Follett Ice Pro EDB1000 Manual
Installation and Service Manual
Serial numbers E00006 and above
Ice Pro™EDB1000 230V, 50 Hz Automatic
Ice Bagging and Dispensing System
00127357R05
801 Church Lane • Easton, PA 18040, USA
Toll free (877) 612-5086 • +1 (610) 252-7301
www.follettice.com
Order parts online
www.follettice.com
Manual de Instalación y Servicio del Dispensador y Embolsador Automático de Hielo Ice Pro
Manuel d'Installation et de Dépannage du Distributeur et Ensacheur Automatique de Glace Ice Pro
Ice Pro Automatisches Eisabfüll- und -ausgabesystem – Installations- und Wartungshandbuch
2
3
Table of contents
Operation and cleaning instructions can be found in manual 00127886.
Las instrucciones de uso y limpieza se encuentran en el Manual 00127886.
Les instructions d'exploitation et de nettoyage sont disponibles dans le manuel 00127886.
Bedienungs- und Reinigungsanweisungen entnehmen Sie bitte dem Handbuch 00127886.
Welcome to Follett Corporation
Specications
Installation
Service
Bienvenido a Follett Corporation
Especicaciones
Instalación
Servicio
Bienvenue à Follett Corporation
Caractéristiques techniques
Installation
Dépannage
Willkommen bei der Follett Corporation
Spezikationen
Installation
Wartung
Replacement parts
Piezas de repuesto
Pièces de rechange
Ersatzteile
5
6
8
15
17
18
20
27
29
30
32
39
41
42
44
51
52
52
52
52
4
Storage area of dispenser contains mechanical, moving parts. Keep hands and arms clear of this area at all times.
If access to this area is required, power to unit must be disconnected rst.
Access to service areas is restricted to persons having knowledge and practical experience of the appliance, in
particular as far as safety and hygiene are concerned.
Ice is slippery. Maintain counters and oors around dispenser in a clean and ice-free condition.
Ice is food. Follow recommended cleaning instructions to maintain cleanliness of delivered ice.
Should local codes require a hard-wired connection and/or shielded wiring, eliminate the cord(s) and plug(s) and
follow the appropriate wiring diagram.
Dispenser can accommodate most cube/cubelet ices up to 1” square or Chewblet®ice (made by Horizon ice
machines). Use of these ices can jam dispenser and void warranty. For questions about ice compatibility, call
customer service at (610) 252-7301.
Always disconnect power before cleaning or servicing the dispenser.
Failure to remove all sanitizer may result in health hazard.
Important Cautions
Welcome to Follett
Follett ice dispensers enjoy a well-deserved reputation for excellent performance, long-term reliability and outstanding
after-the-sale support. To ensure that this dispenser delivers that same degree of service, we ask that you take a moment
to review this manual before beginning the installation of the dispenser. Should you have any questions or require
technical help at any point, please call technical service at (610) 252-7301.
Before you begin
After uncrating and removing all packing material, inspect the equipment for concealed shipping damage. If damage
is found, notify the shipper immediately and contact Follett Corporation so that we can help in the ling of a claim, if
necessary.
5
6
Specications
Electrical
Each icemaker and dispenser requires separate circuit. Equipment
ground required.
Standard electrical – 230V, 50 Hz, 1 phase, Max. fuse – 5 amps,
15 amp circuit. Cord provided.
Plumbing
Drain 1" PVC FPT for hopper drain
Note: Drains should be hard piped and insulated. Maintain
at least 1cm per 31cm (1/4" per foot) run slope on
drain line run.
Temperature
Ambient temperature range: 10˚C (50˚F) minimum; 38˚C (100˚F)
maximum.
Clearance, installation and access information
The dispenser must be level in both directions. The dispenser is to
be installed in a location where use and maintenance is restricted to
trained personnel. The supply cord plug must be accessible.
Door entry Installation sites must have an unobstructed path to
installation location with door openings no less than
870mm (34.25").
Service clearance A minimum of 305mm (12") to left of unit is
necessary for service.
Ice type
Dispenser can accommodate most cube/cubelet ices up to 26mm
(1") square. Crushed, ake, or nugget ice cannot be used. Use of
these ices can jam dispenser and void warranty. For questions about
ice compatibility, call technical service at (610) 252-7301.
Icemaker weight limit
Icemaker(s) mounted on thin top may not exceed 272kg (600 lbs).
Icemaker(s) mounted on thick top may not exceed 590kg (1300 lbs).
Container sizes
Standard unit accommodates bag sizes up to 9kg (20 lbs)/
696mm (27.35").
Standard dispense chute compatible with carts and containers up to
750mm (29.5") high.
