Hunter 33116 User manual

1
©2010 Hunter Fan Company
Evaporative Evaporative Evaporative
Form# 44062-01
20101209
©2010 Hunter Fan Co.
Humidier
Owner’s Guide
Model
33116
33118
English

At A Glance
Warnings and Introduction ................................................................................ 3
Know Your Humidier ....................................................................................... 4
Using Your Humidier
Initial Setup and Operation ................................................................................ 5
Maintenance
Cleaning and Storage ....................................................................................... 6
Humidier Assistance
Troubleshooting ................................................................................................ 8
Service Parts and Support ................................................................................. 9
Treatments ...................................................................................................... 10
Warranty
3 Year Guarantee ........................................................................................... 11
Table of Contents

3
©2010 Hunter Fan Company
At A Glance
Warnings and Introduction
1
Important Safety Instructions: Read all instructions before using this humidier.
• This humidier may not work properly on an uneven surface. ALWAYS place this humidier on a rm, level and water
resistant surface. ALWAYS place the humidier at least six (6) inches away from walls and heat sources such as stoves,
radiators or heaters.
• ALWAYS place the humidier in an area that is out of the reach of children.
• Before using the humidier, extend the cord and inspect for any sign of damage. DO NOT use the product if the cord
has been damaged.
• This product has a polarized plug as a safety feature (one blade is wider than the other). This plug will t into a polarized
outlet only one way. If the plug does not fully t into the outlet, reverse the plug. If it still does not t, contact a qualied
electrician. DO NOT attempt to defeat or override this feature.
• ALWAYS unplug and empty the humidier when it is not in operation or while it is being cleaned.
• DO NOT tilt or move the humidier while it is in operation. Never move the humidier while there is water in the tank.
Empty the water tank, turn the unit off, and unplug the unit before moving.
• In addition to routine maintenance which may be required, this humidier requires seasonal cleaning. Refer to and follow
the instructions for “Cleaning and Storage” on page 6.
• This unit was designed to be used with distilled and/or tap water. DO NOT add scented oils, perfumes or fragrance
additives to the water.
• Never ll the humidier tank with hot water. Always use clean, cool tap water.
• The warnings and cautions in this owner’s manual cannot cover all situations, or events that may arise. Common sense
and caution should be used by the operator in using this device to prevent injury or accident.
READ AND SAVE THESE INSTRUCTIONS
The Hunter® Evaporative Humidier has a unique, patented design with several innovative features:
• Built-in Antimicrobial Properties – We use Microban® on many of the plastic parts and wick. This helps inhibit the growth
of bacteria, mold and fungi that may affect these parts.
NOTE: This product contains antimicrobial properties which are built-in to inhibit the growth of bacteria which may affect
the plastic and wick in the humidier. These properties do not extend to the water, humidied air, or users. Conduct routine
cleaning and maintenance based upon use and individual conditions.
• No White Dust – The Hunter® Evaporative Humidier produces no white dust that can settle on furniture or be inhaled.
NOTE: You may notice mineral deposits accumulating in the tank Tray. This is normal and does not affect performance. If
you would like to clean these deposits away, please see “Cleaning and Storage” on page 6.

444062-01 • 12/09/2010
At A Glance
Know Your Humidifier 1
Water Tank
Tank Cap
Wick
Water Tray
Housing
Tank Handle
O
Control Knob
Vapor Pad Tray
Tank Handle
Exhaust Grill
Niteglo™
Nitelight

