ICStation GY20971-1 User manual
1
ICStation Bluetooth Audio Amplifier Electronic Kit https://www.icstation.com/
1. Description:
The sound quality of this Bluetooth kit is excellent and it comes with sound spectrum
rhythm lights, making it a truly unique and fun product. Perfect for home, school or
hobbyists for soldering practice.
2.Parameter:
1>.Work Voltage:DC 5V
2>.Work Temperature:-25℃~85℃
3>.PCB Board Size:65x49mm
4>.Shell Size:70x70x80mm
5>.Speaker Power:4ohm 3W
3.Circuit and Diagram:
2
4.Components Layout
3
5.Components List:
6. Installation Steps:
Step1: Install the 6pcs color ring resistor. 12K resistors at R1, R7; 330ohm at R3,
10K at R4, R5; 33K at R6.
The resistors are regardless of direction. The color ring readings of the color ring resistors
are shown in the figure below. If the resistance value cannot be determined, then please
use a multi-meter to measure it, and install each color ring resistor according to the
component list.
4
5
Step 2: Install SMD integrated circuit HT6872.
Note: there is a small pit on the chip when installing, and the direction is consistent with
the figure below
Step 3: Install Ceramic/monolithic capacitors.
Monolithic capacitors have no distinction between positive and negative poles.
6
Step 4: Install the Bluetooth module.
Place the components of the Bluetooth module face up on the circuit board.
Step 5: Install electrolytic capacitors at C2, C3, C4, C5, C6, C7.
Note: The long leg of the electrolytic capacitor is the positive pole, and the short leg is the
negative pole.
On the corresponding installation position of the circuit board, the side of the hollow
semicircle is connected to the positive pole, and the side of the semicircle with shadow is
connected to the negative pole.
7
Step 6: Install blue and white adjustable resistors.
The blue and white adjustable resistor RP2 is used to control the display range of the LED
volume column.
8
Step 7:Install IC KA2284
KA2822 is an LED volume level indicator circuit. Facing the KA2284, there is a literal, the
leftmost pin is the first pin, and at the installation position of the circuit board, the side with
the square pad on the side is connected to the first pin (as shown in below picture).
Step 8: Install in-line LEDs.
Note: The long leg of the light-emitting diode is the positive pole, and the short leg is the
negative pole. The color is based on personal preference, and there is no fixed format.
At the installation position on the circuit, the flat side is connected to the negative pole of
the LED.
9
Step 9: Install the 3F07 audio stand.
The audio socket is used as the audio signal input port. When the Bluetooth signal is not
connected, the audio signal can be input from the following port to make the speaker
sound.
Step 10: Install the Dial Potentiometer.
The dial potentiometer is used to adjust the speaker volume.
10
Step 11: Installing the key switch.
Key switch for power switch
Step 12: Install Tact Switch
The touch switch is used for Bluetooth module functions, such as volume, song selection
and other functions
Other ICStation Amplifier manuals
