HMS Networks Ewon Netbiter EC300 Series User guide
NNeettbbiitteerr EECC330000 SSeerriieess
STARTUP GUIDE
SP2508 1.3 en-US ENGLISH
Important User Information
Liability
Every care has been taken in the preparation of this document. Please inform HMS Industrial Networks
of any inaccuracies or omissions. The data and illustrations found in this document are not binding. We,
HMS Industrial Networks, reserve the right to modify our products in line with our policy of continuous
product development. The information in this document is subject to change without notice and should
not be considered as a commitment by HMS Industrial Networks. HMS Industrial Networks assumes no
responsibility for any errors that may appear in this document.
There are many applications of this product. Those responsible for the use of this device must ensure
that all the necessary steps have been taken to verify that the applications meet all performance and
safety requirements including any applicable laws, regulations, codes, and standards.
HMS Industrial Networks will under no circumstances assume liability or responsibility for any problems
that may arise as a result from the use of undocumented features, timing, or functional side effects
found outside the documented scope of this product. The effects caused by any direct or indirect use of
such aspects of the product are undefined, and may include e.g. compatibility issues and stability issues.
The examples and illustrations in this document are included solely for illustrative purposes. Because of
the many variables and requirements associated with any particular implementation, HMS Industrial
Networks cannot assume responsibility for actual use based on these examples and illustrations.
Intellectual Property Rights
HMS Industrial Networks has intellectual property rights relating to technology embodied in the product
described in this document. These intellectual property rights may include patents and pending patent
applications in the USA and other countries.
eWON®, Netbiter®, and Argos®are registered trademarks of HMS Industrial Networks AB. All other
trademarks mentioned in this document are the property of their respective holders.
Netbiter EC300 Series Startup Guide SP2508 1.2 en-US
Preparation 3 (20)
1 Preparation
1.1 About This Document
This document describes how to install a Netbiter EC300 Series gateway and set
up a basic configuration.
For additional documentation and software downloads, FAQs, troubleshooting
guides and technical support, please visit www.netbiter.com/support.
Document Conventions
The following formatting conventions are used in this document to indicate
safety information and other content of specific importance:
WARNING
This instruction must be followed to avoid a risk of death or serious injury.
Caution
This instruction must be followed to avoid a risk of personal injury.
This instruction must be followed to avoid a risk of reduced functionality
and/or damage to the equipment, or to avoid a network security risk.
This is additional information which may facilitate installation and/or operation.
Netbiter EC300 Series Startup Guide SP2508 1.2 en-US
Installation 4 (20)
2 Installation
This product contains parts that can be damaged by electrostatic
discharge (ESD). Use ESD prevention measures to avoid damage.
Make sure that you have all the necessary information about the capabilities
and restrictions of your local network environment before installation.
Basic Installation Steps
1. Mount the unit on a flat surface or on a DIN rail using the optional adapter
kit.
2. Connect the slave devices and Ethernet network as needed.
3. Connect a suitable power supply and apply power.
4. Mobile networking (EC350/EC360):
– Connect the 4G/3G/GPRS antenna and insert the SIM card.
5. Ethernet networking:
– Connect the Netbiter to a PC via the USB port and wait for the device
driver to install.
– Enter the IP address 169.254.200.200 in a web browser to access the
local configuration pages.The username is admin, and the password is
the activation code supplied with the unit.
– Open the Network Settings tab and configure the IP settings for the
WAN interface as needed.
6. Continue to Configuration, p. 14
The Modbus interfaces must be enabled in Argos before they can be used. See
the Argos documentation for more information.
Netbiter EC300 Series Startup Guide SP2508 1.2 en-US
Installation 6 (20)
2.2 Connectors
2.2.1 I/O Terminal Block
Pin Label Function Note
15 HI CAN High
J1939
14 PE CAN Shield
13 LO CAN Low
12 GND CAN Ground
11 COM Analog Input common
10 AI4 Analog Input 4 0–20 mA or 0–10 VDC
9 AI3 Analog Input 3 0–20 mA or 0–10 VDC or PT100
8 AI2 Analog Input 2 0–20 mA or 0–10 VDC
7 AI1 Analog Input 1 0–20 mA or 0–10 VDC or PT100
6 DI2- Digital Input 2
Dry contact type – do not apply
power to these inputs
5 DI2+ Digital Input 2
4 DI1- Digital Input 1
3 DI1+ Digital Input 1
2 COM Relay output common Isolated inputs
Rated load: 1 A @ 24 VDC1 NO Relay output, NO
The analog inputs must be configured for voltage, current or PT100 input.
