Hitachi CM1721ME User manual
Tt5CC-l
!=I
G
Colour Monitor
CM1721ME User Manual
BEDIENUNGSANLEITUNG
17MVX-v2
For future references, record the serial number of your
display monitor, SERIAL No.
The
serial
number
is
located
on
the
rear
of
the
monitor.
READ
THE
INSTRUCTION
INSIDE
CAREFULLY.
KEEP
THIS
USER
MANUAL
FOR
FUTURE
REFERENCES
This monitor is
Energy
Star compliant when used with
a computer equipped with VESA DPMS.
For U.K. Customers
THIS
PRODUCT
IS
SUPPLIED WITH ATWO
PIN
MINS
PLUG
FOR USE
IN
MAINLAND EUROPE. FOR THE U.K.
PLEASE REFER
TO
THE NOTES
ON
THIS
PAGE.
NOTE:
ELECTRICAL CONNECTIION
Your monitor requires an electrical supply of 240 volts
-
50 Hertz
and should be protected by a 5 amp fuse. Your equipment is
supplied with a plug incorporating a 5 amp fuse fitted to the mains
lead. If the plug that is fitted to the equipment is not suitable for
your socket outlet, it must be cut off and the appropriate plug fitted.
The cut off plug should be disposed of, do not insert it into a 13
amp socket to prevent the hazard of electric shocks. With plugs not
incorporating a fuse, the circuit must be protected by a 5 amp fuse.
WARNING: THIS EQUIPMENT MUST BE EARTHED.
IMPORTANT
Your equipment is supplied with a mains lead, the wires of which
are coloured in accordance with the following code: Green and
Yellow-Earth, Blue-Neutral, Brown-Live.
Green
&
Yellow
to Earth
Blue to Neutral
Brown to Live
Fuse
Cord
Clamp
-I-
As the
colours
of the
wires
in your mains lead in this equipment
may not correspond with the markings identified with the terminals
of your plug. proceed as follows:
The wire which is coloured Green and Yellow must be connected to
the terminal in the plug which is marked with the letter E or by the
symbol or coloured Green or Green and
Yellon,
The wire which is coloured Brown must be connected to the
terminal which is marked
with
the letter L or coloured Red.
The wire which is coloured Blue must be connected to the terminal
which is marked N or colourcd Black
The plug moulded on to the cord incorporates a fuse. For
replacement, use a
5
amp BS 1362 fuse. Only ASTA
approved
fuses should be used. The fuse cover/carrier must be refitted when
changing the fuse. In the event of losing the fuse cover/carrier, the
plug must not be used until a replacement has been obtained from
your nearest electrical
stockist
and fitted. The colour of the fuse
cover/carrier is that of the coloured marks on the insert in the base
of the plug.
-
II
-
Please read the following instructions carefully to prevent
potential hazards. This manual should be retained for future use.
1. Do not expose the monitor to rain, water, moisture, or direct
sunlight.
2. Do not spill liquid into the monitor
3. Do not insert any objects into the monitor cabinet’s openings.
4. Do not place near or above sources of heat such as heaters or
radiators.
5. Do not block or cover ventilation opening with any material.
The openings and slots on the cabinet provide necessary air
flow for heat dissipation. The unit should never be enclosed
or built upon unless adequate ventilation is provided.
6. Do not remove the cover to try to service this unit.
Servicing
of any nature should only be performed by authorized service
personnel.
7. WARNING! Do not attempt to service this unit yourself as
opening or removing covers may expose you to dangerous
voltage or other hazards.
8. The On/Off switch is not a disconnecting device. Make sure
to remove the AC power cord after using.
9. When the monitor is turned on continuously for a long period,
the phosphors of the CRT face plate may “bum” leaving a
permanent image on the screen. In order to preserve CRT life,
be sure to turn off the monitor or decrease the displayed
intensity when not in use.
-
III
-
10. WARNING! The voltage ratings and the rated frequencies
are posted on the back panel of this product. Please see
the
overlay in the center of the back panel of this product.
NEVER connect to any other voltage or frequency. Follow
ALL warnings and instructions marked on the product.
11. This, product is equipped with a
3-wire
grounding-type plug.
It will only fit into a grounding-type power outlet. This is a
safety feature. If you are unable to insert the plug into the
outlet, the outlet can be replaced by an electrician. Do not
defeat the safety purpose of the grounding-type plug by
improper use or alteration.
12.
Power source
. This monitor is able to operate using power sources from
108-264VAC/60-50Hz
by means of internal auto power
switching.
. For 120V operation, use only with power cord having a
parallel blade grounding-type plug, rated at I OA-
125V.
. For 240V operation, use only with power cord having a
tandem blade grounding-type plug rated 1 OA-250V
minimum.
-
IV
-
Bitte lesen Sie diese Sicherheitshinweise sorgftitig durch,
damit
die richtige Verwendung des Gerstes sichergestellt wird.
Diese Anleitung
sorg<ig
aufbewahren.
1. Das
Bildschirmger~t
nicht Regen, Wasser, Feuchtigkeit oder
direktem
Sonnenlicht
aussetzen.
2. Keine
Fltissigkeiten
tiber
dem Bildschirmgerat Verschtitten.
3. Niemals
Gegenstande
durch die
&fnungen
in das Innere des
Gerates
stecken oder hineinfallen
lassen.
