10
26. REMOVE UNDER-SEAT WOOFER (STEP 6)
Some or all of the plastic clips (1) may still be stuck to the vehicle,
remove them and put them back on the Door Sill cover trim. A
panel removal pry tool (2) works well.
27. REMOVE UNDER-SEAT WOOFER (STEP 7)
Pull up the carpet to access the USW enclosure. Use a 10mm
socket to remove the two nuts (1). Detach the wire bundle clip
attached to the top corner of the USW enclosure (2).
Remove the enclosure by lifting up the inner edge rst, then lift-
ing up and towards the middle of the vehicle. Unplug the wiring/
connector by depressing the locking tab in the connector. Remove
the USW enclosure from the vehicle.
28. REMOVE UNDER-SEAT WOOFER (STEP 8)
Place the USW enclosure on a workbench or other solid work sur-
face. Remove the four Torx T-10 screws (1). Starting at the stron-
gest point (2) carefully pry the woofer from the enclosure.
REPEAT THE PREVIOUS 8 STEPS FOR THE DRIVER SIDE
29. INSTALL THE IASS-8S WOOFERS IN THE USW ENCLOSURE
Use the four #6 x 1.25” Pan Head Screws to mount the woofer to
the enclosure (these are the longer, thinner screws with a round-
ed head - don’t confuse them with the cover screws which are a
little thicker and shorter and have a at head).
30. RE-INSTALL THE USW ENCLOSURE
Re-install the enclosure in the vehicle. It may take a little wig-
gling to get the open end (the side towards the door sill) to slide
into its slot. Make sure all wiring is run clear. Replace the two
nuts removed previously and tighten with a 10mm socket.
Connect the USW plug to the factory connector (see Next Step if
connector does not t). Replace the carpet.
A.
INSTALLATION
