Exsys EX-48052 User manual

Congratulation on your purchasing this high performance Mini PCI

Express (Mini PCIe) RS422/4 5 serial card. The card is high speed PCI

Express bus based and plug-and-play compliant. Both its enhanced

serial ports (256-byte deep FIFO) are jumper-configurable for RS422,

4-wire RS4 5 and 2-wire RS4 5 modes.

Features:





Full x1 Mini PCI Express Throughput, 250Mbytes/sec





Fully Compliant with PCI Express Base Specifications, Revision 1.1





Supports RS4 5 Auto Transceiver Turn Around by Unique Featured

ATTA

Hardware

Supports 2 DB9-male Connectors over Flat Cables

Support 4-wire RS422/4 5 and 2-wire RS4 5 Modes

Supports RS422/4 5 Speed up to 921.6Kpbs

9-bit Data Framing, as well as 5,6,7 and bits

Supports Win2000, XP, 2003, 200 , Vista, Win 7 and Linux

EX-48052

2S RS422/485 Mini PCIe Card

1. Introduction

2. oard Layout

J3: S2, 2’nd

RS422/485 port

J2: S1, 1’st

RS422/485 port

JP1: S1 mode

settings

Mini PCIe

golden

fingers

Pin #1

Pin #1 JP2: S2 mode

settings

J5: factory use

only, do not

install any jumper

JP3: S1

Terminator

Enable/Disable

JP4: S2

Terminator

Enable/Disable

2S RS422/4 5 Mini PCIe Card

There are 2 sets of the jumpers to set the settings for port 1 (S1) and port

2 (S2) respectively.

Mode Selection Jumper: JP1 for S1, JP2 for S2

Termination Resistor Enable/Disable Jumper: JP3 for S1, JP4 for S2

1. Mode Settings:

JP1 (for S1)

JP2 (for S2)

Description

RS485 2-wire mode

(Default)

RS485 4-wire mode

RS422 mode

2. Termination Resistor Enable/Disable: This jumper

enables/disables the 120 Ohm termination resistor between

DATA+ and DATA- of the RS4 5 transceiver:

JP3 (for S1)

JP4(for S2)

Description

Termination Resistor Disabled

(Default)

ON OFF

3. Jumper Settings

485-2W

485-4W

422

485-2W

485-4W

422

485-2W

485-4W

422

2S RS422/4 5 Mini PCIe Card

Termination Resistor Enabled

1. Remove the Mini PCIe card from its protective antistatic

packaging, remove the screw holding the Mini PCIe card to the

motherboard and insert the new Mini PCIe card into the socket.

2. Put the Mini PCIe card onto the motherboard and attach it with

the screw.

3. Install the serial flat cables. Please mind the pin 1 position to

match with the cable’s red color wire.

4. Installing the Mini PCIe Card

Mini PCIe Socket

Holding screw

ON OFF

2S RS422/4 5 Mini PCIe Card

To install the Windows drivers, there are two methods, one is to run the

setup utility (StnSetup.exe) in each corresponding folder. The other one

is by the Windows’ driver installation Wizard. We recommend you run

the setup utility. It will be simpler. However, PLEASE REFRESH HARDWARE

OR RE OOT THE SYSTEM IN CASE YOUR DRIVER DID NOT TAKE EFFECT

AFTER RUNNING THE SETUP UTILITY.

The drivers are shipped in the following folders on the driver CD:

E:\IO\MOSCHIP\MCS99xx

Drivers are in each

corresponding folder

5. Software Installation

Red wire indicates pin 1

Driver Uninstalling Program

Driver Installing Program

2S RS422/4 5 Mini PCIe Card

In some cases, you may want to uninstall the drivers. To remove the

drivers that already installed for Windows, there are two methods:

1. Run (double click) the uninstall program (for example

MOSCHIP_StnUninst.exe) in each Windows’ folder on the

supplied driver CD, it is usually in the same folder as the

StnSetup.exe utility:

2. Go to Windows’ Control Panel’s Add/Remove Program to

remove the drivers.

D 9-Male Pin Assignment:

RS422 Cable Wiring:

Uninstalling the Software Drivers

7. RS422/485 Pin Assignments and Cable Wiring

DB9 (RS422, PCIe Card)

1 TXD-

2 TXD+

3 RXD+

4 RXD-

5 GND

(RS422 Device)

1 TXD-

2 TXD+

3 RXD+

4 RXD-

5 GND

NC = No connection

9 Pins Signal

1 TXD- (DATA-)

2 TXD+ (DATA+)

3 RXD+

4 RXD-

5 GND

6 NC

7 NC

8 NC

9 NC

2S RS422/4 5 Mini PCIe Card

RS485 (2-wire) Cable Wiring:

Power requirements: 5V DC, 450mA (max)

Operating temp.: 0 to 55

C (32 to 131

)

Operating humidity: 5 to 95% RH

. Environmental Specifications

DB9 (485, PCIe Card)

1 DATA-

2 DATA+

3 NC

4 NC

5 GND

(RS485 Device)

1 DATA-

2 DATA+

3 NC

4 NC

5 GND

Table of contents

Popular PCI Card manuals by other brands

ERMA

ERMA SSI 1417 instruction manual

SIIG

SIIG CyberSerial Dual PCI Software installation

Moxa Technologies

Moxa Technologies CP-102E Quick installation guide

I-Bus

I-Bus IBC2602 user guide

Chelsio Communications

Chelsio Communications T5 Series Installation and user guide

Conrad Electronic

Conrad Electronic 97 46 71 operating instructions

Micro Innovations

Micro Innovations USB650A Quick installation guide

KTI Networks

KTI Networks KF-310 user guide

Asus

Asus SpaceLink WL230 user manual

SIIG

SIIG SC2475 Quick installation guide

TRENDnet

TRENDnet TEW-703PI Quick installation guide

Belkin

Belkin F5D7000F user manual

Pericom

Pericom PI7C7100 manual

ADLINK Technology

ADLINK Technology cPCI-3548 user manual

Digium

Digium TE200 Series user manual

Allo.com

Allo.com 2nd Gen E1/T1/J1 Quick installation guide

Western Digital

Western Digital FireWire PCI Adapter installation guide

Pyle

Pyle Gamelink PLINK1 user guide