Gemini GVC14B User manual
MODEL NO 型號: GVC14B
充電式二合一
旋風直立/手提式吸塵機
RECHARGEABLE
2-IN-1 CYCLONIC
VACUUM CLEANER
A GILMAN GROUP BRAND
2
Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in electric shock, re and/or serious injury.
• This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use
of the appliance in a safe way and understand the hazards involved. Children
shall not play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
• Read through the instructions carefully before using the appliance for the rst
time. Safeguard them for future reference.
• Do not let children to play with this appliance
• This is not a Toys.
• This vacuum cleaner requires a certain amount of maintenance if it is to
function properly.
• This appliance has been designed for indoors and domestic use only. It must
only be used in accordance with these instructions. The manufacturer will not
be held responsible for any damage caused by improper or misuse of the
appliance.
• Connect it only to the voltage stated on the characteristics plate.
• Never leave the vacuum cleaner unattended while it is running.
• Do not attempt to charge the appliance at temperatures below 0˚ or above 40˚C.
• The appliance cannot aspirating an aqueous solution that may contain foaming
detergent.
• Do not dismantle the vacuum cleaner while the motor is still operating.
• Never use the vacuum cleaner without the lter.
• Always keep the openings clean and prevent dust or dirt from blocking the air
passage.
• Do not put any objects into openings. Do not use with any opening blocked
until the obstacles removed.
• Never use the vacuum cleaner to suck up explosive, ammable or combustible
liquids or anything that may be still burning such as cigarette butts or ash/
cinders. Never vacuum up toxic materials, organic solvents or acids.
• Never vacuum up solid, sharp or piercing objects that may damage the lter.
• Do not use wet hands to operate the cleaner, plug or unplug the charger.
• Do not leave the plug hanging freely.
• Do not expose the vacuum cleaner to outdoor weather conditions, moisture
or heat.
• Do not leave the appliance close to heat sources like ovens or heaters, nor
allow the cable to come into contact with hot surfaces.
3
• Do not clean any parts in a dishwasher.
• Do not use a wet cloth of thinner, benzene or other volatile substance to clean
the unit.
• Do not immerse the motor housing, cable or charger in water or any other liquid.
• Do not take the batteries out of their compartment, excluding disposal
conditions.
• Do not switch the appliance on if either the cable or plug are damaged, if it
can be detected that it is not operating correctly or if it has suffered any type
of damage.
• Any type of repair work other than that stated in instruction manual must be
done exclusively by an Authorized Technical Service Center.
• The appliance is only to be used with the power supply unit provided with the
appliance.
• The appliance must only be supplied at safety extra low voltage corresponding
to the marking on the appliance.
• The appliance must be disconnected form the supply mains when removing
the battery.
• Do not use the vacuum cleaner without Dust Tank and lter in place
• Never suck up water or any other liquid.
• Never suck up ammable substances and do not suck up ashes until they are
cold.
• Remove the appliance from the adaptor, before cleaning or replacing the lter.
Allow the appliance to cool completely before cleaning or storing.
• Do not point the appliance at the eyes, ears or mouth during operation.
• Make sure the dust container is properly installed before use.
4
1
2
3
4
5
6
7
8
9
10
11a
11b
1. Stick ON/OFF Switch
2. Folding Handle Release Button
3. Handheld Release Button
4. Handheld ON/OFF Switch
5. Charging Indicator
6. Floor Brush Release Button
7. Floor Brush
8. Stick Handle
9. Handheld Handle
10. Handheld Unit
11a.Charger Base (Upper part)
11b.Charger Base (Lower part)
Floor brush
power indicator
5
12
13
12. Dust Container
13. Cyclonic Filter
14. Filter
15. Adaptor
16. Crevice tool
15
16
14
6
Floor Brush
LED Power Indicator Motorized Brush
Press
Wall Mount Hole
• Choose a position close to an electrical wall socket.
• Before tting it, make sure that there are no dangerous
objects hidden below the surface of the wall, such as
electrical wires, pipes, etc.
