Epson PowerLite 85 System manual

INSTALLATION HANDBOOK

Remote Control Information

Epson PowerLite 85/825/826W

Using the Remote Control

Follow these tips for using the remote control:

Point the remote control at the front of the projector or at the

screen.

Stand within 20 feet of the projector.

Avoid using the remote under bright uorescent lamps or in

direct sunlight, or the projector may not respond properly.

Replacing the Batteries

Replace the batteries as described below:

1. Turn the remote control over.

2. Press the tab on the battery cover

to open it.

3. Install two AA batteries,

inserting the +and –ends

as shown.

4. Close the cover, pressing it down

until it snaps into place.

note

If a button is pressed longer

than 30 seconds, the remote

control stops operating to

conservepower. When you

release thebutton, normal

operation resumes.

caution

When replacing batteries,

take the following

precautions:

Replace the batteries as

soon as they run out. If the

batteries leak, wipe away

battery uid with a soft

cloth. If uid gets on your

hands, wash immediately.

Do not expose batteries to

heat or ame.

Disposeof used batteries

according to local

regulations.

Remove the batteries if

you won’t be using the

projector for a long period of

time.

INSTALLATION HANDBOOK

Remote Control Information

Epson PowerLite 85/825/826W

Controlling the Picture and Sound

You can use the remote control to preview and select your picture

sources, temporarily turn o the picture and sound, freeze the action,

zoom in on the picture, and adjust the volume.

Switching Between Picture Sources

If your projector is connected to more than one computer and/or

video source, you can switch between the dierent sources:

The easiest way to select your source is to press the Searchbutton

on the remote control (or the Source Searchbutton on the

projector) repeatedly until you see the image you want on the

screen.

On the remote control, there are four Source buttons. Use them

to switch between equipment connected to the port identied on

each button, or to project through a network.

After you select a source, the screen goes dark for a moment before the

image appears.

INSTALLATION HANDBOOK

Remote Control Information

Epson PowerLite 85/825/826W

Turning Off the Picture and Sound

You can use the A/V Mute button on the remote control to turn o

the image and sound. This does the same thing as the A/V Mute slide

(shown on page 18) and is useful if you want to temporarily redirect

your audience’s attention.

To turn o the picture and sound, press the A/V Mutebutton.

The screen turns black.

To turn the image and sound back on, press the button again.

You can have the screen turn blue when you press the A/V Mute

button. You can also have an image, such as a company logo, display

on the screen (see page 98).

Stopping Action

You can use the remote control to stop the action in your video or

computer image.

To stop the action and keep the current image on the screen, press

the

Freeze button. The sound continues.

To restart it, press the Freeze button again.

note

This function pauses the

image, but not thesound.

Also, because the source

continues to transmit

signals, you won’t resume

the action from the point

you stopped it.

INSTALLATION HANDBOOK

Remote Control Information

Epson PowerLite 85/825/826W

Zooming Part of Your Image

You can zoom in on a portion of the image using the E-Zoombuttons

on the remote control.

1. Press the E-Zoom button on the remote control.

You see a crosshair indicating the center ofthezoom-in area.

2. Use the pointer buttons to position the crosshair.

3. Continue pressing the E-Zoom button to enlarge the selected

area up to 4× magnication.

4. While the image is enlarged, you can:

Use the pointer buttons to move around the screen.

Press the E-Zoom button to zoom out.

5. When done, press the ESC button to return the image to its

original size.

Controlling the Volume

To change the volume, press the or button on the remote

control or projector.

You can also adjust the volume using the projector’s menu system. See

page 94.

note

To temporarily shut o the

sound and picture, press the

A/V Mute button or close

the A/V Mute slide.

INSTALLATION HANDBOOK

Remote Control Information

Epson PowerLite 85/825/826W

Adjusting the Aspect Ratio

You can use the Aspectbutton on the remote control to adjust how

an image ts into the display area. Each time you press the button, the

projector changes to the next setting.

When Connected to Video Equipment

If you’re projecting from video equipment such as a DVD player, set

the projector’s Aspect setting to match that of the player. For

example, if the video player is set to output images at a 16:9 aspect

ratio, set the projector’s Aspectsetting to16:9 so they match. If the

player outputs images at a 4:3 aspect ratio, select 4:3 (PowerLite

85/825)or Normal(PowerLite 85/826W).

PowerLite 85/825

4:3 setting 16:9 setting

PowerLite 826W

Normal setting 16:9 setting

INSTALLATION HANDBOOK

Remote Control Information

Epson PowerLite 85/825/826W

Note that the projector’s native aspect ratio is narrower than 16:9.

Therefore, widescreen movies and HDTV broadcasts will display with

black bars at the top and bottom when 16:9 is selected as the Aspect

setting. For the PowerLite 826W, you can select Full to stretch the

image vertically to ll the whole projection area.

When Connected to a Computer

For computer images, Normal is usually the best setting to select.

This displays the image at the largest possible size without stretching

it. For computers with wide-panel WXGA displays, the PowerLite

826W displays the image at WXGA resolution, making full use of the

display area; likewise, the PowerLite 85/825 displays XGA images to

their best advantage.

Depending on your computer display and projector model, you may

see black bars at the edges. In that case, try selecting 16:9. The

PowerLite 826W also lets you select:

Full to stretch the image to ll the whole projection area

Zoom to t the image in one dimension only, with the other

dimension cut o

Throughto display the image without stretching or scaling it

If the resolution of the image is the same as the projector’s, changing

the

Aspectsetting has no eect. Also, if you’re projecting through

your computer’s USB port, you can’t change the projector’s aspect

ratio; instead, change your computer’s resolution to match that of the

projector.

note

If part of the image remains

cut o, check theprojector’s

Resolution setting (see

page 92). Select Normalor

Wide, depending on the size

of your computer’s display

panel.

