Forging Mount HY4111 User manual
Instruction Manual
Universal TV Stand
®
Thank you for choosing our product! We strive to provide the best quality
and services for our customers. Would you kindly share your experience
on Amazon if you are satisfied? If you have any questions, please feel
free contact us.
Email：[email protected]
We’re ready to help!
HY4111
•Carefully open the carton, remove contents and lay out on cardbard or other protective
surface to avoid damage.
•Check to assure that all components were received undamaged. Do not use damaged or
defective parts.lf you require replacement parts, contact customer service at
•Carefully read all instructions before attempting installation.
UNPACKING INSTRUCTIONS
IMPORTANT SAFETY INFORMATION
•Install and operate this product with care. Please read this instruction before beginning the
installation, and carefully follow all instructions contained herein. Use proper tools during
installation.
•
If you do not understand the instructions or have any concerns or questions, please contact
customer service at
WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment!
over resulting in death or serious injury!
This product contains small items that could be a choking hazard if swallowed.
Keep these items away from yong children
:
It is the installer’s responsibility to make sure the combined weight of HY4111 and the display
does not exceed 88 ibs(40kg).Use with heavier televisions may result in instability causing tip
Supplied Parts List
10x60mm
Concrete Anchor
M (x1)
ST 1/4”* 60mm
Lag Bolt
L (x1)
Lag Bolt Washer
K (x1)
Tempered Glass
(x1)
M8x15 Bolt
I (x4)
B (x8)
Rubber Pad
(x4)
M6x10 Bolt
(x4)
Secuity Wire
N (x1)
Support Pillar
(x1)
M4x30 Bolt
F (x4)
M4 Washer
C (x4)
Allen Key
(x1)
Metal Washer
(x4)
M6x15 Bolt
G (x4)
M8x45 Bolt
J (x4)
M6 Washer
D (x4)
TV Plate
(x1)
M8x25 Bolt
(x3)
Plastic Cover
(x1)
M6x35 Bolt
H (x4)
M8 Washer
E (x4)
A (x8)
Monitor Bracket
(x2)
Wire Clip
(x2)
Gasket
(x1)
1
(01)
SRQ
P
(04)
(03)(02)
W
V
U
T
Safety lock
￠8.5x18x 5 mm Spacer ￠8.5x18x 10 mm Spacer
O (X2)
2
Connecting the TV Plate to Support Pillar
Step 2
If you find the support column (04) is not in the correct direction, please see figure
below. Loosen M8x25 screws(T), adjust the support to the correct direction then
tighten screws again.
3 positions
Put 03 (Tempered Glass) on the table. Put Q(Gasket) and T
(M8x25 Bolt) under 03. Turn Y (Plastic Cover) and 04(Support
Pillar) upside down under 03 to install and then tighten screws.
Step 1 Connecting the Support Pillar(04) to Tempered Glass(03)
Place foot pads(V) on the bottom
of the tempered glass base(03)
at the four corners
Support Pillar(04)
Plastic Cover(P)
M8x25 Bolt(T)
Gasket(Q)
Allen Key (W)
1.2
Rubber pad
Tempered Glass
V
03
Q
03
1.3
TV Plate (01）
Allen Key (W)
M6x10 Bolt (R)
Metal Washer (S)
Wire Clip (U)
2.1 2.2
Height
Adjustable
Inserting wire clips(U)
TV Plate can be installed on wall alternatively,
wall mounting hardware not included
3
Please select the proper screw length for your
TV by hand tightening to check your flat panel
thread depth.
When attaching brackets to the flat screen,
Too Short Too Long
Correct Correct
First, make sure the diameter of the bolt(F-J) fits your TV. Then, please see the diagram above.
You will need to thread the bolt into the TV using the correct washer (C,D,E) and spacer (A or B) if
necessary with a screwdriver(Not included). Please make sure the monitor brackets(02) are
vertically centered and level with each other.
C D E
Step 3 Mounting the Monitor Brackets(02) to your TV
be careful not to over tighten screws
and be sure that screws do not bottom
out in the mounting holes
3.1
A B F H J
C D E G I
02
3.2
4
Attaching TV to TV Plate and Managing the WiresStep 4
4.1
1
2
Safety lock(O)
CAUTION: Avoid potential personal injury or property damage!
Make sure your locking screws are tightened BEHIND the mounting plate
so the TV is securely fastened in place.
screwdriver
(Not included)
Height adjustable vertical bracket
first choice
second choice
If you find your TV set is too close to the base, please take off the TV from the stand.
Then, change to the second choice to allow more space between TV and
the tempered glass base (03).
First choice Second choice
cable management
4.2
5
5.1 5.2
5.3 5.4
2.75in(70mm)
0.15in(4mm)
Wall
Attaching the Security Steel Wire to the TV
Step 5
If your TV is located nearby the wall as the 5.1, then a steel wire can be attached for additional security.
Using screw (F to J) through washer (C to E), the end of security wire(N), bracket hole and TV VESA hole in
sequence. By tightening the screw, the security wire(N) is attached to the TV.
Diagram 5.3, 5.4 and 5.5.
Wood Stud Wall Concrete & Brick Wall
LKLK
M
Secuity Wire (N)
2.2in(60mm)
2.75in(70mm)
0.375in(10mm)
F to J
C to E
Security wire(N)
Secuity Wire (N)
according to your wall type shown in
Drill 2.75”(70mm) deep holes using a 5/32”
(or 4mm) drill bit . Secure with screws and washers.
Drill 2.75”(70mm) deep holes using a 3/8” (or 10mm)
drill bit, and press anchors into holes. Secure with
screws and washers.
6
5.5
Now your TV is standing steadfastly and securely！
Step 5
Thank you for choosing our products.
Now enjoy your TV with FORGING MOUNT TV stand!
FORGING MOUNT Make Your Life Better
Table of contents
Other Forging Mount Rack & Stand manuals
Forging Mount
Forging Mount HY9403-B User manual
Forging Mount
Forging Mount HY4104 User manual
Forging Mount
Forging Mount HY9389-B-UK User manual
Forging Mount
Forging Mount HY9441-B User manual
Forging Mount
Forging Mount FM4503 User manual
Forging Mount
Forging Mount FM4545 User manual
Forging Mount
Forging Mount HY4105 User manual
Forging Mount
Forging Mount FM4501 User manual
Popular Rack & Stand manuals by other brands
Salamander
Salamander Acadia AC/W/L400/WH Assembly instructions
Fohhn
Fohhn VAT-09 Mounting instruction
ricoo
ricoo FS0522 quick start guide
AMSOIL
AMSOIL BMK-22 Installation and service instructions
Kargo Master
Kargo Master 48220 installation guide
Milestone AV Technologies
Milestone AV Technologies SIMPLICITY SLF2 installation instructions
