3
ATTENTION:
• Do not connect any external power supplies until you have read the Attention notications in the Power Supply
section of the user guide for that device.
• Ne branchez pas de sources d’alimentation externes avant d’avoir lu les mises en garde dans la section
«PowerSupply» du guide utilisateur pour cet appareil.
7Connect the StudioStation100 LAN port to the IPL T PC1 LAN port (see figure 1 on page 1) using the included NETXC
M-M 6 foot (1.8 meter) RJ-45 network crossover cable to enable the IPL T PC1 to power on and off the connected recording
equipment such as the camera, studio lights, and microphone, when a USB drive is inserted into the RCP101 EU USB port.
• If the crossover cable is used, no further conguration is required.
• If a straight-through cable is used and the StudioStation and PC1 are connected through a network, follow these
conguration steps:
a. Congure the IP address of the IPL T PC1 via the embedded web page.
• If you do not know the IP address, use the IP Link Device Manger to discover it.
• The default IP address of the IPL is 192.168.254.254.
b. Assign an Admin password to the IPL T PC1 (optional).
c. From the StudioStation100 Web UI, on the StudioStation page, enter the IP address and the Admin password
(if required) of the IPL T PC1 and test the connection (see gure 4).
• In order to enter the Web UI of the StudioStation 100, you need the IP address of the StudioStation 100.
• The default IP address of the StudioStation 100 is 192.168.254.253
Figure 4. Test Connection on the StudioStation Page
8Connect the IEC power cable from the lights into the IEC Power outlet of the IPL T PC1 to automatically power the lights on
and off when a USB drive is inserted into the USB port on the RCP101 EU.
9Connect an optional HDMI display into the HDMI output to preview the recording.
¢Connect the provided IEC cables:
a. Into the IPLTPC1 and a power source.
b. Into the StudioStation100 and a power source.
c. Verify the front panel buttons and LCDs illuminate.
£Insert a USB drive into the USB port on the RCP101 EU.
a. The StudioStation100 detects the USB drive inserted into the RCP101 EU and sends a command to the IPLTPC1 to
turn on the power outlet.
NOTE: By default, the StudioStation100 records to the RCP101 EU USB drive.
b. The IPL T PC1 powers ON the attached recording devices.
NOTE: When the USB drive is removed from the RCP101 EU, the Studio Station 100 sends a command to turn OFF the
IPLTPC1 power output. All attached recording devices are powered OFF.
¤Configure the StudioStation 100 (optional). Configuration is only available when connected through a network.
a. Congure the metadata on the Metadata page (see gure 5) in the StudioStation100 Web UI.
Figure 5. Configure Metadata on the Encoding & Metadata Page