5
©2010 Hunter Fan Company
Using Your Humidifier
Initial Setup and Operation
2
Figure 1.
Initial Setup
1. Remove the Hunter® Evaporative Humidier from its packaging.
2. Place the humidier on a hard, at, water resistant surface. Always place the
humidier at least six (6) inches away from walls and sources of heat.
3. Make sure the power/speed control is in the ‘OFF’ position.
NOTE: The power/speed control should always be off before unplugging the
humidier, moving the humidier, or relling the water tank.
4. Lift the housing to ensure the wick is properly seated, resting on the bottom of
the water tray and not tilted or otherwise out of position. Figure 1. Place the
housing back on the water tray.
5. Grasp the water tank by the tank handle and remove it from the water tray.
Figure 2.
6. Turn the water tank upside-down and remove the tank cap by turning counter-
clockwise. Figure 3.
7. Fill the water tank with clean, cool water and return the tank cap to its position.
Tighten it by turning clockwise, and return the water tank to the water tray.
8. Plug the humidier’s power cord into a standard household power outlet.
9. Turn the power/speed control to your desired humidier fan speed.
Wick
Figure 3.
Figure 2.
Tank Handle
O
Figure 4.
Control
Knob
Operation
Off Turns the unit off.
Low: Extends the time between rells by running the fan on low.
Lowest noise setting recommended for nighttime use.
High: Average rell rate and optimal for day use. Minimal noise
level.
To turn on or off the Niteglo™ Nitelight, just press the Niteglo™ Button on the top
of the unit.
See Figure 4. for a display of your controls.
If you choose to use vapor pads in your humidier:
Remove 1 vapor pad from the packaging, and insert it lengthwise into the vapor
pad tray on the top of the exhaust grill. Vapor pads will typically last for 24 hours
before needing replacement.
Vapor Pad Tray
Niteglo™
Nitelight

644062-01 • 12/09/2010
Maintenance
Cleaning and Storage 3
Many regions have hard water with high concentrations of minerals. When water
evaporates from the Hunter® evaporative humidier, minerals may be left behind.
These minerals can form a hard white scale which can be removed by following
the cleaning instructions. The frequency of cleaning due to mineral build up can
vary depending upon the quality of water you may have. Refer to “Know Your
Humidier” on page 4 for gure names.
1. Turn the humidier off and unplug the unit.
2. Lift the main housing and remove the water dispersion tray and the wick. The
motor is attached to the main housing. Do not place the motor near water. Do
not use a wet towel on the motor or motor housing as electrical shock may
occur.
3. Replace the humidier’s wick every 4 weeks or when it has turned brown.
4. Remove the water tank from the base and empty any water that is left in the
tank. Soak the base in a mixture of one (1) gallon of water and eight (8)
ounces of vinegar for 20 minutes. The base is dishwasher safe.
5. After soaking, wipe the base with a soft cloth or sponge to remove any
mineral build up. Rinse with clean water several times. If you are planning on
storing the humidier, be sure the base is completely dry.
6. Fill the water tank with one (1) gallon of water and eight ounces of undiluted
white vinegar. Figure 5. Replace the tank cap and shake the tank vigorously
until all interior surfaces of the tank have been exposed to the water/vinegar
mixture.
7. Empty the tank of the water/vinegar mixture. Rinse it several times with clean
water and then replace the tank cap. If you are planning to store the humidier,
dry it inside and out, leaving the cap off to allow the tank to completely dry.
Continue to clean the other parts of your humidier.
8. Wipe the surfaces of the main housing with a soft cloth. Figure 6.
9. Once all the parts are clean, reassemble the humidier, and follow ”Initial
Setup and Operation” on page 5 to continue use. If you are storing the
humidier, make sure all parts are completely dry before reassembling, and
storing in a dry location.
1 gallon Water
8oz. Vinegar
Solution
Figure 5.
Figure 6.

