HomeFree Systems QUX VST 800 User manual
Personal Watcher
QUX VST 800 / VST 800-2
USER MANUAL
10 December 2002
HomeFree Systems Ltd VST 800 User Manual
1
Table of Contents
1. Foreword....................................................................................2
2. Installing the Personal Watcher .................................................3
3. Setting Time...............................................................................4
4. Triggering an Alarm ..................................................................5
5. General Rules for the Client ......................................................6
6. Maintenance Instructions...........................................................7
6.1. Replacing Batteries ....................................................................7
6.2. Cleaning Instructions .................................................................9
6.3. Straps Replacement..................................................................10
7. FCC Notices.............................................................................11
HomeFree Systems Ltd VST 800 User Manual
2
1. Foreword
The Personal Watcher (VST 800) is a wristwatch, which contains
an integral transmitter. The transmitter is transmitting
identification signals, which are used to either locate the client’s
location within an area covered by a local positioning system, or
monitor his/her location and movement status at home.
The Personal Watcher enables the user to send a distress alarm
signal with a simple press of a button.
The Personal Watcher (VST 800) is transmitting on an American
FCC tested and approved frequency, whereas the European
version (VST 800-2) is transmitting on an European tested and
approved frequency. From a user interface and function point of
view the two models are identical; therefore this user manual
serves both versions.
HomeFree Systems Ltd VST 800 User Manual
3
2. Installing the Personal Watcher
Turn on the Personal Watcher by pressing the red ON button on
the electronic key.
Press the electronic key’s RED button down for one second - the
red light turns steadily ON for two (2) seconds.
If the startup command has been successfully received, the red
light on the Electronic Key will flash for two (2) seconds.
Note that if the transmitter has failed to receive the startup
command the red light will turn off after the initial two (2)
seconds ON.
If the Electronic Key battery is low the red light will
immediately flash for two (2) seconds, once the red button is
pressed. (No command is sent to the transmitter).
Place the Personal Watcher on its side, on a non-metal surface,
for 30 seconds.
Wrap the Personal Watcher’s strap around the wrist, as done with
any wristwatch. Once the strap is closed, secure it by fastening
the metal clip. If required, slip the strap holder to hold the lose
edge of the strap.
Note:
An alarm signal is sent to the central monitoring computer
whenever the strap is open, cut, or the Personal Watcher is
removed from the wrist without opening or cutting the strap.
HomeFree Systems Ltd VST 800 User Manual
4
3. Setting Time
To set the Personal Watcher’s time:
1. Pull the knob, positioned at 3 o’clock (use a finger nail to
apply an outbound pressure on upper side of the knob)
2. Turn the knob until the watch hands reach the desired
position.
3. Push the knob back into its secured position.
HomeFree Systems Ltd VST 800 User Manual
4. Triggering an Alarm
1. Press the 8 o’clock pushbutton for 2 seconds.
2. A red light is illuminated inside the watch, as a confirmation
that your press has been registered.
3. A distress signal is immediately sent to the central monitoring
system. An alert message is displayed to the nurse on the
system’s monitor, and in parallel a message is sent to her
pager.
5
HomeFree Systems Ltd VST 800 User Manual
6
•
•
•
5. General Rules for the Client
The Personal Watcher is a waterproof wristwatch and there is no
need to remove it when taking a bath or a shower. You can even
wear it when swimming and diving in a swimming pool or taking
a sauna bath.
Turn the Personal Watcher’s transmission off when admitting to a
hospital, either for a visit or for hospitalization, since the
transmitted signal may affect other medical instrumentation.
Turn the Personal Watcher’s transmission off when boarding a
flight, since the transmitted signal may affect the aircraft’s
avionics thus impairing flight safety.
Turning the Personal Watcher’s transmission off should be done
by an authorized personnel, as follows:
Press the electronic key’s BLACK button down for one
second, the red light turns steadily ON for two (2) seconds.
If the shut down command has been successfully received, the
red light on the Electronic Key will flash for two (2) seconds.
Note that if the transmitter has failed to receive the shut down
command the red light will turn off after the initial two (2)
seconds ON. No periodic transmission
If the Electronic Key battery is low the red light will
immediately flash for two (2) seconds, once the black button is
pressed. (No command is sent to the transmitter).
HomeFree Systems Ltd VST 800 User Manual
6. Maintenance Instructions
6.1. Replacing Batteries
Transmitter Battery Replacement
Lay the Personal Watcher on a table, with its back cover
facing you.
•
•
•
•
•
Gently unscrew the back cover’s four screws and remove the
cover.
Gently remove the battery holder.
Gently pull out the used battery and insert the new one.
Use only CR2025 Lithium batteries (3V, 170mAH), made by
Mitsubishi, Energizer, Renata, or any other UL recognized
CR2025 batteries.
CAUTION
Risk of explosion if battery is replaced by an incorrect type!
Dispose of used batteries according to the instructions!
• Gently place the battery holder back to its original position.
7
HomeFree Systems Ltd VST 800 User Manual
8
•
•
•
•
•
•
•
•
•
Place the back cover at its original position and gently screw
the four screws.
Test the Personal Watch for transmission.
Watch Battery Replacement
Lay the Personal Watcher on a table, with its back cover
facing you.
Gently unscrew the back cover’s four screws and remove the
cover.
Gently remove the electronic assembly and reach the watch-
assembly.
Gently pull out the used battery and insert the new one.
Use only Maxell SR521SW, or equivalent, Lithium
batteries
Gently place the watch and electronic assemblies back at their
original position.
Place the back cover at its original position and gently screw
the four screws.
Test the wristwatch for proper functioning.
Notes:
•
•
Battery replacement should be performed only by an authorized
personnel.
Disposal of used batteries should be done in accordance with
local environmental protection acts.
HomeFree Systems Ltd VST 800 User Manual
9
6.2. Cleaning Instructions
A soft brush and any cleaning solution are all that is needed to
clean the Personal Watcher VST 800.
Alcohol based solutions; Soapy water or Lysol can be used to
clean the Personal Watcher. For additional safety and user
comfort it is Recommended that after cleaning with any of the
above the Transmitter be washed with clear water before it is
reused.
Cleaning the Transmitter:
1. Holding it at the end of the long strap, spray the Personal
Watcher with cleaning solution of choice (see above).
Alternatively you can simply drop the Personal Watcher in
the cleaning solution.
2. Using a piece of cloth or a paper towel, dry the outer side of
the Personal Watcher. Lay the Personal Watcher on the
towel with its inner side facing up. Using a soft brush or
another piece of cloth/towel gently scrub the inner side of
the Personal Watcher.
3. Wash the Personal Watcher in clear water. Dry the Personal
Watcher using a piece of cloth/paper towel or simply let it
dry.
This manual suits for next models
1
Table of contents
