Security advice/ maintenance
• Place the solar panel in direct sunlight for maximum efficiency.
• Clean the solar panel from time to time to ensure proper power output.
• Keep all Fosera products in a safe place and make sure the panel is installed securely, so it can not fall down.
• Protect the battery box, the appliances and the PAYG remote from rain and direct sunlight. Indoor use only.
• Keep the battery box and the appliances clean.
• The ideal temperature for the functional capability of all fosera products is between 0°Celsius and
50°Celsius.
Do`s:
• Do not expose the system to any liquids or rain.
• Do not open or repair any component of the solar system by yourself.
• This should be only done by an authorized technician. Otherwise the warranty will be void.
• If the cables are damaged, make sure that they are repaired or replaced.
• Do not use loads and appliances that are not designed or certified for the system by Fosera (except for
the USB port).
• Only use the provided panels to charge the battery. Other panels or chargers will harm the system and
therefore result in a loss of warranty.
• The system components, including the solar panel, are not fire resistant.
• Keep away from fire.
• The battery contains a high amount of electrical energy. It is important that all short circuits are prevented.
Dont`s:
Installation
• Avoid any shading of the panel.
• The angle should be at least 15 degrees
to ensure that the rain can wash dirt from
the panel.
• Make sure that the solar panel is securely moun-
ted to withstand heavy winds and storms.
• Clean the panel regularly.
Mount the Fosera EVO on the wall with the screws and wall plugs provided. Alternatively it is possible to
place the Fosera EVO on the floor. Indoor use only!
Set the Fosera EVO to installation mode: Turn the until menu installation mode is shown. Push the
to activate the options. Then turn the until the display shows 'Load off'. Press the or the
to quit the menu.
Connect the solar panel to the screw clamp labeled with panel. As soon as the Fosera EVO is connected
to the solar panel, press the . The display will indicate, that the systems battery is charging and is
well connected to the solar module.
Connect the cable of the Fosera appliances up to 3 A to the blue sockets of the Fosera EVO and higher
load appliances to the screw clamp outputs.
Place the solar panel in direction of the sun for maximum performance.
1
2
3
4
If using, connect the lead-acid battery to the screw clamp labelled with PB. Make sure to connect first
only the wires 1and 2to the Fosera EVO system, and once you have tightened the screw on the
Fosera EVO system, connect the wires 3and 4to the lead-acid battery, this step is very important
to avoid a short circuit for the lead-acid battery while connecting it to the system.
Make sure to connect only small loads on Fosera EVO Fosera jacks (3A) and bigger loads to EX1
or EX 2 (10A).The biggest load connect to “Load” clamp (15A).
5
Battery
+
-
GND
PB +
smart SHS
EX 1
EX 2
Panel 2
Load
Panel 1
GND
GND
GND
GND
GND
GND
PB +
12
3 4
Place the appliances at your desired location and use the hook screw, which is included in your Fosera
EVO package. Make sure the cable is not pulled too tightly. If you need to extend the cable please use a
cable provided by Fosera.
6
Switch off the installation mode.
7
Contact
Headquarters
Fosera GmbH & Co. KGaA
Beim Muehlbach 3
89171 Illerkirchberg
Germany
Tel: +49 7346 92469 73
Fax: +49 7346 92469 75
Visit our website: www.fosera.com
Local retailer
