9 First time Printing Instruction
1. Log in to the official website to download
(www.creality.com) or find the Creality
software in the memory card and install it.
Creality Slicer
2.
Select Preferences in sequence → Configure Creality
→ Next → Select corresponding language → Next →
Finish to complete the setting.
3. Select Printer (Ender-3 S1 Plus) 4. Enter the corresponding parameters → Close
5. Open Creality
Slicer 6. Load File
7. Select File
Creality Slicer
Load
Replacing the filament:
1. When the printer is not printing:
A. Heat the nozzle to over 185℃, and wait until the filaments
inside the nozzle are softened. Press the extrusion handle, push
the filaments downwards to see if there is any filament coming
out of nozzle, and then quickly pull out the filaments to prevent
them from being stuck in the throat pipe.
B. Place the new filament onto the rack and repeat the steps in
Section 8: Loading the Filament.
2. When the printer is printing:
A. Pause the printing. After the printer stops, press and
hold the extrusion handle and quickly extract the filament
to prevent it from clogging in the heat break.
B. Place the new filament onto the rack and press it through
the filament detector. Press and hold the extrusion handle to
insert the filament into the nozzle. Then push the filament to
squeeze out the residual filament in the nozzle and clean up
the nozzle before resuming printing.
Plus
300
300
300
