HUUM CLIFF User manual
CLIFF
info@huumsauna.com www.huumsauna.com
ELECTRIC SAUNA HEATER 3–13
POÊLE ÉLECTRIQUE 15-25
800827
3
CLIFF
ELECTRIC SAUNA HEATER
Installation and operation manual
NB! The following instructions for electrical works must be carried out
by a certied electrician.
NB! We recommend a specialist to lay the stones on the heater.
NB! This appliance is not intended for use by persons (including chil-
dren)with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
NB! Children should be supervised to ensure that they do not play with
the appliance.
NB! The installation instructions for appliances for public saunas that
do not have a timer shall state that a pilot lamp showing that the heater
is switched on is to be installed in the aendant’s room.
-
requirements for sauna heating appliances and infrared cabins”.
• electric heater;
• installation and operation manual for the electric heater.
•
NB! The electric heater requires a control panel and stones.
4
THINGS TO CHECK BEFORE INSTALLATION
•
•
• The suitable output of the heater will be determined based on
•
•
4
6 X 40
6 X 40
4
A A
B
H
3.5 *
Min 47.3/
1200 mm
34.4
875 mm
5
Table 1 Output
Room Amps
ACircuit breaker
AWire size
3.5
3.5 3
3
6 6 3
3
30
9 9 3
3
50
3
3
50 6
Table 2 Output
Room Amps
ACircuit breaker
AWire size
3.5
3
3
6 3
3
30
9 3
3
3
3
50
Table 3 A BHWidth/
Depth Weight
3.5
50 mm
33 lb
6
50 mm
9
6
INSTALLATION
Positioning the heater
• The heater must be positioned in such a way that there is a safe
of the heater. See Table 3.
•
situations could emerge during the heating process.
•
•
the heater.
Connecting the heater to the power supply
• A method to disconnect all poles from the mains (a circuit
controller.
•
• power supply.
•
•
•
•
NB! It is forbidden to use a non-heat-resistant cable with PVC isolation
as the power cable. The joint box must be waterproof and it must be
located up to 20 in (50 cm) from the oor.
7
•
•
circuit diagram.
•
•
L1 L2 L2L1
240V 2~
208V 2~
240V 2~
208V 2~
CLIFF 3.5 kW
CLIFF 6 kW
CLIFF 9 kW
CLIFF 10.5 kW
Fiing the stones
•
process.
•
•
•
of the sauna.
•
heater.
•
•
responsibility.
ATTENTION! Too sparsely lled stone container causes re hazard!
NB! We recommend a specialist to lay the stones on the heater.
8
Removing the ribs of the heater
threaded rod by 5 mm.
Push the props between the ribs of the heater.
3. Release the rib from both ends.
and then the left.
NB! Pull the rib away from the heater without using force or turning the
rib – avoid bending the tenons!
A A
1.
2.
3.
4.
fashion.
be
9
First-time use of the sauna heater
to be lower than the standard. The reason for that is the moisture
seeped into the insulating layer during storage in the warehouse and
transportation.
Controlling the heater
the control panel’s producer.
Product can be used only with controlunit with timer function.
allowed.
Guard rails
•
•
ATTENTION! IF THE HEATER IS INSTALLED CLOSER TO FLAMMABLE
CONSTRUCTIONS THAN AT THE DISTANCE OF THE MINIMALREQUIRED
PROTECTION BELT IT MAY CAUSE A FIRE HAZARD!
10
SAUNA ROOM
Wall materials and insulating the sauna room
the electric heater with a regular output.
The following sauna wall and ceiling construction is considered
to be suiciently insulated:
•
• the construction is damp proofed with taped aluminium paper or
•
boarding
• -
•
ceiling panels at the upper part of the wall panelling.
ATTENTION! Insulating the heat barrier has to be approved by the re
inspector. Insulating ues in use is forbidden!
NB! Covering the walls or oor with light protective material, for example,
mineral tiles that are installed directly on the surface of the walls or ceiling
might cause the dangerous overheating of the wall or ceiling material.
Other manuals for CLIFF
2
This manual suits for next models
4
Table of contents
Languages:
Other HUUM Electric Heater manuals
