G3 How to use power
Handheld Page 9 of 9
7How to use power
Press the Power button to turn on the device.
Note that please wait until the LED on after turning the device on.
* When you insert/replace your battery, you should wait about 10 seconds to press the power button.
7.1 -Power Off
Method-1. Press and hold the power button until the instant message pop up appears. When the
message, “Slide to shut down your PC” shows up and then please slide the screen toward to the bottom
to shut down the device.
Method-2. Click or touch the “Shut down” of the power menu in the left-bottom of the screen to shut
down the device.
Method-3. Click or touch the “Hibernate” of the power menu in the left bottom of the screen to shut
down the device.
*Hibernate : The system appears to be off. Power consumption is reduced to the lowest level to
preserve system state.
Note that you should wait until Power LED is off for replacing the battery.
7.2 -Reset
Click or touch the “Restart” of the power menu in the left bottom of the screen to restart your device.
7.3 -Hard Reset
Case 1 : If your device isn’t running well even after you restart the device, press and hold the power
button about 10 seconds to perform the Hard Reset.
** Caution : We do not recommend “Hard Reset” and also do not guarantee it. It may cause the
system problem after performing Hard Reset.
Case 2 : If it does not turn on like a brick under sufficient battery, please press and hold the camera
button and F1 button at the same time about 7 seconds and then press the power button to turn it on.
