Garmin EXTERNAL IRIDIUM ANTENNA User manual

EXTERNAL IRIDIUM®ANTENNA

INSTALLATION INSTRUCTIONS

External Antenna Mounting Considerations

You can install the external antennas on your vehicle to get the most accurate position data for your navigation

device. For best performance, consider these guidelines when selecting the antenna mounting location.

• To ensure the best reception, you should mount the antennas in a location that has a clear, unobstructed

view of the sky in all directions.

• You should not mount the antennas near the engine or other sources of electromagnetic interference (EMI).

• You must mount the antennas at least 5 cm (2 in.) apart from each other.

Installing the External Iridium Antenna

CAUTION

Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.

NOTICE

When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vehicle.

You can use the included bracket to mount the Iridium antenna to an external surface on your vehicle.

1Using the antenna mounting bracket as a template, mark the pilot hole locations .

2Drill the three 3.2mm (1/8in.) pilot holes (optional).

For some types of mounting material, drilling pilot holes is necessary. Do not drill through the mount.

3Using the included screws , secure the mounting bracket to the mounting location.

GUID-0CF9256F-84D8-4544-8DED-A8B94C298FB1 v1August 2022

4Place the magnetic Iridium antenna in the mounting bracket.

5Route the antenna cable into the vehicle and to the mount.

6Remove the 4 screws, washers, and nuts from the mount.

7Remove the ball plate and Group Ride Radio (if necessary) from the mount.

8Insert the External Iridium Antenna connector through the corresponding hole in the mount , and press

the adapter to secure it to the mount.

9Using the included screw, secure the adapter to the mount from the inside of the mount.

10 Replace the mount on the ball plate, and secure the mount using the 4 existing screws, washers, and nuts.

11 Connect the External Iridium Antenna cable to the External Iridium Antenna connector on the mount.

12 Tighten the collar around the connected cables.

Garmin® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries.

Iridium® is a registered trademark of Iridium Satellite LLC. Other trademarks and trade names are those of their respective owners.

Table of contents

Popular Antenna manuals by other brands

Alfa Network

Alfa Network APA-L01 Specifications

Naval

Naval PR-422CA Operation manual

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series manual

TERK Technologies

TERK Technologies TV44 owner's manual

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK quick start guide

HP J8999A instructions

MobilSat

MobilSat MSP-S Mounting instructions

Steren

Steren ANT-UHF 13 instruction manual

Novatel

Novatel 600-G User information

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna owner's manual

TRENDnet

TRENDnet TEW-AO12O Specifications

Radio Shack

Radio Shack 15-1837 owner's manual

CommScope

CommScope CMAX-OMFX-43M-I53 Installation instruction

Ramsey Electronics

Ramsey Electronics DAP25 Kit assembly and instruction manual

COBHAM

COBHAM SAILOR 800 VSAT Replacement procedure

Trango Systems

Trango Systems AD900-9 Specification sheet

Steren

Steren ANT-100 user manual

Proxim

Proxim 5054-PA-23 quick start guide