IKEA LACKERBIT User manual
GB
DE
FR
IT
LÄCKERBIT
ENGLISH 4
DEUTSCH 15
FRANÇAIS 27
ITALIANO 46
4
ENGLISH
Contents
Safety information 4
Product description 7
Care and cleaning 8
What to do if... 10
Technical data 11
Environment concerns 12
IKEA GUARANTEE 12
Safety information
For your safety and correct operation of the appliance,
read this manual carefully before installation and use.
Always keep these instructions with the appliance even if
you move or sell it. Users must fully know the operation
and safety features of the appliance.
The wire connection has to be done by specialized
technician.
Recommendations and suggestions
• The manufacturer will not be held liable for any damages
resulting from incorrect or improper installation.
• The minimum safety distance between the cooker top
and the extractor hood is: for electrical hob 500mm and
for gas hob 650mm.
• If the instructions for installation for the gas hob specify
a greater distance, this must be respected.
• Check that the mains voltage corresponds to that indi-
cated on the rating plate fixed to the inside of the hood.
• For Class I appliances, check that the domestic power
supply guarantees adequate earthing.
• If the extractor is used in conjunction with non-electrical
appliances (e.g. gas burning appliances), a sufficient de-
gree of aeration must be guaranteed in the room in order
to prevent the backflow of exhaust gas. When the cooker
hood is used in conjunction with appliances supplied with
energy other than electric, the negative pressure in the
room must not exceed 0,04 mbar to prevent fumes being
drawn back into the room by the cooker hood.
• If the supply cord is damaged, it must be replaced from
5
ENGLISH
the manufacturer or its service agent.
• Connect the plug to a socket complying with current reg-
ulations, located in an accessible place.
• With regards to the technical and safety measures to be
adopted for fume discharging it is important to closely
follow the regulations provided by the local authorities.
• WARNING: Before installing the Hood, remove the pro-
tective films (white and transparent).
• Use only screws and small parts in support of the hood.
Warning: Failure to install the screws or fixing device in
accordance with these instructions may result in electri-
cal hazards.
• Connect the hood to the power net by using a bipolar
switch having a contact gap of at least 3 mm.
• Do not flambè under the range hood; risk of fire.
• This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concern-
ing use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appli-
ance. Cleaning and user maintenance shall not be made
by children without supervision.
• Children should be supervised to ensure that they do not
play with the appliance.
Accessible parts may become hot when used with cook-
ing appliances.
• Clean and/or replace the Filters after the specified time
period (Fire hazard).
6
ENGLISH
Use
• Switch off or unplug the appliance
from the mains supply before
carrying out any maintenance
work.
• The extractor hood has been
designed exclusively for domestic
use to eliminate kitchen smells.
• Never use the hood for purposes
other than for which it has been
designed.
• Never leave high naked flames
under the hood when it is in
operation.
• Adjust the flame intensity to direct
it onto the bottom of the pan
only, making sure that it does not
engulf the sides.
• Deep fat fryers must be
continuously monitored during
use: overheated oil can burst into
flames.
Care and cleaning
• Activated charcoal filter these
filters are not washable and
cannot be regenerated, and must
be replaced approximately every
4 months of operation, or more
frequently with heavy usage.
• Grease filters the filters must
be cleaned every 2 months of
operation, or more frequently for
particularly heavy usage, and can
be washed in a dishwasher.
• Clean the hood using a damp cloth
and a neutral liquid detergent.
7
ENGLISH
Product description
Perimeter panel
Hood body
Lighting
Grease filter
Control panel
Lights
To turn the lights ON,
press the dial and release
it so that it pops out of
its housing.
To turn the lights OFF,
push the dial back
inwards, returning it to
the OFF position
Motor
Press the dial and release
it so that it pops out of
its housing, then turn the
dial counterclockwise to
select one of the available
suction speeds.
Control Panel
8
ENGLISH
Care and cleaning
Switch off or unplug the appliance
from the mains supply before carrying
out any maintenance work.
IMPORTANT Clean the hood using a
damp cloth and a neutral liquid deter-
gent.
Charcoal Filter
These filters are not washable and
cannot be regenerated, and must be
replaced approximately every 4 months
of operation, or more frequently with
heavy usage.
Grease Filters
Clean or replace the filters continuously
according to below time intervals, to
maintain good performance of the hood
and to prevent a potential fire hazard,
caused by excessive grease build-up.
The grease filters must be cleaned
every 2 months of operation, or more
frequently for particularly heavy usage,
and can be washed in a dishwasher.
9
ENGLISH
Opening Perimeter Panel
Open the Panel by pulling it. Clean the
outside with a damp cloth and neutral
detergent. Clean the inside using a
damp cloth and neutral detergent; do
not use wet cloths or sponges, or jets of
water; do not use abrasive substances.
[
Replacing the lamps
Remove the snap-on lamp cover by lev-
ering it from under the metal ring, sup-
porting it with one hand. Remove the
halogen lamp from the lamp holder by
pulling gently. Replace the lamp with a
new one of the same type, making sure
that you insert the two pins properly
into the housings on the lamp holder.
Replace the snap-on lamp cover. 20 W -
12V halogen light. Connection type: G4,
Length 30mm.
Lamp Power (W) Socket Voltage (V) Dimension
(mm) ILCOS Code
20 G4 12 33 x 9 HSG/C/UB-20-12-G4
10
ENGLISH
What to do if...
PROBLEM POSSIBLE CAUSE SOLUTION
Appliance not stable. The appliance is not correctly
installed. Follow the Installation instruction
enclosed to the appliance.
Appliance is not in horizontal
position. The appliance is not correctly
installed. Follow the Installation instruction
enclosed to the appliance.
Performance in terms of oil
capture arent satisfying. Oil and grease on metal lters. Follow the cleaning frequency of
lters as described in the user
manual.
Appliance doesn't work. The appliance is not correctly
connected.
Verify that the main cable is con-
nected to the motor group or the
plug is connected to the socket.
The lamp is not working. The lamp is not correctly xed. Verify that the lamp is screwed
properly to the lampholder.
The lamp is not working. The lamp is faulty. Replace the lamp bulb.
If there is a fault, first try to find
a solution to the problem yourself.
If you cannot find a solution to the
problem yourself, contact an author-
ized service center.
If you operated the appliance
wrongly, or the installation was
not carried out according to the
Assembly instructions, the visit from
the After Sales Service technician
may not take place free of charge,
even during the warranty period.
Other manuals for LACKERBIT
1
Table of contents
Other IKEA Ventilation Hood manuals
IKEA
IKEA UNDERVERK User manual
IKEA
IKEA UNDERVERK User manual
IKEA
IKEA W10177447B Product information sheet
IKEA
IKEA IH8432WS0 Product information sheet
IKEA
IKEA KULINARISK User manual
IKEA
IKEA BALANSERAD User manual
IKEA
IKEA IHW7303WS0 User manual
IKEA
IKEA LI25DA User manual
IKEA
IKEA LUFTIG User manual
IKEA
IKEA SVÄVANDE User manual
IKEA
IKEA FOLJANDE User manual
IKEA
IKEA KULINARISK 304.432.04 User manual
IKEA
IKEA SVÄVANDE User manual
IKEA
IKEA Range Hood Operating manual
IKEA
IKEA VINSTGIVANDE User manual
IKEA
IKEA MOLNIGT User manual
IKEA
IKEA BF570 Instruction Manual
IKEA
IKEA LUFTIG User manual
IKEA
IKEA LAGAN User manual
IKEA
IKEA UTDRAG User manual
