HP NetStorage 6000 Use and care manual

Other manuals for NetStorage 6000

12

Table of contents

Other HP Network Storage Server manuals

HP

HP ProLiant ML310 Generation 5p User manual

HP

HP J3278B - SureStore CD-ROM Server/Tower 7 NAS... User manual

HP

HP ProLiant DL100 G2 DPSS Instruction Manual

HP

HP J3278B - SureStore CD-ROM Server/Tower 7 NAS... User manual

HP

HP StorageWorks E Series User manual

HP

HP ProLiant 300 Series Instruction Manual

HP

HP LeftHand P4000 - SAN Solutions User manual

HP

HP StorageWorks XP10000 - Disk Array User manual

HP

HP J3278B - SureStore CD-ROM Server/Tower 7 NAS... User manual

HP

HP NetStorage 6000 User manual

HP

HP EX495 - 1.5TB Mediasmart Home Server Installation instructions

HP

HP ProLiant DL380 G4 DPSS User manual

HP

HP StorageWorks NAS e7000 v2 User manual

HP

HP StorageWorks P4000 Series Quick reference guide

HP

HP NetStorage 6000 Instruction Manual

HP

HP ProLiant ML350 G4p User manual

HP

HP ProLiant DL100 G2 DPSS User manual

HP

HP J3278B - SureStore CD-ROM Server/Tower 7 NAS... Installation and operating instructions

HP

HP ProLiant DL180 G User instructions

HP

HP ProLiant ML310 G3 1TB User manual

HP

HP J3278B - SureStore CD-ROM Server/Tower 7 NAS... Instruction Manual

HP

HP ML110 - ProLiant G5 2TB Storage Server NAS User manual

HP

HP NAS 4000s Instruction Manual

HP

HP J3278B - SureStore CD-ROM Server/Tower 7 NAS... User manual

Popular Network Storage Server manuals by other brands

Seagate

Seagate U10 ST320423A installation guide

Synology

Synology RackStation RS816 Hardware installation guide

D-Link

D-Link ShareCenter Pro DNS-1200-05 user manual

Avid Technology

Avid Technology VideoRAID ST Setup and user guide

Western Digital

Western Digital My Cloud Home Duo user manual

PrimeArray

PrimeArray 4xxx user guide

Buffalo

Buffalo TeraStation WSS WSH5010N6 user manual

Planex

Planex MZK-NAS01SG user manual

Intel

Intel SS4000-E - Entry Storage System NAS Server user guide

Synology

Synology RS2212+ Quick installation guide

Allnet

Allnet ALL69000 user manual

Adaptec

Adaptec 5325301580 quick start guide

Motorola

Motorola EXORdisk II user guide

Sony

Sony XDAAI1PK brochure

Cisco

Cisco Linksys NAS200 Quick installation

Sans Digital

Sans Digital MR4UT6G quick start guide

AIC

AIC FB128-LX user manual

Dell

Dell PowerVault NX3500 Setting up

Hard Drive Replacement

HP NETSTORAGE 6000

A. If an alarm is sounding, press the alarm-reset button on the

front panel.

B. Open the front panel door, and locate the blinking red LED along the

top front edge of the unit. This LED is directly above the failed unit.

C. se the key to unlock the drive shuttles.

D. Loosen the shuttle thumbscrew at the base of the failed drive.

Pull forward on the thumbscrew and lift the shuttle lever.

E. Slide the failed drive assembly forward and out of the drive bay.

Before You Begin:

•se only HP Hard Drives approved for your NetStorage 6000. For an up-to-date list of approved

hard disk drives, please visit our web site at http://www.hp.com/support/ns6000. Drives on the

approved list have custom firmware for use in your NetStorage 6000. Do not attempt to install any

hard disk drives other than the approved drives listed at this web site as doing so may result in

system failure or loss of data. sing non-supported hard drives may also void your warranty.

•This replacement drive kit should not be used for expanding your system. For upgrades, use an

HP NetStorage 6000 Hard Drive pgrade Kit.

•To insure proper cooling of the unit, leave the failed drive in the bay until you are ready to replace it.

•It is best to replace a hard drive when the NetStorage 6000 is operating.

D.

B.

C.

E.

Locate and Remove the Failed Drive

arts Required:

•1 drive (same capacity as the failed

drive)

•Key for physically unlocking the

hard drives

•Electrostatic protection device

Install the New Drive

A. Loosen the shuttle lever thumbscrew and open the lever on the new

drive.

B. Slide the drive assembly into the bay vacated by the failed drive.

Fully seat the drive by lifting the lever and pushing rearward while

lowering the lever. The top of the lever will engage with the rail at

the top of the drive bay. Lower the lever, securing the drive in place.

C. Tighten the thumbscrew. Lock the drive shuttles with the key and

close the front panel door.

NOTE: The drive’s LED may flash or go blank after installation. The

LED turns green after a few minutes if it was installed correctly.

Order a Hard Drive

Use the Web Interface to Assign the New Drive

B.

A.

C.

The new drive may now be used to repair or supplement your system.

A logical drive with a failed drive will need rebuilding if a hot spare was not

available to automatically replace the failed drive. If a hot spare was used to

replace a failed drive, then the new drive should be assigned as the hot spare

to replace the one that was called into service.

To rebuild a logical drive:

A. Open a web browser and enter the unit's IP address in the browser's address

or location field.

B. Select Storage > hysical Drives > Actions > Rebuild Logical Drive.

C. Select the Logical Drive to rebuild from the list of Logical Drives. Click OK.

NOTE: The new drive M ST be placed in the same slot location as the drive

that failed.

To assign the new drive as the hot spare:

A. Open a web browser and enter the unit's IP address in the browser's address

or location field.

B. Select Storage > hysical Drives > Actions > Assign Hot Spares.

C. Click on the slot with the new drive. Click OK.

A. You should always have a spare hard drive on hand.

To order a replacement, call HP Customer Care at 970-635-1000.

*C4482-90100*

C4482-90100