Insane Audio JK1001 Assembly instructions
JK1001
2007 to 2014 Jeep Wrangler
Installation Tips
V1.1
Table of Contents
I. Introduction
II. Safety precautions
III. Opening the dash
IV. Removing the stock radio
V. Installing the JK1001
VI. Tips & Tricks
I. Introduction
Congratulations! If you are reading this, then you are most likely
about to install the JK1001 in your 2007 to 2014 Jeep Wrangler.
Don’t worry – installation should be a breeze and this document
is intended to give you a few helpful hints and tips.
This should go with out saying, but PLEASE USE YOUR NEW
JK1001 RESPONSIBLY. Never attempt to operate the unit or view
videos while driving. When in doubt, pull over first then do
what you need to do. When driving, always keep both hands on
the wheel and your eyes on the road!
Should you run into problems or need any additional assistance,
and we will endeavor to get back to you as soon as possible.
You can also find user manuals, and more at:
www.insanejeepaudio.com
Enjoy your new JK1001!
II. Safety Precautions
•Disconnect the negative battery terminal before beginning this
installation!
•Don’t run with scissors
•If at any time during the installation you encounter a wild bear,
you should avoid poking it with a stick. They don’t like that.
III. Opening the Dash
1. On the top of your dash, there is a rubber insert that can be
pried open with a plastic dash tool or a small screwdriver. That
will reveal a single 7mm bolt that needs to be removed.
2. Next, pry open the center switch panel. Be careful not to
scratch the plastic!
3. Remove the single 7mm bolt behind the switch panel.
4. Pry off the dash panel just below
the steering wheel. Start with the
top corners. Once it is off, you’ll see
two 7mm bolts at the top corners.
Guess what? Remove them too.
5. Now you can pop the
entire upper dash panel
off. It’s held in place with
pressure clips.
IV. Removing the stock radio
There are four 7mm bolts on the face of your stock radio that need
to be removed then the whole thing will slide out. Disconnect the
antenna and the old wiring harness from the factory harness.
Once your old radio has been freed from your dash, it can now be
used as a handy doorstop or paperweight.
Note that you’ll also want to remove the plastic connector from the
end of your factory radio antenna. To do this, pry the red clip up
on both sides, then remove the entire connector.
V. Installing the JK1001
•Connect the wiring harness, the GPS antenna, the AM/FM radio
adapter, the iPOD cable and USB cable to the rear of your JK1001 and
simply slide it into the dash.
•You’ll most likely want to route
the iPOD cable and USB cable to
the glove box.
•The GPS antenna has a
magnetic mount and is best
placed on the top of the JK1001.
•If you’re installing a rearview
camera, aux input or connecting
an aftermarket stereo system
just use the included accessory
harness.
Other manuals for JK1001
2
Table of contents
Other Insane Audio Car Receiver manuals
