Elmo MX-1 User manual
MX-1 New Baseplate Installation Guide
1
WARNING: Before you begin installing the new MX-1 baseplate, make sure that your MX-1 unit is not
plugged into anything else, including the optional ELMO Connect Box.
Fold up the MX-1 unit and flip it over so that
the baseplate is facing upwards and the
serial numbers are visible.
Using a screwdriver, carefully remove the 2
screws from the bottom of the baseplate.
The baseplate is magnetized and will not
come off until manually removed.
Take off the baseplate and screws. Do not
throw away your baseplate –you may
need the serial number for later reference.
Place the new MX-1 baseplate on the
bottom of the unit, making sure that it is
properly aligned with the unit.
Replace the 2 screws and screw them back
into the bottom of the new baseplate to
finish installation.
1
2
3
4
5
Bottom of baseplate
Bottom of baseplate
Top of folded MX-1
Bottom of MX-1
with new baseplate
MX-1 New Baseplate Installation Guide
2
To use the MX-1 Writing Board, slide the
baseplate of the MX-1 unit into one of the
two slots located on the bottom of the
Writing Board. This will keep the camera in
place as you write
The MX-1 Writing Board is now ready to be
used! Simply connect the MX-1 to the input
source of your choice.
When you are finished using the MX-1 and
Writing Board, the MX-1 unit can be folded
shut while it is still attached to the Writing
Board.
6
7
8
Other manuals for MX-1
2
Table of contents
Other Elmo Document Camera manuals
Elmo
Elmo Document Camera User manual
Elmo
Elmo Visual Presenter HV-110u User manual
Elmo
Elmo MA-1 User manual
Elmo
Elmo Visual Presenter HV-7100SX User manual
Elmo
Elmo L-12i User manual
Elmo
Elmo TT-02U User manual
Elmo
Elmo TT-02 User manual
Elmo
Elmo Visual Presenter EV-200 User manual
Elmo
Elmo TT-02RX User manual
Elmo
Elmo HV 5100 XG User manual