• Place the wall mount against the wall and mark the places
where the screws will go.
• Drill the holes and insert the anchors into the hole until
level the wall surface.
• Fit the screws into the anchors and remain 2 mm space
from the wall surface.
• Once the screws are tted, place the wall mount onto
them and press it gently downward to make it secure.
• Insert the jack for the charger into socket on the wall
mount.
Insert the upper part of the charging base to the lower part.
Screws
Anchors
Storage area for
screws and anchors
(Located on the back
of charger base)
DC
Jack
hole
Metal pin for
charging
To lower the handle, press the folding
handle release button.
Lift the handle to an upright position,
the handle will lock automatically.
7
Make sure the upright unit is switched OFF.
Avoid any obstacles in between the handheld
unit and the upright unit.
Socket for Adaptor
Make sure the charger base is placed on
a at stable oor.
Attached the upright unit onto the charger
base and the charging indicator will turn on.
If the upright unit is not attached to the charger
base properly, charging will not start.
Avoid any dust in between the charger
base and the unit, clean the contacts if
necessary.
Do not stumble over by the power cable
during charging.
Storage area for
screws and anchors
(Located on the back
of charger base)
Metal pin for
charging
Before using your vacuum cleaner for the rst time, allow the battery to charge
for 14-16 hours.
Charge the battery for 14 - 16 hours when:
• Using the product for the rst time
• After not using the product for a long period of time
Make sure the vacuum cleaner switched off. The adaptor should be connected to a
200-240V~50/60Hz power supply.
Always keep your vacuum cleaner in charging condition when not in use, in
order to ensure full cleaning capacity.
Charging should not be carried out when the ambient temperature is below 0°C
or above +40°C. The charger will become warm during use. This is perfectly
normal.
8
1. Press the handheld release button to detach the handheld vacuum cleaner
from the upright unit. Slide the ON/OFF switch of the vacuum cleaner to ON
and hold the handheld vacuum cleaner will start to work.
2. Vacuum the surface in any direction until the area is clean.
3. Slide the ON/OFF switch to OFF the handheld vacuum cleaner. Slightly lift
the appliance head upward to avoid dust run out from dust container before
switching off.
4. Empty the container after use.
5. Assemble the handheld vacuum cleaner to the upright unit for charging after
every use.
1. Slide the ON/OFF switch to switch on the upright vacuum cleaner.
2. During use, the LED power indicator at the oor brush will light on.
The charging indicator will illuminate blue to indicate that the
vacuum cleaner is being charging.
HINT: It is recommended to charge the vacuum cleaner for at
least 14-16 hours before use.
It is normal that the charger base and the unit will get warm
while charging.
9
• Always switch off the vacuum cleaner before cleaning.
• Empty the container after use every time.
• Do not vacuum up large objects such as tissue papers. This will cause blockage
and lower the suction power .
• Never vacuum up ammable substances and do not vacuum up ashes until
they are cold.
• Always dispose the dust and clean the lters frequently, otherwise the dust
will damage the motor.
1. Detach the dust container
Press the button
at its bottom
2. Pull out the lters
3. Empty the dust container
4. Clean the lters by brush (not included)
5. Re-install the lters in place
6. Re-install the dust container
in proper position
1
2
10
1. Unscrew the left hand side and then
lift and dislodge the brush cover.
4. Re-install the rotating brush again.
Finally, check if the brush cover is
securely xed and the rotating brush
rotates properly.
3. Take out the rotating brush and then
remove the blockage and waste.
Take out the wastes
2. Push the brush shaft left and lift it up.
Remove the belt and take away the
brush shaft.
Belt
Carry out the maintenance if any waste threads or hair gets tangled in the brush.
Take out the brush cover to detach the oor brush from the upright unit.
Slowly rotate the brush manually
and remove any foreign objects
tangled around the brush.
Brush cover
Table of contents
Other Gemini Vacuum Cleaner manuals
