Fanimation CCK8002 User manual

CCK8002

Close-To-Ceiling Kit

INSTRUCTION SHEET

USE THESE INSTRUCTION IN CONJUNCTION WITH YOUR FANIMATION

FAN OWNERS MANUAL AND IN PLACE OF THE STEPS FOR HOW TO

HANG YOUR CEILING FAN. IF YOU NO LONGER HAVE YOUR MANUAL,

ONE CAN BE DOWNLOADED AT WWW.FANIMATION.COM.

After removing your kit from the packaging, use slight1.

pressure to push down and remove the screw trim

cover ring from the ceiling canopy assembly. (Figure 1)

Figure 1

SCREW TRIM

COVER RING

CEILING CANOPY

Figure 2

REMOVE

SCREW

LOOSEN SCREWS (2)

BUT DO NOT REMOVE

SLOTTED

REMOVE

SCREW

Separate the ceiling bracket from the ceiling canopy2.

by loosening the two canopy-to-bracket screws where

the canopy is slotted and completely remove the other

two screws where it is not slotted and set aside for

later. (Figure 2)

Twist the ceiling bracket counter-clockwise and lift out3.

of the ceiling canopy. There is another short canopy

option when it is needed to very close to ceiling.

(Figure 3)

Figure 3

CEILING CANOPY

Short Canopy

CEILING BRACKET

Safety Instructions

To avoid possible shock, be sure electricity is turned off at the fuse box before wiring, and do not operate fan without blades.1.

All wiring and installation procedures must satisfy National Electrical Codes (ANSI/ NFPA 70-1999) and Local Codes. The ceiling fan must2.

be grounded as a precaution against possible electrical shock. Electrical installation should be made or approved by a licensed electrician.

The fan base must be securely mounted and capable of reliably supporting at least 50 lbs. Consult a qualified electrician if in doubt.3.

The fan must be mounted with the fan blades at least 7 feet from the floor to prevent accidental contact with the fan blades.4.

Follow the recommended instructions for the proper method of wiring your ceiling fan. If you do not have adequate electrical knowledge or5.

experience, have your fan installed by licensed electrician.

6˝ downrod 4.5˝ downrod Tall close-to-ceiling kit Short close-to-ceiling kit

Remove the three motor coupling screws from5.

your fan and save for next step. (Figure 5)

METAL SPACER

Route your fan wires through the ceiling canopy and6.

place ceiling canopy onto your motor. (Figure 6)

SCREW TRIM

COVER RING

CEILING

CANOPY

MOTOR

NOTE: MOTOR WIRES

HAVE BEEN OMITTED

FROM DIAGRAM

NOTE: MOTOR WIRES

HAVE BEEN OMITTED

FROM DIAGRAM

SCREW TRIM

COVER RING

CEILING

CANOPY

NOTE: MOTOR WIRES

HAVE BEEN OMITTED

FROM DIAGRAM

MOTOR

DOWNROD

SUPPORT

Alight the 3 big slots in the canopy to the 3 screws in7.

the motor coupler. Firmly attach the canopy cover to

the motor with the three screws removed in step 5

and steel washers from the part bag. (Figure 7)

WARNING

To avoid possible ﬁre or shock, be sure electricity is

turned off at the main fuse box before hanging.

(Figure 8)

Figure 8

MAIN FUSE

BOX

Figure 5

Figure 6

Figure 7

On your fan’s motor, remove the two downrod support4.

set screws and nuts from the downrod support and

discard. (Figure 4)

Figure 4

NOTE: MOTOR WIRES

HAVE BEEN OMITTED

FROM DIAGRAM

DOWNROD SUPPORT

9. Loop the safety cable through pin hole in motor coupler

and put the cable clamp in the end of safety cable.

(Figure 10).

10. Loop the safety cable end through one of the holes in

the hanger plate up into the outlet box, then back out

the center of the plate, then connect the end with the

screw down clamp. Tighten the set screw in the clamp

. (Figure 11).

Figure 12

HOOK

OUTLET

BOX

MOUNTING

BRACKET

Figure 11

Lift your fan motor assembly and hang it from the11.

ceiling bracket hook through one of the two screw

holes in the canopy lip. Do not use the grooved slots.

(Figure 12)

Connect your fan’s wiring according to your fan’s owners12.

manual. If you have misplaced your owners manual

one can be downloaded at www.fanimation.com or

contact a licensed electrician to complete the wiring

of your fan.