INSTALLATION HANDBOOK

Remote Control Information

Epson PowerLite 85/825/826W

Adjusting the Color Mode

You can use the Color Modebutton on the remote control to adjust

the color, brightness, and other aspects of your image. This lets you

quickly adjust the image for various uses.

Press the button repeatedly to select from the following settings:

Dynamic:For increased brightness and contrast when playing video

games or watching TV in a bright room. If you notice video delays

during high-speed gaming, turn o the Progressivesetting (see

page 92).

Presentation: For computer presentations in a bright room with

color graphics.

Whiteboard: For computer presentations in a bright room with

black-and-white text and graphics.

Theatre: For watching movies in a dark room.

Photo: For vivid, high-contrast still images in a bright room.

Sports: For vivid TV images projected in a bright room (video,

S-video, or composite video only).

sRGB: For matching the color palette of standard sRGB computer

displays

Blackboard: For projecting accurate colors on a green chalkboard

(adjusts the white point).

INSTALLATION HANDBOOK

Remote Control Information

Epson PowerLite 85/825/826W

Operating Your Computer with the

Remote Control

If you connect a computer to the projector with a USB cable, as

described on page 42, then select Wireless Mouse for the USB

Type B setting in the Extended menu (see page 101), you can use the

remote control in place of your computer’s mouse. This gives you

more exibility when delivering slideshow-style presentations, since

you won’t have to standnext to the computer to change slides.

Use thePage Up andDown buttons to move through a

slideshow.

Use the pointer buttons to move the cursor on the screen.

Press the Enter button once to left-click, or press it twice to

double-click. Press the Escbutton to right-click.

To drag-and-drop, hold down the Enter button. Then use the

pointer buttons to drag the object. When it’s where you want

it, press Enter to release it.

Page up or down

to change slides

in PowerPoint

Right-click

Left-click

Move cursor

INSTALLATION HANDBOOK

Remote Control Information

Epson PowerLite 85/825/826W

Highlighting Your Presentation

You can display a pointer to call out important information on the

screen. If you want to customize the pointer tool, you can choose from

three alternative shapes.

Using the Pointer Tool

1. To activate the pointer tool, press the Pointer button on the

remote control. A pointer appears on the screen.

If you prefer to use a dierent style of pointer, see the instructions

in the next section.

2. Use the pointer buttons on the remote control to position

the pointer on the screen.

3. When you’re doneusing the pointer, pressthe Pointer or Esc

button to clear the screen.

Customizing the Pointer Tool

You can change the appearance of the pointer by choosing from three

alternative shapes.

1. Press the Menubutton on the remote control, highlight the

Settings menu, highlight Pointer Shape, and press Enter. You

can select one of the pointer shapes shown at the left.

2. Select the shape you want and press Enter.

3. Highlight Returnand press Enter.

4. Press Menu to exit from the menu system.

Pointer

Other manuals for PowerLite 85

This manual suits for next models

Table of contents

Other Epson Projector manuals

Epson

Epson Elp-3500 User manual

Epson

Epson PowerLite 7300 User manual

Epson

Epson BrightLink 695Wi+ User manual

Epson

Epson EH-LS500W User manual

Epson

Epson EMP-811 User manual

Epson

Epson VS410 User manual

Epson

Epson PowerLite Pro Z8150NL User manual

Epson

Epson PowerLite 750c Specification sheet

Epson

Epson PowerLite 95 User manual

Epson

Epson 826W - PowerLite WXGA LCD Projector Dimensions

Epson

Epson PowerLite 850p User manual

Epson

Epson EB-W10 User manual

Epson

Epson VS220 Reference guide

Epson

Epson CO-W01 User manual

Epson

Epson PowerLite Home Cinema 5010 Manual

Epson

Epson EMP-51 User manual

Epson

Epson 6110i - PowerLite XGA LCD Projector Reference guide

Epson

Epson POWERLITE 83V+ User manual

Epson

Epson EMP-713 User manual

Epson

Epson EB-Z8050W User manual

Epson

Epson 1700C - PowerLite XGA LCD Projector User manual

Epson

Epson PowerLite Pro Z8000WUNL User manual

Epson

Epson PowerLite 260D User manual

Epson

Epson VS400 Specification sheet

Popular Projector manuals by other brands

iEmmet

iEmmet MP-312 user manual

Sony

Sony VPL-HS10 Marketing Specifications & Features manual

Sony

Sony VPL-HW65ES Quick reference manual

Toshiba

Toshiba TLP-791U Specifications

Philips

Philips LC1341 Declaration of conformity

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB operating instructions

NEC

NEC NP600S EDU Specifications

BenQ

BenQ SH753P user manual

Eiki

Eiki EK-623U series quick start guide

Christie

Christie LHD700 user manual

Navitar

Navitar FX instruction manual

InFocus

InFocus LitePro 560 user guide

Sony

Sony SRX-R815P operating instructions

Vivitar

Vivitar DP1500 X specification

Acer

Acer C20 Series manual

Asus

Asus ZenBeam Latte user manual

BOXLIGHT

BOXLIGHT CP-322i/CP-634i user manual

JVC

JVC 1108TTH-AO-AO instructions