R U N
CV CONTROLLER
R U N
Gener al Information
LED Lamp
Connected Sock et
5~24V
Power Input
Sock et
dc
Remote ID
Learning Button
Running Light
On/O
Pause
Ke y
Mode
Ke ys
Speed
Ke ys
Brightnes s
Ke ys
LED Lamp Connected Sock et
12~24V Power Input Sock etdc
C Terminal of Rec eiver s:
T3-CV
T3-5A
T3- CV T3- CC
T3- 5A
— 5 —
Running Light
T3-CC Receiver
Remote ID
Learning Button
STRONG. SIMPLE. COMPACT.
COLOR CHANGING LED ARCH LIGHTING WIRING DETAIL QUICK START GUIDE
Syncing/Pairing the Receiver(s) to the Remote
To pair, turn on both the receiver and remote. The receivers are located in the forward facing junction box on
each vac stanchion. Press the “ID learning button” on the T3-CC receiver then press and hold any key (except
On/Off) on the remote. The receiver will beep and the remote indicator light will ash green 3 times upon a
successful pairing. To control multiple receivers simultaneously, follow the steps above for each receiver.
• Sync and control all of your arch
lights together
• Select between unique static colors
via a full color wheel or 32 built-in
color changing models
• Easily adjust both speed and
brightness settings
• Create custom, unique color
changing programs
Rev Date 21 0512
www.ggled.net
The T3X Wireless Remote Control offers intelligent, user friendly control of your color changing arch lighting
system. This remote allows you to:
1. Operation Panel and Component Instruction:
T3X
LED RGB Programmable Controller
On/Off
Scene-mode Keys
Touch Full-color Circle
Sync Status
Indicator Light
DIY Key for Color Selection
Switch Key for
Changing Modes
Speed Keys
Mode Keys Brightness Keys
T3X can realize the signal sync on unlimited receivers within effective
distance, a very good solution for the LED project needs sync control
wirelessly.
Can RF remote the functions of switch, pause, mode, speed and LED
brightness. More proudly, the T3X has the brand-new programmable
function, only 10 seconds to DIY a new change effect.
★Buzzer on/off: Press “Scene-mode Key” for 3 seconds.
●
●Additional Functions:
Long press for 2 seconds to enter DIY programming function.
5. Save the new program into the “Scene-mode keys”.
4. Adjust the brightness and the speed by pressing the “SPEED” and “ BRT”.
3. After color selection, press to switch jumping/smooth/flickering changing effect.
2. Press to enter next color. (can save 1-10 colors)
1. Select any color on , the controller will save immediately.
Press “MODE” key under DIY function, can display the standard color for black,
red, green, blue, yellow, purple, cyan and white. Among them, black can be used
for editing fade in dimming effect, etc.
Long press ”DIY key for color selection” to clear the current color.
▲
▲
DIY Key for Color Selection
(Press"PLAY" to play cycle modes.
merely play the dynamic effect,
the static effect will be skipped)
(Press 3 seconds to save)
LED RGB Programmable Controller
Programming has never been so easy.
— 26 —
T3X remote works with T3-CV, T3-CC, T3-5A receiver.
Wiring the LED Fixture to the Receiver
See the below diagram and corresponding table to wire the LED Fixture to the T3-CC Receiver.
Leader Cable
to LED Fixture
Black
White
Green
Red
Leader Cable T3-CC Receiver
Black
White
Green
Red
V+
B
G
R
