After finishing installing, the sensor could be connected the power and testing it.
STEP 1
STEP 2
STEP 3
CONNECTION SKETCH FIGURE:
(As per right drawing)
TEST:
Turn the TIME knob anti-clockwise on the minimum,
turn the LUX knob clockwise on the maximum
(sun).
Turn on the power, the sensor will be electrify and
warm-up, 30 sec later, the item will be entered into
working estate.
5~10 seconds after the light goes out for the first time and then sensing, the load should be
worked.
Turn LUX knob anti-clockwise on the minimum (moon). The inductor load should not work
after load stop working. If you cover the detection window with the opaque objects (towel
etc), the load work .under no induction signal condition, the load should stop working within
5-15sec.
Note: when testing in daylight, please turn LUX knob to (SUN) position, otherwise
the sensor lamp could not work!
NOTE:
Should be installed by electrician or experienced man.
Avoid installing it on the unrest objects.
There shouldn’t be hindrance and moving object in front of the detection window effecting
detection.
Avoid installing it near air temperature alteration zones such as air condition, central heating,
etc.
Considering your safety, please don’t open the cover when you find the hitch after
installation.
SOME PROBLEM AND SOLVED WAY:
The load don’t work:
a. Please check the power and load connect is correct.
b. Check if the load is good.
c. Check if the working light corresponds to the ambient light.
The sensitivity is poor:
a. Please check if there is hinder in front of the detection window to effect receiving
the signals.
b. Please check if the ambient temperature is too high.
c. Please check if the signals source is in the detection fields.
d. Please check if the installation height corresponds to the height showed in the
instruction.
The sensor can’t shut the load automatically:
a. Check if there are continual signals in the detection fields.
b. Check if the time delay is set to the longest.
c. Check if the power corresponds to the instruction.
d. Check if the temperature change obviously nears the sensor, such as air condition
or central heating etc.