4. Das
BildschirmgeCit
nicht in der Nahe von Heizgeraten der
Heizungen aufstellen.
5.
Nicht die beliiftungsdffhungen des Gehauses blockieren oder
abdecken. Diese
@frrungen
und
Schlitze
im Gehause sorgen
tir
die notwendige Ventilation. Das Bildschirmgerat sollte
niemals mit einer Verkleidung umgeben oder in einem Regal
eingebaut werden. falls keine ausreichende
Beltiftung
vorhanden ist
6. Niemals versuchen, das Gehause zu entfemen oder das
Bildschirmgerat selber zu war-ten.
Alle
Wartungsarbeiten
sollten nur vom Kundendienst durchgefiihrt werden.
7. Nicht versuchen, das Bildschirmgerat selbst zu war-ten. Im
Inneren
des Gerates sind gef&rliche elektrische Spannungen
und andere Gefahren vorhanden.
8. Der Netzschalter ist keine Trennvorrichtung Sicherstellen,
daR
die
NetzanschluRleitung,
wenn das Gerat
Iangere
Zeit nicht
benutzt wird,
aus
der netzsteckdose gezongen wird.
-V-
9.
Bei
Einstellung des Bildschinngerates auf
starkste
Helligkeit
und Kontrast uber langere Zeit Konnen die Leuchtschicht der
Bildrohrenoberfhiche
einbrennen. Zur Verlangerung der
Lebensdauer der Bildrohre ist sicherzustellen,
dal3
das
Bildschirmgerat nach der Verwendung ausgeschaltet wird
oder Helligkeit und Kontrast verringert werden.
10. Die Angaben zur Spannung und Frequenz entnehmen Sie dem
Fabrikschild.
Schliessen Sie Ihr Gerat nie an eine
Stromquelle mit andeier. als der dort genannten Spannung/
Frequenz an.
Beachten
Sie ausserdem alle am Gerat
angebrachten Warn- und Bedienungshinweise.
11. Ihr Gerat ist mit einem dreipoligen Schukostecker ausgestattet.
Dieser Stecker kann nur an eine Schutzkontaktsteckdose
angeschlossen
wrerden.
Sollte der Stecker nicht in die
Steckdose
passen,
lassen
Sie diese bitte von einem Elektriker
auswechseln.
Es
mu8 sichergestellt werden.
dal3
die
minimale
Bildwiederholfrequenz von
70 Hz
bei
Positivdarstellung
und 60 Hz
bei
Negativdarstellung
nicht
unterschritten wird (storendes Bildschirmflimmem
konnte
die Folge sein).
Weiterhin wird
aus
ergonomischen Griinden empfohlen, die
Grundfarben Blau und Rot
nicht
auf dunklem Untergrund zu
verwenden (schlechte Lesbarkeit und erhohte Augenbelastung
bei
zu
geringem Zeichenkontrast
w&ren
die Folge).
“Der
arbeitsplatzbezogene Schalldruckpegel
nach
DIN 45 635 Teil
1000 betragt
70dB(A)
oder
weniger”
-
VI
-
(Gerat,
Typ, Bezeichnung)
in ijbereinstimmung mit den Bestimmungen der
BMPT-Amt-
sblVfg
243/l 99 1 funk-entstort ist. Der
vorschriftsmai3ige
Betrieb
mancher Gerate
(zB
Me&sender)
kann allerdings gewissen Ems&r
ankungen
unterliegen.
Beachten Sie deshalb die Hinweise in der Bedienungsanleitung.
Dem Bundesamt’ fur Zulassungen in der Telekommunikation
wurde das inverkehrbringen dieses
Gerates
angezeigt und die
Berechtigung zur ijberprtifung der Serie auf die Einhaltung der
Bestimmungen eingeraumt.
-
VII
-
/
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates. uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions. may
cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for
help.
Warning:
A shielded-type power cord is required in order to meet FCC
emission limits and also to prevent interference to the nearby radio
and television reception. It is essential that only the supplied
power cord be used.
Use only shielded cables to connect l/O devices to this
equipment.
You are cautioned that changes or modifications not
expressly approved by the party responsible for compliance could
void your authority to operate the equipment.
-
VIII
-
This manual suits for next models
1
Table of contents
Other Hitachi Monitor manuals
Hitachi
Hitachi PW1 37PD5000 User manual
Hitachi
Hitachi CML170SXW User manual
Hitachi
Hitachi CM500ET User manual
Hitachi
Hitachi CMP4201 User manual
Hitachi
Hitachi CML200UXWB User manual
Hitachi
Hitachi CM610ET User manual
Hitachi
Hitachi DW1-UA User manual
Hitachi
Hitachi 55PD8800TA User manual
Hitachi
Hitachi CML154XW User manual
Hitachi
Hitachi CM715ET User manual
Hitachi
Hitachi CMP205SXE User manual
Hitachi
Hitachi CMP4212E User manual
Hitachi
Hitachi CML151XW User manual
Hitachi
Hitachi CM776ET User manual
Hitachi
Hitachi CML174SXW2 User manual
Hitachi
Hitachi CML153XW User manual
Hitachi
Hitachi 42PMA300A User manual
Hitachi
Hitachi CML176SXW User manual
Hitachi
Hitachi CM615ET302 User manual
Hitachi
Hitachi 55HDM71 - 55" Plasma Panel User manual
