2 Description
Ventilation Unit WL800 • Version: 28.04.2016 • Errors and technical modifications subject to change without notice.
1. Description
The Ventilation Unit WL800 is installed in the ridge area of conservatories replacing
the normal glazing. The WL800 discharges air into the outer atmosphere (exhaust
mode) or circulates the air inside (circulation mode).
The WL800 communicates via radio with the building control systems WS1 and (KNX)
WS1000 Color or Style. Using an integrated temperature sensor inside the ventilation
unit, the building control systems can utilize the circulation mode to gain heat or to re-
duce water condensation.
With the ventilation modules RF-WL, the Ventilation Unit WL800 can be automati-
cally controlled in different levels. In addition to that, the WL800 can be manually and
directly controlled via the radio remote control Remo 8, the pushbutton interface RF-
B2-UP or via the solar radio pushbuttons Corlo P RF.
Functions:
•Exhaust mode and Circulation mode
•EveryWL800 requires an air intake opening of not less than 18,360 mm²
(Comfort: 38,400 mm²)
•Air circulation to gain heat (Automatic function of control units WS1/
WS1000): Warm air from the ridge area is distributed throughout the whole
room by the ventilation unit
•Air circulation to reduce condensation water (Automatic function of
control units WS1/WS1000): Using a special calculating process, the control
units recognize critical conditions of temperature and dew point and start the
ventilation unit, usually even before any moisture starts settling.
•Wireless activation. Radio connection is automatically established after
switching on of the mains voltage
• Smoothly running radial fans
• Continuously variable
•Highlyinsulated and thermally decoupled housing (no cold bridges)
•Extremelytight-closing flap with self-locking drive and load limit switch
•Pressure-resistant mounting panel
• Installation along with self-cleaning panes possible, due to silicon-free
processing
• Power and radio electronics arranged inside, but outside of the air flow.
Maintenance possible entirely from inside
• Automatic control and manual operation possible with the following control
systems:
WS1 Color, WS1 Style, WS1000 Color, WS1000 Style, KNX WS1000 Color,
KNX WS1000 Style (all from software version 1.811)
• Automatic control possible with the following ventilation modules:
RF-WL, RF-WL 0-10 V
• Manual operation possible with the following radio transmitters:
Remo 8 (from version 1.1), RF-B2-UP, Corlo P1 RF, Corlo P2 RF