The digital inputs are of the dry contact type which require no control voltage.
Do not connect power to the digital inputs as this may damage the unit.
The relay output must be supplied from an isolating transformer using a
secondary listed fuse rated at maximum 3.3 A and minimum 30 VDC.
Netbiter EC300 Series Startup Guide SP2508 1.2 en-US
Installation 7 (20)
2.2.2 Power Supply
Connecting power with reverse polarity or using the wrong type of power
supply may damage the equipment. Make sure that the power supply is
connected correctly and of the recommended type.
Connect a DC power supply of the recommended type to the +(plus) -(minus)
terminals. See also Technical Data, p. 16.
2.2.3 USB Connector
The USB micro B connector can be used to connect a computer to the unit for
local configuration, firmware upgrades and troubleshooting.
Netbiter EC300 Series Startup Guide SP2508 1.2 en-US
Installation 8 (20)
2.2.4 SIM Card (EC320, EC350 & EC360)
The SIM card must have a mobile data plan and allow text messaging. PIN code
security must be disabled. Additional configuration in Argos or in the local web
interface is required.
Insert the SIM card carefully and push it firmly downwards until it clicks into
place. Observe the position of the cut-off corner and the contact surfaces.
Make sure that the SIM card does not slip behind the holder.
2.2.5 Antenna Connectors
A GPS antenna (not included) must be connected to the GPS antenna connector
to use the built-in GPS receiver. The GPS antenna connector also provides power
for active GPS antennas.
EC320 & EC350
Netbiter EC300 Series Startup Guide SP2508 1.2 en-US
Installation 10 (20)
2.2.6 RS-485 Serial Interface (3-pin)
The RS-485 interface can be used for multiple Modbus RTU devices.
RS-485 connector pin layout
Pin Function
ARS-485 A line
BRS-485 B line
COM RS-485 common
2.2.7 RS-232 Serial Interface (3-pin)
The RS-232 interface can be used for a single Modbus RTU device.
RS-232 connector pin layout
Pin Function
Rx Receive (input)
Tx Transmit (output)
GND Signal ground
Netbiter EC300 Series Startup Guide SP2508 1.2 en-US
Other manuals for Ewon Netbiter EC300 Series
1
This manual suits for next models
9
Table of contents
Other HMS Networks Gateway manuals
HMS Networks
HMS Networks Intesis IN770AIR00 O000 Series User manual
HMS Networks
HMS Networks Intesis INMBSDAL1280200 Assembly instructions
HMS Networks
HMS Networks Intesis INMBSDAL1280200 Assembly instructions
HMS Networks
HMS Networks Ixxat SG-gateway User manual
HMS Networks
HMS Networks Intesis KNX User manual
HMS Networks
HMS Networks Intesis IN775FGL00 O000 Series User manual
HMS Networks
HMS Networks Intesis IN771AIR00LO000 User manual
HMS Networks
HMS Networks Ewon Netbiter EC300 Series User manual
HMS Networks
HMS Networks Intesis 700 Series User manual
HMS Networks
HMS Networks Intesis IN770AIR00 O000 Series User manual
HMS Networks
HMS Networks Ewon Flexy 205 Installation and operating instructions
HMS Networks
HMS Networks Intesis INBACACA004I000 Assembly instructions
HMS Networks
HMS Networks Intesis IN770AIR00 O000 Series User manual
HMS Networks
HMS Networks Ewon Cosy+ User manual
HMS Networks
HMS Networks Anybus Wireless Bolt CAN User manual
HMS Networks
HMS Networks Intesis User manual
HMS Networks
HMS Networks Intesis IN701-KNX Series User manual
HMS Networks
HMS Networks Intesis IN770AIR00XO000 User manual
HMS Networks
HMS Networks Intesis IN703DAL0640000 User manual
HMS Networks
HMS Networks Intesis IN770AIR00 O000 Series User manual
Popular Gateway manuals by other brands
LST
LST M500RFE-AS Specification sheet
Kinnex
Kinnex Media Gateway quick start guide
2N Telekomunikace
2N Telekomunikace 2N StarGate user manual
Mitsubishi Heavy Industries
Mitsubishi Heavy Industries Superlink SC-WBGW256 Original instructions
ZyXEL Communications
ZyXEL Communications ZYWALL2 ET 2WE user guide
Telsey
Telsey CPVA 500 - SIP Technical manual
