eufy Security eufyCam S330 User manual
5100500XXXX V01
S330 eufyCam
QUICK START GUID
E
Anker Innovations Limited. All rights reserved. eufy Security and eufy Security Logo
are trademarks of Anker Innovations Limited, registered in the United States and
other countries. All other trademarks are the property of their respective owners.
EN 01
①
②
③
④
⑩
⑪
⑤
⑥
⑦
⑧
⑨
⑫
AT A GLANCE
S330 eufyCam
Model: T8160
①Spotlight ⑤Solar Panel ⑨Speaker
②Camera Lens ⑥LED Indicator ⑩SYNC Button
③Photosensitive Sensor ⑦Microphone 2 ⑪Mounting Hole
④Microphone 1 ⑧Motion Sensor ⑫USB-C Charging Port
English 01
Deutsch 13
Español 25
Français 37
Italiano 49
Nederlands 61
Portuguese 73
85
02 EN EN 03
CHARGING S330 EUFYCAM
5V USB Charger
USB Port 1
LED Indicator Description
Steady Blue Charging
OFF Fully Charged
Charging Time 8 Hours
Option 1
Option 2
ADDING S330 EUFYCAM
On eufy Security app, follow the onscreen instructions to add your eufy Security
devices. Choose Add Device, then select S330 eufyCam to add it to your system.
04 EN EN 05
2 HOURS PER DAY*
* Make sure the solar panel can be fully exposed to direct sunlight for at
least 2 hours per day.
S330 eufyCam includes a solar panel that converts
sunlight into electrical energy and keeps the built-in
battery charged every day.
The charging efficiency fluctuates according to the intensity of the sunlight.
Don't worry when the battery level goes down. It happens when there isn't enough
sunlight or the camera is consuming more power than usual.
You don't need to charge the camera with a cable
until a low battery alarm goes off.
06 EN EN 07
Best places to install:
- Wall without eaves
- A pole or fence where
sunlight is not blocked
- Over eaves, if the eaves
are below 3 m high
Places not to install:
- Inside your home or
under the porch
- Under or on a tree
- Under slanted eaves
MOUNTING THE CAMERA
Select a Location
Select a location where you can get the desired view. We recommend hanging the
camera 7-10 ft (2-3 m) above the ground.
Motion
Detection
Zone
Camera
Field-of-View
Up to 26 ft (8 m)
7-10 ft
(2 - 3 m)
Motion
Detection
Zone
08 EN EN 09
Mount the Camera
1. Turn the knob of the mounting bracket counterclockwise to loosen and
disassemble it.
2. Drill holes with a 15/64 inch (6 mm) drill bit, then insert the anchors into the
holes; anchors are necessary for walls that are made out of hard materials such
as concrete, brick, or stucco.
3. Firmly screw the knob of the mounting bracket into the mounting hole.
4. Hold and screw the camera to the mounting bracket. Rotate the camera to
adjust the view and check it using the live stream, which you can access in the
eufy Security app.
For troubleshooting, check Help on the eufy Security app. Refer to the app page
for LED indicator status.
10 EN EN 11
SAFETY
• Do not use the device in the environment at a too high or too low temperature,
never expose the device to strong sunshine or too wet environment.
• The suitable temperature for T8160 and accessories is -20°C to 50°C (Charging
temperature is 0°C to 45°C) .
• It is recommended to supply the device in an environment with a temperature
that ranges from 5°C~25°C.
• When supplying, please place the device in an environment that has a normal
room temperature and good ventilation.
Warning:
• Replacement of a battery with an incorrect type can defeat a safeguard;
• Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting
of a battery can result in an explosion;
• Leaving a battery in an extremely high temperature surrounding environment
can result in an explosion or the leakage of flammable liquid or gas; and
• A battery subjected to extremely low air pressure may result in an explosion or
the leakage of flammable liquid or gas.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
NOTICE
NOTICE (Europe and United Kingdom)
This product complies with the radio interference requirements of the
European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in compliance with
the essential requirements and other relevant provisions of Directive 2014/53/EU.
