Type plate
Log guard
Fire-box surround
Ash-pan
Grate shuttle
Air supply control
Building application
Before installing a stove or erecting a chimney, you must apply
to your local planning authority for planning permission. We
recommend you contact your local planning office for advice on
building regulations and applying for planning permission.
Structural support
Check that the wood joists are strong enough to bear the weight
of the stove and chimney. The stove and chimney can usually
be placed on a normal wooden joist in a self-contained house
provided the total weight does not exceed 400 kg.
Hearth plate
The stove must be placed on a hearth plate to protect the floor
from any embers. If the floor under the stove is combustible, it
must be protected with a minimum of 12 mm of non-combustible
material that covers at least 300 mm of the floor in front of the
stove door and 100 mm on each side.
Chimney
The draught in the chimney must generate a negative pressure
of at least 12 Pa. The draught is affected both by the length
and cross-sectional area of the chimney, and by how well sealed
it is. The shortest recommended chimney length is 3.5 metres.
The cross-sectional area must be 150-200 cm² (140-160 mm
in diameter). Carefully check that the chimney is sealed and
that there is no leakage around soot hatches and flue pipe
connections.
Note that the draught in the chimney is reduced in a flue with
sharp bends and horizontal sections. A horizontal flue length of
up to 1 metre is permissible, provided that the vertical flue is
at least 5 metres high. It must be possible to sweep the entire
length of the flue and the soot hatches must be easily accessible.
Technical data
Output 3-9 kW
Nominal output 6 kW
Efficiency rating up to 80%
Model H26T/K Tall H26T Low H26K Tall H26K Low
Weight (kg) 470 420 240 240
Widthd (mm) 580 580 580 580
Depth (mm) 462 462 462 462
Height (mm) 1622 1312 1622 1312
Weight H26T with baking oven: 480 kg
Weight H26K with baking oven: 265 kg
Weight Heat tank (Optional accessory for H26 T/K Tall): 120 kg
Air duct connection, external diameter Ø150 mm.
Type approved in accordance with:
European standard EN-13240
Swedish environmental and quality marking, P-marking cert. no.
220306
Norwegian standard NS 3059, SINTEF 110-0223
German standard DIN EN 13240, RRF 4005900
General
information
This manual contains
instructions on how the
Handöl 20 series must be
assembled and installed.
In order to be able to guarantee the performance and
safety of the stove, we recommend that it is installed by a
professional. Our Handöl agents can recommend suitable
installers. For information about our agents, please visit our
website www.handol.se
Instructions for use and how to light the stove correctly are
also supplied with the stove. We recommend that you read
these instructions carefully and keep them safe for future use.
The stove is type approved and must be connected to a chimney
able to withstand temperatures of at least 350°C. The diameter
of the external connection is 150 mm. Air should be supplied
from outside for use as combustion air.
