Garland INT10G10SP1 User manual
User Guide
RegenTAP: Dual Breakout | INT10G10SP1 | 1.12.4
This document describes the front panel, LED indications, interfaces, rear panel, rear switch and
installation procedure for the INT10G10SP1. The unit supports two span applications in one chassis.
The span port assignments are as follows:
Port 1 Input to span output ports 3, 5, 7, 9.
Port 3 Span output from port 1.
Port 5 Span output from port 1.
Port 7 Span output from port 1.
Port 9 Span output from port 1.
Port 2 Input to span output ports 4, 6, 8, 10.
Port 4 Span output from port 2.
Port 6 Span output from port 2.
Port 8 Span output from port 2.
Port 10 Span output from port 2.
Front Panel
LED Indications
PS2 Power Supply 2 LED Green indicates normal
Off indicates power not applied
PS1 Power Supply 1 LED Green indicates normal
Off indicates power not applied
SYS System LED Green indicates normal
Port 1 – 9 Left Up Arrow Green indicates link
Port 1 – 9 Right Up Arrow Flashing Green indicates TX/RX activity
Port 2 – 10 Left Down Arrow Green indicates link
Port 2 – 10 Right Down Arrow Flashing Green indicates TX/RX activity
Rear Panel
PS 1 Fan 1
Fan 2 PS 2
Garland Technology | 716.242.8500 | garlandtechnology.com/support
Copyright © 2021 Garland Technology, LLC. All rights reserved. 1
User Guide
RegenTAP: Dual Breakout | INT10G10SP1 | 1.12.4
Installation Procedure
1. Connect power cables to PS1 and PS2 on the rear panel and plug into available power sources.
2. Verify that the PS1 and PS2 LEDs on the faceplate are illuminated.
3. Verify that the SYS LED on the faceplate is illuminated.
4. Insert 10G SFPs into the desired ports. This step can be done prior to power on if desired.
5. Verify the L/A LEDs are illuminated green indicating link.
6. Verify the L/A LEDs are flashing green indicating traffic.
Garland Technology | 716.242.8500 | garlandtechnology.com/support
Copyright © 2021 Garland Technology, LLC. All rights reserved. 2
Table of contents
Other Garland Chassis manuals