For the declaration of conformity, visit the website: https://uk.eufylife.com.
This product complies with the radio interference requirements of the
United Kingdom
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in compliance
with Radio Equipment Regulations 2017(SI 2017/1206). The full text of the UK
declaration of conformity is available at the following internet address:
https://uk.eufylife.com.
RF exposure information:
The Maximum Permissible Exposure (MPE) level has been calculated based on
a distance of d=20 cm between the device and the human body. To maintain
compliance with RF exposure requirement, use products that maintain a 20cm
distance between the device and human body.
Frequency bands and power as below:
Function Bandes Operation Frequency Max.Power
Wi-Fi for T8160 2.4GHz 2412-2472MHz EIRP 19.86 dBm
The following importer is the responsible party (contract for EU matters):
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807 Munich,
Germany
The following importer is the responsible party (contract for UK matters):
Anker Technology (UK) Limited I GNR8, 49 Clarendon Road, Watford,
Hertfordshire, WD17 1HP, United Kingdom
DE 13
12 EN
Your product is designed and manufactured with high quality materials and
components, which can be recycled and reused.
This symbol means the product must not be discarded as household
waste, and should be delivered to an appropriate collection facility for
recycling. Proper disposal and recycling helps protect natural resources,
human health and the environment. For more information on disposal and
recycling of this product, contact your local municipality, disposal service, or
the shop where you bought this product.
①
②
③
④
⑩
⑪
⑤
⑥
⑦
⑧
⑨
⑫
AUF EINEN BLICK
S330 eufyCam
Modell: T8160
①Scheinwerfer ⑤Solarmodul ⑨Lautsprecher
②Kameraobjektiv ⑥LED-Anzeige ⑩SYNC-Taste
③Lichtempfindlicher Sensor ⑦Mikrofon2 ⑪Befestigungslöcher
④Mikrofon1 ⑧Bewegungssensor ⑫USB-C-Ladeanschluss
14 DE DE 15
AUFLADEN DER S330
EUFYCAM
5V USB Charger
USB Port 1
LED-Anzeige Beschreibung
Dauerhaft blau Ladevorgang
Aus Vollständig aufgeladen
Ladedauer 8Stunden
Option 1
Option 2
ADDING S330 EUFYCAM
Befolgen Sie in der eufy Security-App die Anweisungen auf dem Display, um Ihre
eufy Security-Geräte hinzuzufügen. Wählen Sie Gerät hinzufügen und dann S330
eufyCam, um das Gerät zu Ihrem System hinzuzufügen.
16 DE DE 17
2 HOURS PER DAY*
*Stellen Sie sicher, dass das Solarmodul mindestens 2Stunden pro Tag
vollständig dem direkten Sonnenlicht ausgesetzt werden kann.
S330 eufyCam enthält ein Solarmodul, das Sonnenlicht in
elektrische Energie umwandelt und dafür sorgt, dass der
integrierte Akku jeden Tag aufgeladen wird.
Die Ladeleistung schwankt je nach Intensität der Sonneneinstrahlung.
Machen Sie sich keine Sorgen, wenn der Akkustand nachlässt. Das passiert, wenn
nicht genügend Sonnenlicht vorhanden ist oder die Kamera mehr Strom als üblich
verbraucht.
Sie müssen die Kamera erst dann mit einem Kabel aufladen, wenn der Alarm bei
niedrigem Batteriestand ertönt.
Other manuals for eufyCam S330
1
Table of contents
Languages:
Other eufy Security Security Sensor manuals
eufy Security
eufy Security S300 User manual
eufy Security
eufy Security T8450 User manual
eufy Security
eufy Security HomeBase 2 User manual
eufy Security
eufy Security T8900 User manual
eufy Security
eufy Security T8910 User manual
eufy Security
eufy Security Smart Buoy User manual
eufy Security
eufy Security T8920 User manual
