Eneo H.264 Video Compression User manual
INSTRUCTION MANUAL
(HDR-4082AH1.0_User Guide_V1.0)
H.264 Video Compression
Digital Video Recorder
2
Safety Precautions
Explanation of Graphical Symbols
WARNING
To reduce a risk of fire or electric shock, do not expose this product to rain or moisture.
CAUTION
Changes or modifications not expressly approved by the manufacturer may void the user’s authority to
operate this equipment.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer.
Discard used batteries according to the manufacturer’s instructions.
This symbol indicates the presence of important operating and
maintenance (servicing) instructions in the literature accompanying the
product.
This symbol indicates the presence of uninsulated ”dangerous voltage”
within the product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
3
These precautions must be followed for safety reasons.
Warning
Do not use if the unit emits smoke, strange sounds are heard or odor is emitted.
- Continued use may cause electrocution and/or fire. Immediately remove the power plug from
the outlet. Once the unit stops emitting smoke, consult the dealership where this unit was
purchased or factory shop for repairs.
- Do not attempt repairs on your own.
Make sure the power cable is not damaged.
- Always use the power cable supplied with the unit.
- Do not place heavy objects on the power cable or place the power cable near heating
equipment. Also, do not bend the power cable forcefully, work upon or staple it. A damaged
power cable may result in fire and/or electrocution.
- Should the power cable become damaged it must be replaced by the dealership where this unit
was purchased or factory shop.
Make sure there is no dust accumulation on the power plug or the outlet.
- Dust accumulation may result in a short-circuit and heat generation and cause fire.
- Be especially careful when using an outlet situated in a room exposed to high humidity,
condensation and/or dust, or in a kitchen.
- Periodically remove the power plug from the outlet and clean any dust and dirt between the plug
and the outlet.
Caution when connecting the power cable
- Connect the power plug directly with the outlet. Faulty connection may result in heat generation
and cause fire.
- Do not use the power cable while it is tied in a bundle. This may result in heat generation and
cause fire.
- When using the extension cord supplied, make sure the power consumption of the connected
unit does not exceed the electrical rating of the extension cord. Higher power consumption may
result in heat generation and cause fire.
Disassembly prohibited
- Do not place your hand inside this unit as this may cause fire and/or electrocution.
- Consult the dealership where this unit was purchased or factory shop for diagnostics,
adjustments, and repairs.
Do not place any foreign objects inside the unit.
- Do not insert or push in any metal or combustible object through openings such as air ducts.
This may cause fire and/or electrocution.
- In the event that a foreign object is inside the unit, turn off and unplug the unit. Consult the
dealership where this unit was purchased or factory shop. Continued use may result in fire
4
and/or electrocution.
Do not place a container holding water or other liquids above the unit when it is connected to
power.
- In the event that water gets inside the unit, turn off and unplug the unit. Consult the dealership
where this unit was purchased or factory shop. Continued use may result in a fire or
electrocution.
Do not allow the unit to get wet.
- This unit is not waterproof. Do not expose the unit to water. This may cause fire and/or
electrocution. Do not use in a bath or shower room.
- In the event that the internal components have been exposed to water, turn the power off and
remove the power plug from the outlet. Consult the dealership where this unit was purchased or
factory shop. Continued use may cause electrocution and/or fire.
Do not use during thunder/thunder storms.
- Do not use during thunder/thunder storms. Never touch the connection cable during
thunder/thunder storms. This may cause electrocution.
Do not place in an unstable position.
- Doing so may cause accidents and/or breakdowns through falling or toppling.
- In the event that the unit has been dropped or the casing has been damaged, turn the power off
and remove the power plug from the outlet. Consult the dealership where this unit was
purchased or factory shop. Continued use may cause electrocution and fire.
Do not expose to shock or vibration.
- Stored data may be damaged or lost through hard-disk breakdowns caused by shock/vibration.
Do not use this unit in areas where it is exposed to the possibility of explosion.
- Do not use this unit in areas where explosive and/or flammable gases are present. This may
cause fire and/or explosion.
For pluggable equipment, the socket-outlet shell be installed near the equipment and shall be
easily accessible.
Caution
Do not pull on the power cable when removing the power plug from the outlet.
- Hold the power plug when disconnecting the power cable from the outlet. Pulling on the power
cable from the outlet. Pulling on the power cable may damage the cord. This may cause fire
and/or electrocution.
