H3C S5500-SI Series User manual
Tool list
Mounting the switch to a rack
Introduction to installation accessories
Before installation, wear an ESD-preventive wrist strap, and make sure that the wrist strap
has a good skin contact and is well grounded.
When the depth of a switch is greater than 300 mm (11.81 in), the front mounting
brackets only secure the switch rather than bear its weight.
Flathead
screwdriver
Phillips
screwdriver
ESD-preventive wrist
strap
Needle-nose
pliers
Wire-stripping
pliers
Diagonal
pliers
Blow dryer
Grounding cable
Front mounting bracket
and M4 screws
Cage nut (User supplied)
Rear mounting bracket
and load-bearing screw
Rubber pads
M6 screw (User supplied) Bail latch
The installation tools are not provided with the switch. Prepare them by yourself.
Method 1—Using only front mounting brackets
Install front
mounting brackets
Install cage nuts to the
square holes of the rack
1U
23
1
Method 2—Using front and rear mounting brackets
1U
Install the load-
bearing screw
Install the front mounting
bracket
Install cage nuts to the
square holes of the rack
Mount the rear mounting
brackets to the square holes on
the rear post of the rack
4
3
12
Mounting the switch to a workbench
2
Stick the rubber pads to the appropriate
positions on the switch bottom
1
Connecting the grounding cable
Method 2 +12 VDC (RPS)
123
You can use only the RPS power supply recommended by H3C (optional RPS power
supply and power cable) for RPS DC input.
Install an OT terminal on the other end of the grounding
cable, and connect the OT terminal to the grounding strip.
Connect the OT terminal of the
grounding cable to the switch
12
Connecting the power cable
Before connecting the power cable, connect the grounding cable and make sure that
the switch is correctly grounded.
Connect the power cable to the switch first and then to the power supply system to
avoid bodily injury.
Connect the AC power cable
Install the bail latch
123
Connect the power
cable to the receptacle
Secure the bail latch over
the power cable
Connect the DC power cable
Method 1 –52 VDC to –55 VDC (RPS)
2
1
3
Copyright © 2011, Hangzhou H3C Technologies Co., Ltd.
For more information about the product and installation procedures, log in to www.h3c.com
Other manuals for S5500-SI Series
22
Other H3C Switch manuals
H3C
H3C S1850 Series User manual
H3C
H3C S6300 Series Operating and maintenance manual
H3C
H3C S5500-EI series User manual
H3C
H3C s5800 series User manual
H3C
H3C S6300 Series User manual
H3C
H3C S9500 Series User manual
H3C
H3C S5500-SI Series User manual
H3C
H3C S3600V3 Series Instruction Manual
H3C
H3C UniServer BX1010E User manual
H3C
H3C S10512 User manual
H3C
H3C S5170-EI Series User manual
H3C
H3C S6520X-SI Series User manual
H3C
H3C LS-S5600-26C-OVS User manual
H3C
H3C S3100-26T P-EI-W User manual
H3C
H3C PSR600-54A-B User manual
H3C
H3C S5500-SI Series User manual
H3C
H3C S5850 Series User manual
H3C
H3C S6850-56HF Operating and maintenance manual
H3C
H3C S7502 User manual
H3C
H3C E500C-F Series User manual
