to:
•
Install and remove memory
•
Install a 2.5” drive
•
Install a VESA mount bracket
•
Connect power
•
Install an operating system
•
Install the latest device drivers and software
Open the Intel NUC Chassis
To open the Intel NUC chassis, follow these steps:
1. With a screwdriver unscrew the four corner screws on the bottom cover of the chassis and lift the
cover.
Installing and Removing Memory
Intel NUC Kits NUC7CJYHN and NUC7PJYHN have two 260-pin DDR4 SO-DIMM sockets. Be sure to
select memory modules that meet these requirements:
1.2V low voltage memory
2400 MHz SO-DIMMs
Non-ECC
Find compatible memory modules in the Intel® Product Compatibility Tool:
NUC7CJYHN
NUC7PJYHN
User Guide for NUC7CJYHN, NUC7PJYHN
4
NOTE If you plan to install only one memory module, install it in the lower memory
socket.
To install memory, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer and
disconnect the power cord.
3. Remove the computer’s bottom chassis cover.
4. Align the small space at the bottom edge of the memory module with the key in the socket.
5. Insert the bottom edge of the module at a 45 degree angle into the socket (A).
6. When the module is inserted, push down on the outer edge of module until the retaining
clips snap into place (B). Make sure the clips are firmly in place (C).
To remove a SO-DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer and disconnect
the power cord.
3. Remove the computer’s bottom chassis cover.
4. Gently spread the retaining clips at each end of the memory socket, which causes the module to
pop out of the socket (C).
5. Holding the module by the edges, lift it away from the socket, and store it in an anti-static package.
6. Reinstall and reconnect any parts you removed or disconnected to reach the memory sockets.
7. Replace the computer’s cover and reconnect the power cord.
Install a 2.5” SSD or Hard Drive
The Intel NUC Kits NUC7CJYH[x] and NUC7PJYH[x] support a 2.5” Solid State Drive (SSD) or Hard Disk
Drive (HDD).
Find compatible 2.5” drives in the Intel® Product Compatibility Tool:
NUC7CJYHN
NUC7PJYHN
User Guide for NUC7CJYHN, NUC7PJYHN
5
1. Slide the new 2.5” drive into the drive bay, ensuring the SATA connectors are fully seated into the
connectors of the SATA daughter card (A).
2. Secure the drive into the drive bay with the two small silver screws that were included in the box (B).
Set the drive bay bracket down inside the chassis (C).
User Guide for NUC7CJYHN, NUC7PJYHN
6
Close the Chassis
After all components have been installed, close the Intel NUC chassis (using an electric or battery
operated screwdriver can damage the NUC).
Attach and Use the VESA Bracket (Optional)
Follow these instructions to attach and use the VESA mount bracket:
1. Using the four small black screws that were included in the box, attach the VESA bracket to the
back of the monitor or TV.
User Guide for NUC7CJYHN, NUC7PJYHN
7
2. Attach the two slightly larger black screws to the bottom chassis cover of the Intel NUC.
3. Slide the Intel NUC onto the VESA mount bracket.
User Guide for NUC7CJYHN, NUC7PJYHN
8
Connect Power
Each Intel NUC model includes either a region-specific AC power cord or no AC power cord (only the power
adapter).
Product codes
Power cord type
BOXNUC7CJYHN,
BOXNUC7PJYHN
No power cord included.
An AC power cord needs to be
purchased
separately. Power cords are available at many Internet sites for use in
multiple countries. The connector on the power adapter is a C5 type
connector.
BOXNUC7CJYHN1
,
BOXNUC7PJYHN1
US power cord included.
BOXNUC7CJYHN2,
BOXNUC7PJYHN2,
EU power cord included.
BOXNUC7CJYHN3
UK power cord included.
BOXNUC7CJYHN4
Australia/New Zealand power cord included.
BOXNUC7CJYHN5
India power cord included.
Connect AC power.
User Guide for NUC7CJYHN, NUC7PJYHN
9
Install an Operating System
Refer to Supported Operating Systems for a list of Intel-validated Windows* operating systems, as well
as versions of Linux that have been reported as compatible by Intel NUC owners.
Refer to Operating System Installation for system requirements and installation steps.
Install the Latest Device Drivers and Software
Here are the options for keeping device drivers current:
Allow the Intel® Driver & Support Assistant (Intel® DSA) to detect out-of-date drivers
Manually download drivers, BIOS, and software from Download Center:
o NUC7CJYHN
o NUC7PJYHN
The following device drivers and software are available.
Intel® Chipset Device Software
Intel® UHD Graphics
Intel® Wireless
Intel® Bluetooth
Intel® Trusted Execution Engine
Intel® Serial I/O
Intel® GNA Scoring Accelerator
Realtek* Gigabit Ethernet
Realtek* Card Reader
ITE Tech* Consumer Infrared
Intel® Software Guard Extensions
This manual suits for next models
10
Table of contents
Other Intel Computer Hardware manuals
Intel
Intel CD1M3128MK Configuration guide
Intel
Intel DP43TF - CARACTERISTIQUES TECHNIQUES User manual
Intel
Intel G22856-001 Installation manual
Intel
Intel DZ77GAL-70K Quick setup guide
Intel
Intel P9500 - Core 2 Duo 2.53 GHz 6M L2 Cache 1066MHz FSB Socket P Mobile... User manual
Intel
Intel LF80537GF0484M - Cpu Core 2 Duo T7400 2.16Ghz Fsb667Mhz 4Mb Fcpga6... User manual
Intel
Intel BX80637I53570K User manual
Intel
Intel 845 DESIGN Guide
Intel
Intel i960 Series Guide
Intel
Intel 925 - Pentium D 925 3.0GHz 800MHz 4MB-Cache Socket 775... User manual
Intel
Intel Agilex Series User manual
Intel
Intel RMSP3AD16OF Installation manual
Intel
Intel 520J - Pentium 4 2.80GHz 800MHz 1MB Socket 775... User manual
Intel
Intel ESM-2740 User manual
Intel
Intel 82496 CACHE CONTROLLER User manual
Intel
Intel SRCU42E - Ultra320 SCSI PCI Express X8 RAID Storage... Installation manual
Intel
Intel RES2SV240 Installation manual
Intel
Intel 2ND GENERATION CORE PROCESSOR FAMILY DESKTOP - THERMAL MECHANICAL S AND DESIGN GUIDELINES... User manual
Intel
Intel BX80562QX6700 - Core 2 Extreme 2.66 GHz... User manual
Intel
Intel RS2WC080 Installation manual
Popular Computer Hardware manuals by other brands
EMC2
EMC2 VNX Series Hardware Information Guide
Panasonic
Panasonic DV0PM20105 Operation manual
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 user manual
Gigabyte
Gigabyte B660M DS3H AX DDR4 user manual
Raidon
Raidon iT2300 Quick installation guide
National Instruments
National Instruments PXI-8186 user manual
