06/11 Page 5
General instructions
The banding machine of the type
BA 30/800
manufactured
by HIMA is easy to operate but nevertheless requires pru-
dence. The persons operating the machine shall be familiar
with its operation and limits.
The following instructions must be observed:
Please read the operating instructions carefully prior to using
the banding machine and use the machine only in the proper
way described in these operating instructions.
Caution!
Persons not instructed in the operation shall not use the
machine. Please make sure that the designated opera-
ting staff has been instructed properly.
Do not operate the machine if it has been damaged
during transportation or during use. This applies in parti-
cular to damages of the appliance connector (A) with the
main switch (B), the remote operation socket (C) or the
operating elements (D) on the front. The machine shall
be serviced or repaired only by specialised persons
(HIMA customer service). Do not repair the machine
yourself (warranty will become void). In case of dama-
ges, please contact the customer service immediately.
Putting into initial operation
Remove all protective foils. Remove any parts on or inside
the machine or in the immediate vecinity of the machine. Do
not stick advertising (stickers, paper, etc.) to the machine.
Danger of electrical shock!
Do not clean the outer case of the machine with a drip-
ping wet cloth. Use a dry cloth. The same applies to the
electrical operating elements (D). Keep any chemical
detergents away from the operating elements and the
nameplate (E).
HIMA
Harald Hinderer Maschinenbau
Phone: (0049) 71 83 / 30 7700