Do not touch the power plug with wet hands.
- Doing so may result in electrocution.
Do not sit on.
- Doing so may cause the unit to fall, be damaged and/or result in injury.
5
Make sure the cables are connected properly.
- Connect and install the power cable and connection cable very carefully. Tripping over the cable
may result in the unit capsizing or falling and cause injury.
Do not place heavy objects on connected units.
- Doing so may affect the stability of the unit and cause it to fall which may result in injury. Doing
so may also damage the unit depending on the weight of the object.
Shipment and portability
- Never move this unit while the power is turned on.
- When shipping, remove the power plug from the outlet, confirm that the connection cable has
been removed, and store in original packaging. Ship using a method that causes the least
amount of shock and/or damage to this unit. Also, do not drop this unit.
Maintenance when the unit is going to remain unused for long periods of time
- Remove the power plug from the outlet when the unit is going to remain unused for long periods
of time.
Cleaning the internal components
- Consult the dealership where this unit was purchased or factory shop for cleaning internal
components. Leaving the unit unused for long periods of time may attract duct to the internal
components, which in turn may cause fire and/or breakdowns.
Do not block the cooling fans or air ducts.
- This unit it equipped with air ducts and cooling fans in order to assist the ventilation of hot air
produced by the hard disk drive. Placing covers, placing in a case, or placing inside bookcases
may cause heat build up, and may result in fire and/or electrocution.
- When the unit is set up in a rack, leave open space on all sides.
. Leave 5 cm or more of space above and below.
. Leave 10 cm or more of space on both sides and on the rear.
Do not expose to extreme temperatures or humidity changes.
- Do not place in areas where the unit will be exposed to extreme temperatures (±10 degrees C
per hour) or humidity changes.
Points on unit positioning
- This unit is constructed using precision electronic parts. Avoid placing it in areas described
below as this may cause faulty operation and/or breakdowns.
. In direct sunlight
. In places exposed to water
. In the vicinity of cooling and heating units or humidifiers
. Near the air conditioner where the unit is exposed to cool air
. Dusty areas
. Areas that contain fire hazards
. In the vicinity of volatile substances
. Areas where the unit will be exposed to constant vibration (in trains, cars, etc.)
Cautionary points on condensation
- Droplets may form on the outside when very cold water is poured into a cup. In the same way,
6
droplets may form around the internal components of his unit. This is called condensation.
- Do not use this unit if condensation has formed. Using this unit while condensation is formed
may cause breakdowns. In the event of sudden sharp temperature changes, turn off the power
and do not use this unit until the temperature of the room where it is positioned stabilizes (about
2 hours). Condensation will not occur while the power is turned on.
- When condensation is likely to occur… Use the unit after turning the power off and leaving it for
1~2 hours.
Back up battery
- This unit has got a built-in lithium battery used to back up the clock function. The battery
continues to operate the clock even when there is a power disruption.
- The life expectancy of the battery is approximately 2 years. If the battery runs out or leaks, the
clock resets when the power is turned off.
- Battery fluid leaks
. In the event that the battery fluid has leaked rinse hands/clothes thoroughly with water.
. Loss of eyesight may result if battery fluid enters the eyes. Do not rub the eyes. Immediately
rinse with clean water and consult a physician.
- When disposing of this unit
. Consult the dealership where this unit was purchased for information concerning the disposal
of the lithium battery.
Warning
Installation and servicing should be performed only by qualified and experienced personnel.
Turn off the power of the DVR when connecting cameras, audio or sensor cables.
The manufacturer is not responsible for any damage caused by improper use of the product or failure to
follow instructions for the product.
The manufacturer is not responsible for any problems caused by or resulting from the user physically
opening the DVR for examination or attempting to fix the unit. The manufacturer may not be held liable for
any issues with the unit if the warranty seal is removed.
Warranty for Critical Parts
HDD, Battery and ATX Power: 2 years (25℃environment)
Cooling Fan: 3 years (25℃environment)
7
Product Components
The package contains the main unit and its components as specified below. When you purchase the unit,
Please check to ensure the components specified below are included.
