WARRANTY / DISCLAIMER:
Abuse of Camera IS NOT covered under warranty. Fire Cam warrants its products
against defects in material or workmanship for 12 months from date of purchase unless
otherwise specified. The Fire Cam HD WIFI Dash Cameras one year warranty is
limited to the replacement or repair of the defective item at no charge if we determine
the item to be defective. This warranty shall not apply to any item subject to misuse
including such as failure by buyer to follow instructions, product modification, ordinary
wear and tear, negligent or improper operation. Abuse of camera IS NOT covered
under the warranty. Fire Cam products are not recommended for concrete training
towers or flashover chambers where it could sustain high temps for long periods of
time. Electronic damage due to over-voltage, incorrect polarity from product power
supplies, or incorrect MAINS voltage is not covered under the warranty. DO NOT USE
ANY AFTERMARKET CHARGERS FOR YOUR CAMERAS. Fire Cam chargers are
designed specifically for Fire Cam’s only. Modification, repair, or attempted repair by
anyone other than Fire Cam or without the written permission of Fire Cam will void this
warranty. This warranty covers the cost of factory repair, labor and parts on eligible
equipment which is returned. Equipment, which is repaired under this warranty will be
returned freight prepaid. If it is determined that the Fire Cam does not need repair, the
purchaser shall pay for return shipping charges. Disclaimer: Fire Cam does not
assume any responsibility for any accidents or injuries incurred to the user of the Fire
Cam HD WIFI Dash Camera.
WARNING!
Firefighting is a dangerous activity and should only be performed by a trained
professional. The end user of Fire Cam products assumes all responsibility connected
with the use of this product including but not limited to continuing education, and
activity that conforms to local Standard Operating Procedures. Neither the
manufacturer nor any distributor assumes any liability for injuries sustained while using
Fire Cam products. The Fire Cam® Fire Helmet CamerasTM are manufactured of
anodized aluminum, and may retain heat for several minutes after being exposed to a
heated environment such as a structure re or training re so it needs to be handled with
care. The end user is responsible for installation consistent with the mounting
instructions, as well as regular safety inspections of the BlackJack Holder and Fire
Cam Fire Helmet Cameras. For further questions, please go to www.FireCam.com
under the "contact us" page.
