IBM THINKPAD T30 - User manual

Thank you for purchasing the IBM ThinkPad T Series computer. Match the items on this list with the items in the box. If any item is

missing or damaged, please contact your place of purchase.

hComputer hBattery pack Notes:

1. Some models may contain additional

items that are not listed.

2. For some models, a diskette drive is

included in the package.

3. Your computer features IBM

Disk-to-Disk recovery. Everything

needed to recover factory-installed files

and applications is on your hard disk.

Disk-to-Disk recovery eliminates the

need for a Recovery CD. For more

information, see “Recovering

preinstalled software” in the Service

and Troubleshooting Guide.

hPower cord hBooks:

vSetup Guide

vService and

Troubleshooting

Guide

vManual package

for Microsoft

Windows

hAC adapter hTelephone cable

Setting up your computer

1. Installing the battery.

a) Align the side of the battery with the side of the battery compartment in the

computer 1; then gently push the battery into the compartment 2.

b) Slide the battery latch to lock it.

2. Connecting to a power source.

Connect the ac adapter to the computer’s power jack (at the rear of the computer).

Make the connections in the order shown.

3. Turning on the system.

a) Open the computer display. Press the latches 1 and open the display 2. Then

position the display so that it is convenient for viewing.

b) Press the power switch1.

4. Using the UltraNav

™

Your ThinkPad computer comes with the UltraNav pointing device. The UltraNav consists of the TrackPoint

and the touch

pad, each of which is itself a pointing device with basic functions and extended functions.

You can use both the TrackPoint and the touch pad together. You can also configure the pointing devices to your preferred

settings. For example, you can use the TrackPoint and the touch pad for pointing with their extended functions. Or you can

use the TrackPoint for its pointing function only, and the touch pad for its extended functions only, or vice versa.

For more information about the UltraNav, press the ThinkPad button to open Access ThinkPad, your on-board help system.

Note: Some models have the TrackPoint only, without a touch pad and its buttons.

5. Using the volume control.

You can adjust the sound level produced by the built-in speakers by using the

following three buttons:

1 Volume down

2 Volume up

3 Mute

If you mute the sound and then turn off your computer, the sound will

remain muted when you turn on your computer again. To turn on the

sound, press the Volume up or Volume down button.

When you press one of these buttons, the volume indicator appears on the screen

for a few seconds. For more information on volume control, see the on-board help

system, Access ThinkPad.

6. Setting up Windows.

Your computer comes with a Microsoft Windows 2000 or XP operating system. After turning on your computer, follow the

instructions on the screen to set up the operating system. This procedure takes approximately 30 minutes, and your computer

restarts several times.

7. Using Access ThinkPad.

Whenever you have a question about your computer, or wish to view IBM Web

sites, simply press the ThinkPad button to open Access ThinkPad.

Access ThinkPad is the comprehensive, on-board help and information center for

your computer. It travels with you, eliminating the need to carry reference manuals.

Find information about your ThinkPad computer and its features by using the

search function. For direct access to help and support, tips from other mobile users,

and information about accessories, software, and upgrades, visit the IBM Web site.

Installing memory

Increasing memory capacity is an effective way to make programs run faster. You can increase the amount of memory in

your computer by installing a PC2100 double data rate (DDR) synchronous dynamic random access memory (SDRM)

unbuffered small outline dual inline memory module (SO-DIMM), available as an option, in the memory slot on the

bottom of the computer. SO-DIMMs with different capacities are available.

Note: Use only a PC2100 DDR SDRAM unbuffered SO-DIMM in your computer. If you install a SO-DIMM that is not supported by

your computer, the computer beeps, and the system does not start. You can purchase the appropriate memory option from your IBM

reseller or IBM marketing representative.

Attention: Before you start installing a module, touch a metal table or a grounded metal object. This action reduces any static

electricity from your body. The static electricity could damage the SO-DIMM.

To install the SO-DIMM, do the following:

1. Turn off the computer; then disconnect the ac adapter and all cables from the

computer.

2. Close the computer display, and turn it over.

3. Remove the battery.

4. Loosen the screw on the memory slot cover; then remove the cover.

If the SO-DIMM is already in the memory slot, remove it to make room for the

new one by pressing out on the latches on both edges of the socket at the same

time. Be sure to save it for future use.

5. Find the notch on the side of the SO-DIMM.

Attention: To avoid damaging the SO-DIMM, do not touch its contact edge.

6. With the notched end of the SO-DIMM toward the right side of the socket, insert

the SO-DIMM into the socket at an angle of about 20 degrees 1; then press it

firmly 2.

7. Pivot the SO-DIMM until it snaps into place.

Make sure that the card is firmly fixed in the slot and does not move easily.

8. Replace the memory slot cover over the memory slot, aligning the back side of the cover first; then tighten the screw.

Attention: When you have added or upgraded a memory card, do not use your computer until you have closed the memory

slot cover. Never use the computer with the cover open.

9. Put the battery back in place and turn the computer over again.

To make sure that the SO-DIMM is installed correctly, do as follows:

1. Turn the computer on.

2. While the “Press F1 for IBM BIOS Setup Utility”message is displayed at the lower-left area of the screen, press the F1 key. The

IBM BIOS Setup Utility screen appears. The “Installed memory”item shows the total amount of memory installed in your

computer. For example, if you install a 256-MB SO-DIMM into a computer whose built-in memory is 256 MB, the quantity

shown in “Installed memory”should be 512 MB.

Your name:

_________________________

Company name:

_________________________

Model number:

_________________________

Serial number:

_________________________

Company or reseller service:

_________________________

IBM service Web site:

_________________________

IBM service number:

_________________________

Trademarks

The following terms are trademarks of the IBM Corporation in the

United States or other countries or both:

IBM

ThinkPad

TrackPoint

UltraNav

Microsoft and Windows are trademarks of Microsoft Corporation

in the United States and/or other countries.

Notes:

This manual suits for next models

Table of contents

Other IBM Laptop manuals

Popular Laptop manuals by other brands

HP ze2401xt - Pavilion Notebook PC datasheet

Velocity

Velocity NoteMagix M10 quick start guide

Dell

Dell Alienware 17 R2 Service manual

Toshiba

Toshiba A105-S2236 Specifications

HP ENVY 17 Maintenance and service guide

Winbook

Winbook LM user guide

Dell

Dell Inspiron 1464 Setup guide

Dell

Dell Inspiron 15R 5537 quick start guide

HP PROBOOK 4520S Maintenance and service guide

Dell

Dell Latitude ATG D620 Service manual

Sony

Sony VAIO PCG-FX270 Specifications

Dell

Dell Latitude 7310 Service manual

Dell

Dell Precision GU806 Quick reference guide

Sony

Sony VAIO PCG-R505JLK user guide

Lenovo

Lenovo THINKPAD X32 Setup guide

HP Compaq tc4200 Software guide

Toshiba

Toshiba mini NB300 specification

Lenovo

Lenovo ThinkPad X201 Tablet Manual