Figure 10

CABLE CLAMP

Using the two screws and washers, securely attach8.

the ceiling bracket to the ceiling junction box, making

sure to run the supply wires through the hole in the

center of the bracket. (Figure 9)

Figure 9

MOUNTING

BRACKET

NOTE: SUPPLY WIRES

HAVE BEEN OMITTED

FROM DIAGRAM

OUTLET

BOX

WASHER

SCREW

Figure 14

Figure 15

DIMPLED

GROOVE

MOUNTING

TAB (4)

SCREW TRIM

COVER RING

Install the remaining two screws14. removed in step 2

to secure the ceiling canopy to the ceiling bracket.

(Figure14)

Push the screw cover trim ring up to conceal the15.

screws, such that the mounting tabs seat into the

dimpled grooves in the ceiling canopy midway between

the screws. (Figure 15)

.etelpmocsitikgniliec-ot-esolcruoyfonoitallatsnI16.

Reference your owners manual for any additional

assembly steps required for your Fanimation ceiling

fan.

10983 Bennett Parkway

Zionsville, IN 46077

Toll Free (888) 567-2055

FAX (866) 482-5215

Outside U.S. call (317) 733-4113

Visit Our Website @ www.fanimation.com

NOTE: MOTOR WIRES

HAVE BEEN OMITTED

FROM DIAGRAM

Figure 13

MOUNTING

BRACKET

SCREW

SLOT

Lift the fan off the bracket hook and mount your fan by13.

sliding the ceiling canopy over the mounting bracket

with the two loosened screws going into the slots in

the canopy. Be sure all wiring is tucked into the ceiling

canopy and is not pinched. Once the canopy is flush

with your ceiling, turn clockwise to seat the screws

into the keyed portion of the slot. Tighten the screws.

(Figure 13)

Table of contents

Other Fanimation Fan manuals

Fanimation

Fanimation Air Shadow FP815FS User manual

Fanimation

Fanimation Islander User manual

Fanimation

Fanimation Treventi FP2500 Series User manual

Fanimation

Fanimation FP10 / 20 Fan Series User manual

Fanimation

Fanimation AIREDROP LP7653 Series User manual

Fanimation

Fanimation Bourbon Street FP510 Series User manual

Fanimation

Fanimation AIRE DECOR BP210B 1 Series User manual

Fanimation

Fanimation Draco FP3220CH User manual

Fanimation

Fanimation FP8032DZ User manual

Fanimation

Fanimation SPITFIRE User manual

Fanimation

Fanimation The Sandella MAD3260 User manual

Fanimation

Fanimation The Wylde FP D6220 Series User manual

Fanimation

Fanimation Involution FP4520 Series User manual

Fanimation

Fanimation PALMA FP6258BNMW User manual

Fanimation

Fanimation ISLANDER FP320 1 Series User manual

Fanimation

Fanimation The Levon FP7910 series User manual

Fanimation

Fanimation FP8050 The Quattro User manual

Fanimation

Fanimation The Celano FP5420PW User manual

Fanimation

Fanimation PC/DC FPD7619 Series User manual

Fanimation

Fanimation BREWMASTER FP1280-220 User manual

Fanimation

Fanimation EDGEWOOD FP9060 Series User manual

Fanimation

Fanimation Old Havana FPH61RS User manual

Fanimation

Fanimation The Zonix FP4640 User manual

Fanimation

Fanimation The Zonix FP4640OB User manual

Popular Fan manuals by other brands

ELTA FANS

ELTA FANS H03VV-F installation guide

Hunter

Hunter 20714 Owner's guide and installation manual

Emerson

Emerson CARRERA VERANDA CF542ORB00 owner's manual

Hunter

Hunter Caraway Owner's guide and installation manual

Panasonic

Panasonic FV-15NLFS1 Service manual

Kompernass

Kompernass KH 1150 operating instructions

VES

VES FALA100/12V/TR Original instructions

Vertiv

Vertiv Liebert DCD user manual

Westinghouse

Westinghouse GFP Series owner's manual

Venmar

Venmar KUBIX HRV PLUS Series user guide

Maico

Maico ECR 31 installation instructions

Sonnenkonig

Sonnenkonig Dinky instruction manual

S&P

S&P ECOWATT HXBR manual

Wider

Wider IMP03369BH instruction manual

Panasonic

Panasonic F-60DHN Operating and installation instructions

Hinkley

Hinkley HIGHLAND instruction manual

Broan

Broan 766BN installation guide

Premium

Premium PFS16022 Use manual