7
©2010 Hunter Fan Company
Maintenance
Replacing the Wick
3
NOTE: The humidier’s wick is made of paper and is NOT washable.
Over time, minerals in your water will build up in the humidier’s wick, degrading
its ability to absorb water and reducing the humidier’s output. Therefore, you
should replace the humidier’s wick every season, depending on the hardness of
your water.
1. Turn the humidier off and unplug the unit.
2. Lift the main housing, remove it from the base, and set it aside. Figure 7.
3. Grasp the humidier wick, hold it over the base, and squeeze the water from
it. Figure 8. This will keep water from dripping onto your oor. You may also
want to wrap the wick in a towel to keep it from dripping while you transport
it to disposal.
4. Replace the old wick with a new Hunter humidier wick. New wicks are
available at your local Hunter retailer or at www.hunterfan.com.
5. Ensure the wick is properly seated, resting on the bottom of the base and not
tilted or otherwise out of position.
6. Return the main housing to its position on the base. Make certain the main
housing is properly seated on the base.
7. Plug the humidier’s power cord into a standard household power outlet and
turn the power/speed control to your desired setting.
Figure 7.
Figure 8.

844062-01 • 12/09/2010
Humidifier Assistance
Troubleshooting 4
Problem:
Excessive noise.
Solution:
1. Check the water tank to make sure it is properly seated on the base.
2. Check the water tank to make sure there are no bubbles when the water tank
is full and running. If there are bubbles, turn the unit OFF until the bubbling
stops. When the bubbling has stopped, set the unit to the desired speed.
Problem:
Humidier not working.
Solution:
1. Make sure the power knob is not set to OFF and the unit is plugged into a
working wall outlet.
Problem:
Mineral build-up on the water tank or water tray.
Solution:
1. Refer to the section “Cleaning and Storage” on page 6.
Problem:
Humidity output and water usage decreased.
Solution:
1. Check the power knob to make sure it is set to the desired speed.
2. Check the water tank to make sure there are no bubbles when the water tank
is full and running. If there are bubbles, turn the unit OFF until the bubbling
stops. When the bubbling has stopped, set the unit to the desired speed.
3. Clean any components that have mineral build-up. Refer to the section
“Cleaning and Storage” on page 6.

9
©2010 Hunter Fan Company
Humidifier Assistance
Service Parts and Support
4
Service Parts
Part # Part Name Part Replace
89754-01-326 Water Tank
G0841-01-679 Tank Assembly
Cap
31948 Wick 1 per month or
as needed
99940-01-679 Water Tray
If you need any assistance with setup, operation, or parts for your new Hunter
Humidier, please call us, our technical support staff is ready to help!
USA: 1-888-830-1326
Canada: 1-866-268-1936
Hours of operation are from 7:00 am to 7:00 pm Monday - Friday and 8:00 am
to 5:00 pm on Saturday, Central Time. You may also contact us over the Internet
at www.hunterfan.com or register your product at www.hunterfan.
com/register and select your product under product registration.
Technical Support

10 44062-01 • 12/09/2010
Model Product Evaporative Ultrasonic Vaporizer Warm Mist
31955 Silver Ion Cartridge
31954 Demineralization Cartridge
31961 Vapor Steam
31956 Vapor Pads
31960 Water Treatment Tablets
Notes
Humidifier Accessories
Treatments 5
Other manuals for 33116
1
This manual suits for next models
5
Table of contents
Other Hunter Humidifier manuals

Hunter
Hunter 38200 User manual

Hunter
Hunter 34355 User manual

Hunter
Hunter Aspire HHE150 User manual

Hunter
Hunter 33200A User manual

Hunter
Hunter 33116 User guide

Hunter
Hunter 35205 User manual

Hunter
Hunter QLS-03CB User manual

Hunter
Hunter 34257 User manual

Hunter
Hunter 36517 User manual

Hunter
Hunter 35617 User manual

Hunter
Hunter QLS-05 User manual

Hunter
Hunter 36316 User guide

Hunter
Hunter 37203 User manual

Hunter
Hunter 31018 User manual

Hunter
Hunter 33520 User manual

Hunter
Hunter 37205 User manual

Hunter
Hunter 31006 User manual

Hunter
Hunter 20080902 User manual

Hunter
Hunter 32517 User manual

Hunter
Hunter WARM MIST 35216 User manual





