Optional 166mm (6.5") leg extension kit may be purchased to allow
for up to 915mm (36") high carts and bags up to 18kg (40 lbs) and
860mm (33.85") high.
Bag pins
Bag pins may be adjusted to accommodate bag hole centers from
127mm (5") to 254mm (10").
7
* Special top required for icemakers weighing more than 272kg
(600 lbs). Add an additional 54mm (2.125") to height. Contact
factory.
** Add 51mm (2") to depth and 4.5kg (10 lbs) to shipping weight
when drain pan accessory is used.
Dimensions and clearances
572mm (22.5")
26mm (1") FPT drain
*1823mm
(71.75")
1188mm
(46.75")
864mm
(34")
788mm
(31")
max. cart
695mm
(27.35")
max. bag
242mm
(9.5")
26mm (1")
FPT
drain
3121mm
(52.0")
**1156mm
(45.5")
305mm (12")
Service
Clearance
572mm (22.5")
26mm (1") FPT drain
*1823mm
(71.75")
1188mm
(46.75")
864mm
(34")
788mm
(31")
max. cart
695mm
(27.35")
max. bag
242mm
(9.5")
26mm (1")
FPT
drain
3121mm
(52.0")
**1156mm
(45.5")
305mm (12")
Service
Clearance
Fig. 1
Fig. 2
8
Installation
Door Entry
Some disassembly may be necessary to gain access through door
openings with a width of 850mm (34.25") to 1156mm (45.5").
Note: Disassembly is NOT necessary for gaining entry through
door openings larger than 1156mm (45.5'')
1. Remove lower splash panel with four screws (Fig. 3.1).
1
Fig. 3
1
2
Fig. 5
2. Detach the following plugs from the left side of control box:
Window interlock J26 (Fig. 4.1)
Control J21 (Fig. 4.2)
PCB power J22 (Fig. 4.3)
Auger motor J24 (Fig. 4.4)
3. Remove control panel cover by lifting and detaching hook
and loop tape (Fig. 5.1).
4. Remove lower cover with two thumbscrews, one from each
side (Fig. 5.2).
3 – PCB power J22
Agitation motor J23
4 – Auger motor J24
2 – Control J21
1 – Window interlock J26
Footswitch J27
Input power
Fig. 4
1
2
3
4
Fig. 6
5. Remove transfer case with two latches (Fig. 6.1).
6. Remove ice deection plate by lifting up (Fig. 6.2).
7. Remove auger by lifting up (Fig. 6.3).
8. Remove auger tube by lifting up. Note position of locating
slot on lower end for reinstallation (Fig. 6.4).
9. Remove blower duct by loosening thumb screw, rotating
clip (Fig. 7.1) and lifting up (Fig. 7.2).
1
2
Fig. 7
10. Remove control box/fan motor mounting assembly with
two screws (Fig. 8).
Fig. 8
10
11. Remove auger motor bracket with 8 screws (Fig. 9).
12. Remove bag pin bracket with two thumbscrews (Fig. 9).
Fig. 9
13. The units width may be further reduced by removing the
upper ice storage section (Fig. 10). This reduces unit width
by 45mm (1.75") to an overall width of 864mm (34").
a) Remove window.
b) Pull window interlock switch cable through wire trough in
upper right corner of base (Fig. 10.1).
c) Cut tie wrap.
d) Release latch from each side of ice storage section
(Fig. 10.2).
e) Lift upper ice storage section from base.
Note: Reinstallation of auger tube requires locating slot be in
the 7 o’clock position and upper end of auger be ush to
auger motor bracket.
1
2
Fig. 10
Table of contents
Languages:
Other Follett Ice Maker manuals
Follett
Follett 7UC100A User manual
Follett
Follett Horizon Elite HC-1810R/N Operation manual
Follett
Follett HCD1000R User manual
Follett
Follett Ice Pro EDB1000-SA Series User manual
Follett
Follett Horizon HCD1000RVS User manual
Follett
Follett HCC1010A Operation manual
Follett
Follett 230V 50Hz Supplement
Follett
Follett HCD710ABS User manual
Follett
Follett HCC1400A Operation manual
Follett
Follett ER400A Manual
Follett
Follett HMD700R Operation manual
Follett
Follett Horizon Elite Chewblet 1010 Series User manual
Follett
Follett HCC700A Operation manual
Follett
Follett Horizon Elite H D710ABT Series User manual
Follett
Follett Horizon HCC1000AJS User manual
Follett
Follett HCC1000A Operation manual
Follett
Follett Horizon Elite HMF1810RJS User manual
Follett
Follett Horizon HCC1000WHT User manual
Follett
Follett HCE Operation manual
Follett
Follett T400A Setup guide