DVR Set
Client Software CD, User Guide
/
Remote Control , Battery1.5V, Mouse / /
DVD-RW data cable
(Refer to below table)
HDD data and power cable
(Refer to below table)
HDD mounting bracket & Screw
(Refer to below table)
HDD bracket fixing screw
Rack Mount (2EA)
Power Cable (110V or 220V)
Items
Quantity
HDD SATA Data Cable 4 EA
HDD Mounting Bracket 2 EA
HDD Mounting Bracket Screw 6 EA
Rack Mount Bracket 2 EA
Basic function of the OUSE
①:
Left button: SELECT function
②:
Wheel: MOVEMENT function on a drop-down menu
8
ounting the HARD DISK
1. Remo e the unit’s co er. 2. Fix the supplied rubber pads to the
supplied HDD mounting bracket.
Then fix the hard disk to the
mounting bracket using the supplied
screws (A).
3. Connect the unit’s power cable (B) and the supplied S-ATA cable (C) to the hard
disk. Then fix the hard disk to the unit using the supplied HDD fixing screws (D).
9
Compatible HDD Models
Seagate ST32000542AS (Barracuda LP) 2 TB 5900 RPM 32 MB
Seagate ST3 000340SV (Surveillance) TB 7200 RPM 32 MB
Seagate ST3 00528AS (Barracuda) TB 7200 RPM 32 MB
Seagate ST3500830SCE 500 GB 7200 RPM 8 MB
Seagate ST35004 8AS (Barracuda) 500 GB 7200 RPM 6 MB
Seagate ST35004 0AS (Barracuda) 500 GB 7200 RPM 6 MB
Seagate ST32504 0AS (Barracuda) 250 GB 7200 RPM 6 MB
Seagate ST32503 0SV (Surveillance) 250 GB 7200 RPM 8 MB
Seagate ST32503 8AS (Barracuda) 250 GB 7200 RPM 8 MB
Seagate ST3 608 5AS (Barracuda) 60 GB 7200 RPM 8 MB
HITACHI HDS722020ALA330 2 TB 7200 RPM 32 MB
HITACHI HDS72 0 0KLA330 TB 7200 RPM 32 MB
HITACHI HDT72 0 0SLA360 TB 7200 RPM 6 MB
HITACHI HDS72 0 0CLA332 TB 7200 RPM 32 MB
HITACHI HDS72 050CLA362 500 GB 7200 RPM 6 MB
HITACHI HDP725050GLA360 500 GB 7200 RPM 6 MB
HITACHI HDS72 032CLA362 320 GB 7200 RPM 6 MB
HITACHI HDS72 025CLA382 250 GB 7200 RPM 8 MB
HITACHI HDT72 025SLA380 250 GB 7200 RPM 8 MB
HITACHI HDP725025GLA380 250 GB 7200 RPM 8 MB
Western Digital WD20EADS 2 TB 7200 RPM 32 MB
Western Digital WD 0EACS TB 7200 RPM 6 MB
Western Digital WD5000AACS 500 GB 7200 RPM 6 MB
Western Digital WD2500AAKS 250 GB 7200 RPM 6 MB
NOTICE
The brands and models of all HDD should be the same. If the brands and models of the HDD are different, the DVR
may not recognize HDD or malfunction
10
Booting the DVR and Basi Time Setting
. During the first start up, the following message will be displayed.
2.
Setting Daylight Saving Time
If the DVR is to be set Day Light Saving Time and be synchronized NTP (Network Time Protocol), Take next steps.
. Enter the SETUP mode. The default Password is “ ”.
Table of contents
Other Eneo DVR manuals
Eneo
Eneo DLR1.1-04N/250V User manual
Eneo
Eneo MER-34R160300A User manual
Eneo
Eneo DLR3-08N/160CD User manual
Eneo
Eneo Almira R-01 User manual
Eneo
Eneo HDR-4004AM User manual
Eneo
Eneo MSR-24N040004A User manual
Eneo
Eneo TVR-2008AM1.0 User manual
Eneo
Eneo IER-38R320005A User manual
Eneo
Eneo MER-28N040000A User manual
Eneo
Eneo DLR-1004/500V User manual
Eneo
Eneo MSR-24N040004A User manual
Eneo
Eneo DPR-2016/500D User manual
Eneo
Eneo DTR-6108/xxxD User manual
Eneo
Eneo IER-25R040004A User manual
Eneo
Eneo HDR-4008AE3.0 User manual
Eneo
Eneo MSR-24N080004A User manual
Eneo
Eneo DTR-6008/250CD User manual
Eneo
Eneo TER-12N040200A User manual
Eneo
Eneo INR-18N040005A User manual
Eneo
Eneo DIR-4108H Series User manual
